Chapter 3. Noise Husheng Li The University of Tennessee.

Slides:



Advertisements
Similar presentations
Physical Layer: Signals, Capacity, and Coding
Advertisements

1. INTRODUCTION In order to transmit digital information over * bandpass channels, we have to transfer the information to a carrier wave of.appropriate.
1 Transmission Fundamentals Chapter 2 (Stallings Book)
Department of Electronics and CommunicationsEngineeringYANSAHAN UNIVERSITY Department of Electronics and Communications Engineering YANSAHAN UNIVERSITY.
EE322 Digital Communications
Nov 01, 2005CS477: Analog and Digital Communications1 Bandpass Noise Analog and Digital Communications Autumn
Low Noise Amplifier Design
Department of Electronic Engineering City University of Hong Kong EE3900 Computer Networks Data Transmission Slide 1 Continuous & Discrete Signals.
3-1 Introduction Experiment Random Random experiment.
Review of Probability and Random Processes
Z. Ghassemlooy 1 Noise in Communication Systems Professor Z Ghassemlooy Electronics and IT Division School of Engineering Sheffield Hallam University U.K.
Chapter 8. Impact of Noise Husheng Li The University of Tennessee.
Digital Communication
ELEC 303 – Random Signals Lecture 21 – Random processes
Random Processes and LSI Systems What happedns when a random signal is processed by an LSI system? This is illustrated below, where x(n) and y(n) are random.
Formatting and Baseband Modulation
Part 2 Physical Layer and Media
CE 4228 Data Communications and Networking
ECE 590 Microwave Transmission for Telecommunications Noise and Distortion in Microwave Systems March 18, 25, 2004.
Chapter 2. Signals Husheng Li The University of Tennessee.
Introduction to Analog And Digital Communications
Dept. of EE, NDHU 1 Chapter Three Baseband Demodulation/Detection.
COSC 4214: Digital Communications Instructor: Dr. Amir Asif Department of Computer Science and Engineering York University Handout # 2: Random Signals.
TELECOMMUNICATIONS Dr. Hugh Blanton ENTC 4307/ENTC 5307.
Random Processes ECE460 Spring, Power Spectral Density Generalities : Example: 2.
ECE 5233 Satellite Communications Prepared by: Dr. Ivica Kostanic Lecture 9: Satellite link design (Section 4.3) Spring 2014.
Abdul-Aziz .M Al-Yami Khurram Masood
Wireless Communication Elec 534 Set I September 9, 2007 Behnaam Aazhang.
1 Chapter 1 Introduction to spread-spectrum communications Part I.
1 What is small scale fading? Small scale fading is used to describe the rapid fluctuation of the amplitude, phases, or multipath delays of a radio signal.
Effect of Noise on Angle Modulation
Ya Bao, South Bank University 1 Noise Richard Read, The Essence of Communications Theory, Chapter 3.
Adaphed from Rappaport’s Chapter 5
Chapter 6. Effect of Noise on Analog Communication Systems
Chapter 4: Baseband Pulse Transmission Digital Communication Systems 2012 R.Sokullu1/46 CHAPTER 4 BASEBAND PULSE TRANSMISSION.
ارتباطات داده (883-40) فرآیندهای تصادفی نیمسال دوّم افشین همّت یار دانشکده مهندسی کامپیوتر 1.
COSC 4214: Digital Communications Instructor: Dr. Amir Asif Department of Computer Science and Engineering York University Handout # 3: Baseband Modulation.
Chapter 6 Bandpass Random Processes
Digital Communications Chapeter 3. Baseband Demodulation/Detection Signal Processing Lab.
Chapter 10: Noise In Microwave Circuits
Chapter 1 Random Process
ECE 4371, Fall, 2009 Zhu Han Department of Electrical and Computer Engineering Class 7 Sep. 15 th, 2009.
Dept. of EE, NDHU 1 Chapter One Signals and Spectra.
ECE 4710: Lecture #31 1 System Performance  Chapter 7: Performance of Communication Systems Corrupted by Noise  Important Practical Considerations: 
Electronic Noise Noise phenomena Device noise models
ECE 4710: Lecture #37 1 Link Budget Analysis  BER baseband performance determined by signal to noise ratio ( S / N ) at input to detector (product, envelope,
Outline Transmitters (Chapters 3 and 4, Source Coding and Modulation) (week 1 and 2) Receivers (Chapter 5) (week 3 and 4) Received Signal Synchronization.
CHAPTER 1 Part 2.1  Noise.
ENE 490 Applied Communication Systems
1 Review of Probability and Random Processes. 2 Importance of Random Processes Random variables and processes talk about quantities and signals which.
EEE Chapter 6 Random Processes and LTI Huseyin Bilgekul EEE 461 Communication Systems II Department of Electrical and Electronic Engineering Eastern.
Performance of Digital Communications System
NARROW BAND NOISE UNIT IV Prepared by: D.MENAKA & S.NANDHINI, Assistant Professor, Dept. of ECE, Sri Venkateswara College of Engineering, Sriperumbudur,
Eeng360 1 Chapter 2 Linear Systems Topics:  Review of Linear Systems Linear Time-Invariant Systems Impulse Response Transfer Functions Distortionless.
Eeng Chapter4 Bandpass Signalling  Bandpass Filtering and Linear Distortion  Bandpass Sampling Theorem  Bandpass Dimensionality Theorem  Amplifiers.
Kiran Thapaliya Pranesh Sthapit Ramesh Lama. I. What the system link budget tells the system engineer II. The Channel a)The concept of Free Space b)Error.
Noise in Communication Systems
EE354 : Communications System I
Eeng Chapter4 Bandpass Signalling  Bandpass Filtering and Linear Distortion  Bandpass Sampling Theorem  Bandpass Dimensionality Theorem  Amplifiers.
Dr. Clincy Professor of CS
Outline Introduction Signal, random variable, random process and spectra Analog modulation Analog to digital conversion Digital transmission through baseband.
Advanced Wireless Networks
Sampling rate conversion by a rational factor
Dr. Clincy Professor of CS
Chapter 6 Bandpass Random Processes
Probability, Random Variables, and Random Processes
Electronic Noise Noise phenomena Device noise models
EE 6332, Spring, 2017 Wireless Telecommunication
Chapter4 Bandpass Signalling Bandpass Filtering and Linear Distortion
Noise I Abigail Firme.
Presentation transcript:

Chapter 3. Noise Husheng Li The University of Tennessee

Homework 2  Deadline: Sept. 16, 2013

Random Process  For a random process in the discrete time domain, we use to represent the probability distribution of n samples.  If the random process is stationary, we have  Hierarchy of probability density of random process

Markov Process  Markov process is a special type of random process.  For each Markov process, we have  Intuitively, in a Markov process, given the current system state, the future system state is independent of the previous history.

Noise  Noise is the negative factor impairing communication qualities. Without noise, we may transmit as much as we want without errors.  In this chapter, we study the mechanisms, properties and descriptions of various types of noise.  We follow the classical book: D. Middleton, An Introduction to Statistical Communication Theory, Peninsula Publishing, 1987

Three Types of Noise  In this chapter, we consider three types of noises:  Thermal noise  Shot noise  Impulse noise

Thermal Noise  Thermal noise is the result of the random motion of the free electrons in a conductor with temperature T.  The random movement results in a random current I(t).  Two equivalent representations of a resistance at temperature T:

Spectrum of Thermal Current (detailed model)  Using the theory of electrons (such as free path), we obtain the spectrum of thermal current  When the wave length is 10^-6cm and T0=300K, the spectrum begins to depart from the uniform response when f is more than 10^13 rad/s.In the range of wireless signal, we can consider the thermal noise as ‘white’.  The voltage spectrum is given by

An Alternative Derivation  We can have another approach to derive the Nyquist equation:

Quiz  Problem 1. Given the following band pass signal: write down the equivalent baseband signal in both time and frequency domains.  Problem 2. Consider a two-path wireless channel with the following output: write down the frequency domain transfer function.

Generalization  Nyquist’s result is mot limited to purely resistive elements in an equilibrium state, but can also be directly extended to general (passive) linear systems.

Noise Factor and figure  The noise factor of a system is defined as  The noise figure is defined as  The noise factor is given by, where T_e and T_0 are the noise and physical temperatures. For a cascaded system, the noise factor is given by

Homework 3  Problem 1. If the temperature is 300K and the signal bandwidth is 1MHz, what is the value of noise power?  Problem 2. Consider a series of devices with gains G1, G2, …, Gn and noise temperature T1, T2, …, Tn. What is the expression of the noise temperature of these concatenated devices?  Problem 3. What is the expectation and variance of Poisson distribution?  Deadline: Sept. 23, 2013.

Distribution of Thermal Noise  We can assume that the thermal noise is Gaussian distributed:  Usually we also assume that the thermal noise is white, i.e., the noise is independent for different time slots.  In this case, we say that the communication channel is additive white Gaussian noise (AWGN).

White Noise  When the noise spectrum is flat, we call it white noise.  The spectral density is given by

Filtered (Colored) Noise  When passed through a LTI filter with transfer function H(f), we have  Example: noise passed through RC network

Noise Equivalent Bandwidth  Average noise power:  Noise equivalent bandwidth:  The filtered noise is What about the RC circuit?

Illustration of Equivalent Bandwidth

Bandpass Noise  Bandpass noise results when white noise passes through a bandpass filter.

SNR  The predetection signal-to-noise ratio is given by  We also define a system parameter (W is the low pass filter bandwidth)

Quadrature Components  The bandpass noise can be written as  The power spectral densities are identical lowpass functions related to G_n(f):

Envelope and Phase  The envelope of bandpass noise is a Rayleigh random variable  The phase distribution is uniform over [0,2π]

Impulse Noise  The noise inherent in transmitting and receiving systems is for the most part due to thermal effects in both the passive and active elements of the system.  Additional noise may enter a communication link through the medium of propagation. One common source is interference, which has a noticeable different statistical character.

A General Model  We assume that the noise process X(t;a) is the resultant of multiple events in the time interval (t,t+T).  We have

Poisson Noise  In this model, the process X(t,a) is assumed to be the result of the linear superposition of independent impulses.

Typical Impulsive Noises

Temperature-limited Shot Noise  Shot noise is the name given to the noise that arises in vacuum tubes and crystals because of the random emission and motion of electrons in these active elements.  Noise of this type appears as a randomly fluctuating component of the output current and along with thermal noise is an important factor inhibiting the performance of transmitting and receiving systems.

Expression of Distribution  Consider the current of a temperature limited diode.  The current waves can be written as  The first order approximation is given by

Spectrum of Shot Noise