K. Fuchsberger
Kick response measurements Dispersion measurement
Vertical error increasing (phase) H response (MCIAH.80204) V response (MCIAV.80104)
Kick-response measurements H: Dp/p dep. Only partly reproduced by model V: Phase error for Dp/p=0, but almost no Dp/p dep. of measured data. (Data: )
Kick-response measurements H: V: (Data: )
FT-length (s)b2b3deltak/kdeltap/pdeltarms average stddev b3 is independent on FT length (average = -4.68) b2, deltak/k, deltap/p unrealistic, but related by transformation. (Data: ) Fits to Kick-response data:
(Data: )
BPM scaling polynomials applied additional factor of 1/1.12 applied (after polynomials) 2 nd order Dispersion higher than predicted by model! (Data: )
9 (Data: )
BPM scaling polynomials applied additional factor of 1/1.12 applied (after polynomials) !? (Data: )
Results from fit: 1. Calc parameters from Kick- Response 2. With resulting values fit xi and Dp/p to Dispersion. 3. Fit Kick-Response with fixed Dp/p 4. Go to (Data: )
Preliminary Conclusions: A model including b 3 (between about -4 and -5 units) reproduces very well both the measured dispersion- and kick-response- data. The effect is independent on the flat-top length. Questions: What is a realistic (measured) average value for a b 3 the MBIs used in TI8? What else could be the source of the observed effects?
(Data: )
(Data: ) !?
with Relation to madx strengths: