JERRY THE MOUSE. By: Zainab Alamery

Step 1: ☻This is sketching that I did of other mice that helped me form my Jerry mouse. I started the mouse design with just a couple of ideas like you see below.

Step 2: ☻These are a couple of ideas that I had of my mouse it started with the ones on the below.

Step 4: ☻These are the sketches I started for my finial design.

☻This is jerry the mouse it is made in Rhino, Rhino is used for things like this 3D design it shows all the sides for example Perspective, top, front, right. Start with a sketch, drawing, physical model, scan data, or only an idea—Rhino provides the tools to accurately model and document your designs ready for rendering, animation, drafting, engineering, analysis, and manufacturing or construction. Step 3:

Step 4: ☻This mouse was made by forming shapes and figures to get it to look like this by using the tool bar on the right.

Step 5: ☻This is the front view of my mouse as you can tell there are small round circles in the bottom that is so the mouse can stand up on them, so it can move faster.

Step 6: ☻This is the back view of my mouse I used circles to form the cushion on the mouse to keep the user comfortable. Also the two ovules on the side are to keep the pinky and the thumb on the side and comfortable. In the bottom of the mouse there are wheels to help it move faster.

Step 7: ☻I called this mouse “ Jerry the mouse” because it reminded me of Jerry it looked like a mouse.

The End. ☻ Brought to you by “let me tell you” Productions.