Liquids and Gasses Matter that “Flows”

Slides:



Advertisements
Similar presentations
Chapter 11 Fluids Mass Density DEFINITION OF MASS DENSITY The mass density of a substance is the mass of a substance divided by its volume: SI Unit.
Advertisements

Matter 1. Density: m – mass V – volume Units:
Chapter 15 Fluids. Pressure The same force applied over a smaller area results in greater pressure – think of poking a balloon with your finger and.
Fluids Mechanics Carlos Silva December 2 nd 2009.
Chapter 9 Solids and Fluids 1. Introduction 2. Fluids at Rest 3. Fluid Motion.
Fluids Gases (compressible) and liquids (incompressible) – density of gases can change dramatically, while that of liquids much less so Gels, colloids,
Static Fluids Fluids are substances, such as liquids and gases, that have no rigidity. A fluid lacks a fixed shape and assumes the shape of its container.
Fluids - Statics Level 1 Physics. Essential Questions and Objectives Essential Questions What are the physical properties of fluid states of matter? What.
Fluids Fluids are materials that can flow, gases and liquids. Air is the most common gas, and moves from place to place as wind. Water is the most familiar.
AP Physics II.A – Fluid Mechanics.
Lecture 8b – States of Matter Fluid Copyright © 2009 Pearson Education, Inc.
Chapter 9 Solids and Fluids. Solids Has definite volume Has definite volume Has definite shape Has definite shape Molecules are held in specific locations.
Static Fluids Fluids are substances, such as liquids and gases, that have no rigidity. A fluid lacks a fixed shape and assumes the shape of its container.
Unit 3 - FLUID MECHANICS.
Fluid Mechanics Chapter 10.
AP Physics II.A – Fluid Mechanics.
Chapter 14 PHYSICS 2048C Fluids. What Is a Fluid?  A fluid, in contrast to a solid, is a substance that can flow.  Fluids conform to the boundaries.
Monday, Nov. 22, 2004PHYS , Fall 2004 Dr. Jaehoon Yu 1 1.Density and Specific Gravity 2.Fluid and Pressure 3.Absolute and Relative Pressure 4.Pascal’s.
CHAPTER 15 : FLUID MECHANICS
Chapter 10 Fluids.
Chapter 11 Fluids. Density and Specific Gravity The density ρ of an object is its mass per unit volume: The SI unit for density is kg/m 3. Density is.
© 2005 Pearson Prentice Hall This work is protected by United States copyright laws and is provided solely for the use of instructors in teaching their.
Advanced Physics Chapter 10 Fluids. Chapter 10 Fluids 10.1 Phases of Matter 10.2 Density and Specific Gravity 10.3 Pressure in Fluids 10.4 Atmospheric.
Hydrostatics: Fluids at Rest. applying Newtonian principles to fluids hydrostatics—the study of stationary fluids in which all forces are in equilibrium.
Fluid Mechanics Chapter 13 2 Fluid Anything that can flow A liquid or a gas Physics Chapter 13.
Warm-up Pick up the free response at the door and begin working on it.
Static Fluids.
Fluids AP Physics Chapter 10.
Chapter 15 Fluid Mechanics.
Chapter 10 Fluids. Units of Chapter 10 Phases of Matter Density Pressure in Fluids Atmospheric Pressure and Gauge Pressure Pascal’s Principle Measurement.
A fluid is a state of matter in which the particles are free to move around one another. No definite shape exists. The term “fluid” encompasses liquids.
Fluid Mechanics - Hydrostatics AP Physics 2. States of Matter Before we begin to understand the nature of a Fluid we must understand the nature of all.
© 2005 Pearson Prentice Hall This work is protected by United States copyright laws and is provided solely for the use of instructors in teaching their.
Chapter 11 Fluids.
Chapter 15 Fluid Mechanics States of Matter Solid Has a definite volume and shape Liquid Has a definite volume but not a definite shape Gas –
Monday, Nov. 17, 2003PHYS , Fall 2003 Dr. Jaehoon Yu 1 PHYS 1443 – Section 003 Lecture #20 Monday, Nov. 17, 2003 Dr. Jaehoon Yu 1.Density and Specific.
1 Fluid Mechanics Chapter 13 2 Fluid Anything that can flow A liquid or a gas.
Chapter 14 Fluids What is a Fluid? A fluid, in contrast to a solid, is a substance that can flow. Fluids conform to the boundaries of any container.
Fluids Unlike a solid, a fluid can flow. Fluids conform to the shape of the container in which it is put. Liquids are fluids the volume of which does not.
Chapter 9.1 Review Fluids. 1. What are the properties of a fluid? What states of matter are fluids?
Unit 6 : Part 1 Fluids.
Fluids. Introduction The 3 most common states of matter are: –Solid: fixed shape and size (fixed volume) –Liquid: takes the shape of the container and.
Chapter 14 Fluids.
Subdivisions of matter solidsliquidsgases rigidwill flowwill flow dense dense low density and incompressible and incompressible compressible fluids condensed.
Advanced Physics Chapter 10 Fluids.
Chapter 12 Gases Gases, Liquids and Soils Liquids and Gases Similarities: Both do not have an absolute shape Both are “fluids” because it can flow.
Copyright © 2015 John Wiley & Sons, Inc. All rights reserved. Chapter 11 Fluids.
FLUIDS A fluid is any substance that flows and conforms to the boundaries of its container. A fluid could be a gas or a liquid. An ideal fluid is assumed.
Wednesday, Apr. 14, 2004PHYS , Spring 2004 Dr. Jaehoon Yu 1 PHYS 1441 – Section 004 Lecture #20 Wednesday, Apr. 14, 2004 Dr. Jaehoon Yu Variation.
Fluids. Units of Chapter 10 Phases of Matter Density and Specific Gravity Pressure in Fluids Atmospheric Pressure and Gauge Pressure Pascal’s Principle.
Fluid Mechanics - Hydrostatics AP Physics B. States of Matter Before we begin to understand the nature of a Fluid we must understand the nature of all.
Fluid Mechanics Chapter 8. Fluids Ability to flow Ability to change shape Both liquids and gases Only liquids have definite volume.
Today (Chapter 10, Fluids)  Review for Exam 2 Tomorrow (Chapters 6-10)  Review Concepts from Tuesday  Continuity Equation  Bernoulli’s Equation  Applications/Examples.
Physics Chapter 9: Fluid Mechanics. Fluids  Fluids  Definition - Materials that Flow  Liquids  Definite Volume  Non-Compressible  Gasses  No Definite.
Phys 101, General Physics I. Reference Book is Fluid Mechanics A fluid is a collection of molecules that are randomly arranged and held together by weak.
Chapter 14 Lecture 28: Fluid Mechanics: I HW10 (problems):14.33, 14.41, 14.57, 14.61, 14.64, 14.77, 15.9, Due on Thursday, April 21.
Ying Yi PhD Chapter 11 Fluids 1 PHYS HCC. Outline PHYS HCC 2 Density and Pressure Pressure and Depth in a Static fluid Buoyant Forces and Archimedes’
Chapter 11 Fluids.
Chapter 11 Fluids.
Fluid Mechanics Presentation on FLUID STATICS BY Group:
Physics 21.
Fluids Liquids and Gases Chapter 11.
Copyright © 2014 John Wiley & Sons, Inc. All rights reserved.
Chapter 7: Solid and Fluids
When you catch a deep-sea fish, why does its eyes pop-out?
Physics 151: Lecture 29 Today’s Agenda
Chapter 14 PHYSICS 2048C Fluids.
Chapter 14 PHYSICS 2048C Fluids.
Chapter 11 Fluids.
Presentation transcript:

Liquids and Gasses Matter that “Flows” Fluid Mechanics Liquids and Gasses Matter that “Flows”

Density and Specific Gravity Density is mass per unit volume SI unit is But this is also used

Specific Gravity Ratio of density to the density of water at 4oC. Density of water at 4oC=1 g/cm3 The 4oC is important since water’s density changes with temperature It has nothing to do with gravity Relative density would be a better term

Pressure A static fluid will exert a force perpendicular to any surface it is in contact with Pressure is defined as Force per unit Area Note this is scalar SI unit of N/m2=pascal=pa

Atmospheric Pressure The big volume of air above us exerts pressure downwards. Pressure at sea level Changes depending on elevation, temperature, weather condition etc.

Pressure at depth Assume that is constant all throughout the liquid. Fluid is incompressible Force is from weight of liquid

Pressure at depth If fluid is compressible (gasses) density changes with height and equation is only valid for very thin slices.

Pascal’s Law Equations independent of Area, only height matters. Pressure is the same at any two points at the same level of the fluid. If pressure is applied to one end it is distributed throughout the fluid and to the walls of the container

Pascal’s Law Application Hydraulic Lift However, volume of the liquid remains the same

Hydraulic Lift Work done by F1 = Work done by F2

Example A car lift used in a service station uses compressed air to exert a force on a small piston with a circular cross section of radius 5.00cm. The pressure is transmitted by a liquid to a second piston of radius 15.0 cm. What force must the compressed air exert to lift a car weighing 13300N? What air pressure produces this force?

Example Note: no need to convert to meters since units cancel

Absolute Pressure and Gauge Pressure Total Pressure within a vessel Gauge Pressure Excess Pressure above atmospheric pressure Gauge Pressure – Ex. A tire shows 220kPa Absolute Pressure of tire is 220kPa+1atm=320kPA Flat tire actually has 1 atm of pressure inside

Pressure Gauges - Manometer Many different devices used to measure pressure Manometer – consists of a U-shaped tube filled with a liquid of known density. It is open in one end and the other end is connected to a container filled with gas whose pressure to be measured.

Pressure Gauges - Manometer Bottom of tube has same pressure Gauge pressure is proportional to height difference

Pressure Gauges - Barometer Mercury barometer – consists of filled tube of mercury closed on one end and the other end is inverted into a dish of mercury. Pressure in the closed end of the tube can be approximated to be zero.

Pressure Gauges - Barometer mmHg or Torr, is another common unit of measure of pressure. But it is affected by temperature (density of Hg changes) as well as gravity.

Buoyancy Bodies immersed in water will weigh less Bouyant Force is exerting an upward force Assume a submerged object with uniform cross section area A

Bouyancy

Bouyancy Archimedes’ Principle- When a body is immersed in a fluid, the fluid exerts an upward force on the body equal to the weight of the fluid displaced by the body.

Example Archimedes was supposedly tasked to determine if the crown of the king was pure gold. He solved this by first weighing the crown in air, and then weighing the crown when submerged in water. Suppose the scale read 7.84N in air and 6.84N in water, what is the crown made of?

Example

Bouyancy An object will float if

Fluid Flow – Fluid Dynamics Complicated, but can be simplified with certain assumptions Ideal Fluid Incompresible- same density throughout Not viscous - has no internal friction Minimal turbulence

Fluid Flow Assume the flow is steady Flow rate is constant

Fluid Flow Since incompresible Continuity Equation

Example A water hose of 2.50cm diameter is used by a gardener to fill a 30.0L bucket. The gardener notes that it takes 1.00min to fill the bucket. A nozzle with an opening of cross-sectional area 0.500cm2 is attached and held so water is projected horizontally from a point 1.00m above ground. Over what horizontal distance can the water be projected?

Example

Example

Bernoulli’s Equation Pressure in a fluid depends on velocity and height Assuming ideal fluid, fluid at certain cross section will do work on other parts of the fluid.

Bernoulli’s Equation

Example Water enters a house through a pipe with an inside diameter of 2.0 cm at an absolute pressure of 4.0x105 Pa. A 1.0cm diameter pipe leads to the second floor bathroom 5.0 m above. When the flow speed at the inlet pipe is 1.5 m/s, find the flow speed, pressure and volume flow in the bathroom.

Example

Example

Problems Giancoli 10-20 In working out Pascal’s principle, Pascal showed dramatically how force can be multiplied with fluid pressure. He placed a long thin tube of radius r=0.30cm, vertically into a wine barrel of radius R=21cm. He found that when the barrel was filled with water and the tube filled to a height of 12m, the barrel burst. Calculate (a) the mass of water in the tube? (b) the net force exerted on the barrel lid just before rupture.

Serway 14-20 A U tube of uniform cross-secitonal area, open to the athmosphere, is partially filled with mercury. Water is then poured into both arms. If the equilibrium configuration fo the tube is as shown with h2=1.00cm, find h1.

Young and Friedman 14.31 A cubical block of wood, 10 cm on a side, floats in the interface of oil and water with its lower surface, 1.50cm below the interface. The density of oil is 790kg/m3. (a) what is the gauge pressure at the upper face of the block? (b) What is the gauge pressure at the lower face of the block? (c) What are the mass and density of the block?

Young and Friedman 14.46 A golf course sprinkler system discharges water from a horizontal pipe at the rate of 7200cm3/s. At one point in the pipe, where the radius is 4.00cm, the absolute pressure is 2.40x105 Pa. At a second point in the pipe, the water passes through a connection where the radius is 2.00cm. What is the absolute pressure as it flows through the constriction?