Warning! All information contained herein are the properties of Tim Nash. Do not duplicate or distribute this side show with my permission!

Start-up Screens First Start-up Screen

Start-up Screens Second Start-up Screen

Start-up Screens Fourth Screen. You can see the LED’s are flashing. (I missed the third screen)

Start-up Select Screen After the start-up screens, the controller waits for an input from the operator for 5 seconds. If no input, the controller loads the last settings by default.

OEM Settings load The factory settings are: V-Boost on – 6000 rpm V-Boost full rpm Shift Light – 9000 rpm Rev Limit – rpm

New Settings Screen Three button menu selects the new settings for v-boost, rev limit, and shift.

V-Boost On Screen Adjust to set when the v-boost starts to open the servo.

V-Boost Wide Open Adjust to set RPM where the V-Boost is wide open.

Rev Limit Screen Adjust to set the Rev Limit RPM.

Shift Light Screen Adjust to set the shift RPM

Saving Screen This is displayed when any setting has been modified.

Smoking Screen This is displayed after an adjustment to the v- boost settings.

Key on, bike off screen

Idle Reading

Yee-Ha Button Fully opens v-boost at 1800 RPM with out going threw all the screens (just in case a v-rod happens by on a Sunday).

Wide Open % Controller is indicating V-Boost output. Output is scaled and indicated in 10% increments.