[LAB 1] Getting Start  Introduction  Getting Start  Guiding Materials

 配件 :  Beagle Bone  USB OTG cable  MicroSD Card  MicroSD Card adaptor BeagleBone Rev A6a

Getting Start  Connect to PC with Windows7

Getting Start  Check Storage device

Getting Start  Install the driver: Bone_DRV or Bone_D64  It’s going to pop out an error message  Change the language of system to English.  Change back after installed.

Getting Start  Default mode when BeagleBone connect to PC via USB cable is FlashDrive mode.  Switch to Network mode after Driver has been installed by “Eject” function.

Getting Start

 Launch Bone101 introduction  Connect to address :80  Launch Cloud9 IDE with Chrome or FireFox  Connect to IP address :3000

Getting Start  Bone101

Getting Start  Cloud9 IDE

Guiding Materials  BeagleBone System Reference Manual  BeagleBone Schematic  

Guiding Materials  BeagleBone System Reference Manual

Guiding Materials  BeagleBone Schematic

Guiding Materials 

Guiding Materials 

Example 1  Drive LED onBoard USR 2 、 USR 3  Programming in JavaScript  “require (’Bonescript’)” for including Library in need.

Example 1  Drive LED onBoard USR 2 、 USR 3  Programming in JavaScript  “require (’Bonescript’)” for including Library in need.

Example 1