Grouting Ceramic Tile This step comes after the tile is installed and has had time to cure. It is very important to either follow the instructions listed.

Slides:

Advertisements

Similar presentations

Ceramic Tile Installation Step 5 – Install Tile TNC EDUCATION SERVICES, INC Instructional Design and Learning Management.

Advertisements

Mosaics. History of Mosaics Mosaic can be traced back through several cultures. The first culture attributed with mosaics was the Aboriginal Native Americans.

NGfL CYMRU GCaD FLOOR COVERINGS.

Adhesives Questions 1)What is the best kind of clamp to use when gluing wood edge to edge? A.Spring clamp B.Bar clamp C.C clamp D.Hand screw clamp.

Welcome to: Interior & Exterior Maintenance and Repair Course.

Applying Floor Finish To Protect Floor Surfaces, and to Maintain Clean, Safe, Attractive Floors.

2313 W Sam Houston Parkway N Suite 105 Houston, Texas ROK Shield Application Instructions ROK Shield is a non-toxic,

HVAC523 Soldering.

Flasking ,Wax elimination Packing and Processing

SPRAY-DOWN OVERLAYMENT APPLICATION SPRAY-DOWN. THE BENEFITS OF OVERLAYMENT REPAIR EXISTING SURFACES PROFITABLE ELIMINATE REMOVAL SAVES TIME ON EXISTING.

© Pearson Education Limited, Copying permitted for the purchasing institution only. This material is not copyright free. Painting and Decorating.

Chapter 13, Section 3. Discuss the procedures for removing these types of stain from tile floors Blood stains Burn marks Candy or chewing gum Heel marks.

Curing and Protection of Concrete

Salk Institute Mobile Lab Gel Electrophoresis Teacher Instructions VWR Set Up 12 groups Mira Costa kit.

Tracheostomy Cleaning Guidelines (All Information taken from individual manufacturer’s guidelines) Arcadia Cleaning Soak the tube for 60 minutes in warm.

1 USDOC41 Rev 0 1/04 Training and Education Program ©2004 HemoCue, Inc. HemoCue ® Training and Education Program The HemoCue Hb System.

Method to fix wall tiles. Preparation All wall tiles to be immersed in water for 3-4 hours for better results. Some gap in between the rows to allow the.

Steps to Regrout Bathroom Tile Ph. No.(914) or (888)

Producing Plaster Components Casting a plaster slab.

Basic cleaning procedures

Readme slide for presentation Delete before use The following presentation is based on teaching the CAMT course using the CAMT Participant guide. It is.

New Mexico FFA Agricultural Mechanics Career Development Event Concrete and Masonry.

Color Wheel. Step 1: You will need to get 12x18 inch white paper to paint on.

VERTICAL/WALL APPLICATION. PRIMING YOUR WALL PRIMER: MAY BE APPLIED DIRECTLY OVER DRYWALL, MASONRY, CONCRETE, CONCRETE BLOCK, OR ICF/STYROFOAM SUBSTRATES.

INTD 59 intro to kitchen & bath design kitchen finishes.

Ceramics. Ceramic objects are made with inorganic, non-metallic materials that are heated and then cooled. These materials tend to be strong, but brittle.

GLAZING 101 Ceramics 1 Waverly-Shell Rock HS. GLAZE IS… A liquid suspension of finely ground minerals which is applied on the surface of bisque fired.

Step 1: Prepare the surface The floor should be clean, dry, flat and sound. The floor should be free from oily/waxy or curing compounds.

Dry lining by direct bond – overview

HOW TO GUIDE PAINTING TECHNIQUES. CONTENTS INTRODUCTION EQUIPMENT AND MATERIALS LEARNING OUTCOMES CLASS PREPERATION THE WORKSHOP TEAM BUILDING STEP BY.

1 HVACR316 - Piping Soldering. 2 Soldering Copper Tubing The most common method of joining copper tubing in hydronic heating systems is soft soldering.

Kristin Cook. Overview Picking a Color Picking a Paint Type Types of Materials for Different Patterns Preparing the Walls Painting Conclusion Questions.

INDUSTRIAL FLOOR SHEETING_. Industrial Floor Sheeting  INTRODUCTION_  BENEFITS_  SUGGESTED SPECIFICATION_  INSTALLATION INSTRUCTIONS_  MAINTENANCE.

FLOORFLEX VINYL TILES_. Floorflex Vinyl Tiles  INTRODUCTION_  BENEFITS_  SUGGESTED SPECIFICATION_  INSTALLATION INSTRUCTIONS_  MAINTENANCE PROCEDURES_.

SUPERFLEX VINYL TILES & SHEETING_. Superflex Vinyl Tiles & Sheeting  INTRODUCTION_  BENEFITS_  SUGGESTED SPECIFICATION_  INSTALLATION INSTRUCTIONS_.

Linocut Materials. Lino plate The traditional base for a linocut print is made from carved linoleum. Some artists have switched over to other materials.

Rafco Products Acid Staining. Rafco Products Acid Staining JadeTurquoiseCoffeeCarmel MahoganyEbonyMission Brown Amber Reactive stains Natural colors Permanent.

Effervescent Launchers Vanderbilt Student Volunteers for Science Training Presentation Fall 2004.

Intaglio Materials.

Motorcycle gas tank rust removal & sealing Notes: 1.These are suggested instructions 2.Only applicable to steel gas tanks 3.Sealer won’t work on plastic.

Principles of Manufacturing Copyright © Texas Education Agency, All rights reserved 1.

University of Nebraska–Lincoln Know how. Know now.

GLAZING 101 Ceramics Mr. Martin.

COLORFLOR STANDARD.  INTRODUCTION_  BENEFITS_  SUGGESTED SPECIFICATION_  INSTALLATION INSTRUCTIONS_  MAINTENANCE PROCEDURES_  TECHNICAL PROPERTIES_.

Clay Painting Form of clay animation, which is one of the many kinds of stop motion animation The base clay of your sculpture or the 'Canvas' of your 'Clay.

TROWEL-DOWN OVERLAYMENT APPLICATION TROWEL-DOWN. THE BENEFITS OF OVERLAYMENT REPAIR EXISTING SURFACES PROFITABLE ELIMINATE REMOVAL SAVES TIME ON EXISTING.

COMPACT SHEETING SARLON COMPACT UNI. INTRODUCTION  Compact vinyl flooring contribute to lowering noise disturbance within a building in a number of ways.

HOMOGENEOUS VINYL TILES & SHEETING COLORFLOR STANDARD.

COMPACT SHEETING SURESTEP STAR. INTRODUCTION  Surestep is a 2m wide glass fibre-mat reinforced compact antistatic vinyl floor covering, featuring a 0.7mm.

HOMOGENEOUS VINYL TILES & SHEETING ELITE PUR. INTRODUCTION  Homogeneous vinyl flooring has a uniform structure and composition from the top to the bottom.

Paintbrush Care. Parts of a brush 1. Wipe the paint off the brush First, wipe off excess paint using a cloth or soft tissue. Gently squeeze the brush.

STATIC CONTROL TILES & SHEETING PRIMO SD. INTRODUCTION  Static Dissipative flooring is essential for protecting sensitive equipment from static charge.

Steps in Cleaning Floors Using Vinegar and White Vinegar for Laminate Floors VacuumCleanerReviewss.com.

HOMOGENEOUS VINYL TILES FLOORFLEX. INTRODUCTION  Homogeneous vinyl flooring has a uniform structure and composition from the top to the bottom as there.

Create decorative backsplashes, accent walls, or other focal points

SUPERFLEX HOMOGENEOUS VINYL TILES & SHEETING.

FLOORFLEX® VINYL TILES_.

Grouting Armstrong Alterna Tile

INDUSTRIAL FLOOR HOMOGENEOUS VINYL SHEETING.

VINYL TILES & SHEETING_

Fiberglass-Reinforced Sheet Flooring Installation System

GLAZING Ceramics.

Fiberglass-Reinforced Sheet Flooring Installation System

Student: xxxxxxxxx AEC 204 Lab December 5, 2006

Effervescent Launchers

Int’l Manufactured Stone Corp.

Presentation transcript:

Grouting Ceramic Tile This step comes after the tile is installed and has had time to cure. It is very important to either follow the instructions listed on the next slides or follow the manufacturer’s suggestions if different from the requirements listed within this lesson. Copyright © Texas Education Agency, All rights reserved.

Mixing Grout 1.) Prepare a small batch of floor grout to fill tile joints. Grout comes in different colors and can be tinted if necessary. Tinting is a trial and error process. When you get the color you want, save the formula. TIP: When mixing grout for porous tile, such as quarry or natural stone, use an additive with a release agent to prevent grout from bonding to the tile surfaces. Copyright © Texas Education Agency, All rights reserved.

Applying the Grout 2.) Starting in a corner, pour the grout over the tile. Use a rubber grout float to spread grout outward from the corner, pressing firmly on the float to completely fill joints. For best results, tilt the float at a 60º angle to the floor and use a figure-eight motion. Copyright © Texas Education Agency, All rights reserved.

Troweling the Grout 3.) Use the grout float to remove excess grout from the surface of the tile. Wipe diagonally across the joints, holding the float in a near-vertical position. Continue applying grout and wiping off excess until about 25 sq. ft. of the floor has been grouted. Copyright © Texas Education Agency, All rights reserved.

Sponging the Grout Joints 4.) Wipe a damp grout sponge diagonally over about 2 sq. ft. of the tile at a time to remove excess grout. Rinse the sponge in cool water between wipes. Wipe each area once only; repeated wiping can pull grout from the joints. Repeat steps 1 through 4 to apply grout to the rest of the floor. Copyright © Texas Education Agency, All rights reserved.

Buffing the Surface Clean Allow the grout to dry for about 4 hours, then use a soft cloth to buff the tile surface free of any remaining grout film. Copyright © Texas Education Agency, All rights reserved.

Applying Sealer to the Joints Apply grout sealer to the grout lines, using a small sponge brush or sash brush. Avoid brushing sealer on the tile surfaces. Wipe up any excess sealer immediately. Copyright © Texas Education Agency, All rights reserved.

Sealing Porous Tile VARIATION: Use a tile sealer to seal porous tile, such as quarry tile or any unglazed tile. Roll a thin coat of sealer (refer to manufacturer's instructions) over the tile and grout joints with a paint roller and extension handle. Copyright © Texas Education Agency, All rights reserved.

Our Next Lesson Will Be ? Under Construction Instructor’s Choice Copyright © Texas Education Agency, All rights reserved.