Metamorphism: New Rocks from Old Chapter 10 Geology Today Barbara W. Murck, Brian J. Skinner Disharmonic Folding in Gneiss N. Lindsley-Griffin, 1999
Rock Cycle Metamorphic Rock Rock formed in the solid state by alteration of preexisting rock deep within the Earth. Heat, pressure, and chemically active fluids are the agents. J. R. Griffin, 1999
Metamorphism Mineralogical, chemical, and structural changes in solid rocks, in response to physical and chemical conditions at depths below regions of sedimentation and diagenesis. Fig. 10.2, p. 273 N. Lindsley-Griffin, 1999
Pressure, temperature are the most important factors. Metamorphism Pressure, temperature are the most important factors. N. Lindsley-Griffin, 1999
Metamorphic Factors PORE FLUIDS Small amounts of gases or liquids between grains Facilitate solution, migration, and precipitation of ions to speed up recrystallization Provide a reservoir for ions during the growth of new minerals Speed up reactions Fig. 10.3, p. 274 Quartz veins in slate N. Lindsley-Griffin, 1999
Metamorphic Factors PRESSURE 1. Confining pressure: greater density, prevents fracture, plastic deformation 2. Differential stress: Non-uniform pressure produces preferred orientation, rock cleavage, foliation Fig. 10.4, p. 275: Granite formed in uniform stress Gneiss formed in differential stress N. Lindsley-Griffin, 1999
Metamorphic Factors HEAT Enhances recrystallization Speeds up chemical reactions At deepest crustal levels, some of the rock melts Migmatite - part metamorphic and part igneous (Fig. 10.9, p. 281) N. Lindsley-Griffin, 1999
Slate Gneiss Protolith: shale Protolith: shale Low grade High grade Metamorphic Factors TIME - enhances all other metamorphic factors Long periods of time allow larger grains to grow Slate Gneiss Protolith: shale Protolith: shale Low grade High grade N. Lindsley-Griffin, 1999
Metamorphic Factors LARGE AMOUNTS OF FLUIDS = METASOMATISM Composition changes greatly by: - addition of new material - removal of old material - combination of both Fig. 10.20, p. 291: Limestone changed into red garnet, green pyroxene, and calcite rock. If pure, would be marble. N. Lindsley-Griffin, 1999
Metamorphic Factors LARGE AMOUNTS OF FLUIDS = METASOMATISM Composition changes greatly by: - addition of new material - removal of old material - combination of both Fig. 10.20, p. 291: Limestone changed into red garnet, green pyroxene, and calcite rock. If pure, would be marble. N. Lindsley-Griffin, 1999
Preferred orientation: All the seagulls are facing into or away from the wind This alignment produces a foliation N. Lindsley-Griffin, 1998
Foliation: From conglomerate to metaconglomerate - flattened cobbles parallel to each other Alluvial sandstone and conglomerate Metaconglomerate, Fig. 10.5, p. 276 N. Lindsley-Griffin, 1998
Foliation: Slaty cleavage - tendency to break along planes that form perpendicular to maximum stress. In folded layers the cleavage parallels the axial plane Slaty cleavage at angle to bedding Fig. 10.7, p. 277 N. Lindsley-Griffin, 1999
Foliation: Schistosity - planar minerals like mica crystallize perpendicular to maximum stress. Garnet Schist Thin section view of schistosity in phyllite N. Lindsley-Griffin, 1999
Foliation: Gneiss - micaceous schist alternating with coarsely crystalline bands Pre-existing layers High-grade metamorphism N. Lindsley-Griffin, 1999
Low Grade to High Grade Progressive changes to shale as higher T and P over time allow different index minerals to form. Fig. 10.8, p. 280 N. Lindsley-Griffin, 1999
Types of Metamorphism CONTACT METAMORPHISM Rocks are heated and chemically changed by intrusion of hot magma. Concentric zones or aureoles N. Lindsley-Griffin, 1999
Types of Metamorphism BURIAL METAMORPHISM - Deep sedimentary basins REGIONAL METAMORPHISM - Subduction and plate collision; most intense where continents collide Affects broad regions Mountain ranges and continental interiors Fig. 10.12, p. 283 N. Lindsley-Griffin, 1999
Types of Metamorphism METASOMATISM Very large water-rock ratios Composition changes greatly by: - addition of new material - removal of old material - combination of both Fig. 10.20, p. 291: Limestone changed into red garnet, green pyroxene, and calcite rock. If pure, would be marble. N. Lindsley-Griffin, 1999
Metamorphic Facies INDEX MINERAL - appears at certain P-T conditions in the progression from lower grade to higher grade: Chlorite Biotite Garnet Kyanite Sillimanite ISOGRADS - lines on map showing where a particular index mineral first appears. Fig. 10.13, p. 284 N. Lindsley-Griffin, 1999
Assemblage of minerals typical of a set of metamorphic conditions Metamorphic Facies Assemblage of minerals typical of a set of metamorphic conditions Fig. 10.14, p. 285 N. Lindsley-Griffin, 1999
Polymorphs of Al2SiO5 reveal P-T conditions Metamorphic Facies Polymorphs of Al2SiO5 reveal P-T conditions Kyanite Sillimanite Andalusite Fig. 10.14, p. 285, with additions N. Lindsley-Griffin, 1999
Continental core regions -- Canadian Shield Regional metamorphism Continental core regions -- Canadian Shield N. Lindsley-Griffin, 1998
Finely foliated rocks: slate and phyllite. Regional metamorphism Finely foliated rocks: slate and phyllite. Slate, with slaty cleavage at high angle to bedding N. Lindsley-Griffin, 1998
Coarsely foliated rocks: Schist Regional metamorphism Coarsely foliated rocks: Schist Micaceous minerals, formed from shale or siltstone N. Lindsley-Griffin, 1998
Coarsely foliated rocks: Gneiss Regional metamorphism Coarsely foliated rocks: Gneiss Bands of micaceous minerals alternating with bands of granular minerals (usually quartz and feldspar) N. Lindsley-Griffin, 1998
Shear Metamorphism Along faults - grinding and crushing at shallow crustal levels, stretching and recrystallization at deeper levels. Also known as cataclastic metamorphism (not in textbook). Mylonite Thin section N. Lindsley-Griffin, 1998
Protolith + Process = Product Metamorphic Rocks Foliated Protolith + Process = Product Greenschist Amphibolite Basalt + moderate T and P = greenschist (green chlorite) Basalt + high T and P = amphibolite (black amphibole) Fig. 10.16, p. 288 N. Lindsley-Griffin, 1999
Protolith + Process = Product Metamorphic Rocks Foliated Protolith + Process = Product Basalt + low T, high P = Blueschist (blue amphibole) Blueschist + high T and P = Eclogite (green pyroxene, red garnet) (Fig. 10.17, p. 288) N. Lindsley-Griffin, 1999
Protolith + Process = Product Metamorphic Rocks Foliated Protolith + Process = Product Shale Slate Phyllite Schist, Gneiss Increasing metamorphic grade Fig. 10.8, p. 280 N. Lindsley-Griffin, 1999
Protolith + Process = Product Metamorphic Rocks Foliated Protolith + Process = Product Shale + heat, pressure Slate Phyllite with progressive growth of foliation, grain size (Fig. 10.15, p. 287) N. Lindsley-Griffin, 1999
Protolith + Process = Product Metamorphic Rocks Foliated Protolith + Process = Product Phyllite Schist (clay-rich) Gneiss (quartz + feldspar rich) N. Lindsley-Griffin, 1999
Protolith + Process = Product Metamorphic Rocks Nonfoliated Protolith + Process = Product Hand specimen of Quartzite Thin section of Quartzite Quartz sandstone + Recrystallization = Quartzite Fig. 10.19, p. 290 N. Lindsley-Griffin, 1999
Protolith + Process = Product Metamorphic Rocks Nonfoliated Protolith + Process = Product Thin section of Marble Hand specimen of Marble Limestone + Recrystallization = Marble Fig. 10.19, p. 290 N. Lindsley-Griffin, 1999
Metamorphic Facies at Convergent Boundaries High temperature, low pressure in volcanic arcs Greenschist and Amphibolite facies High pressure, low temperature in subduction zone Greenschist and Blueschist facies © Houghton Mifflin 1998. All rights reserved
Metamorphism at Convergent Boundaries Regional Contact Shear © Houghton Mifflin 1998. All rights reserved
Metamorphism at Mid-Ocean Ridges Sea water circulates in fractures Water is heated, hydrothermally changes basalt Metals are concentrated near hot vents © Houghton Mifflin 1998. All rights reserved
Metamorphism at Divergent and Transform Boundaries Shear Divergent: Hydrothermal Shear © Houghton Mifflin 1998. All rights reserved