ENGR 166 – Foundations in Engineering Structural Engineering Module Dynamics of Structures.

Slides:

Advertisements

Similar presentations

Advertisements

Development of an In-Situ Test for Direct Evaluation of the Liquefaction Resistance of Soils K. H. Stokoe, II, E. M. Rathje and B.R. Cox University of.

 BY: Lanise, Alexis, Jr., Matthew, Christian ▪ Plates grind against each other ▪ Earthquakes happen along the edges of tectonic plates ▪ The earthquakes.

Shakes and Quakes A Structural Engineer's View

Faults & Topography. What’s a Fault? A fault is a break in the rock that makes up the Earth’s crust. The surfaces on either side of the break move past.

Lecture-11 1 Lecture #11- Faults and Faulting. Lecture-11 2 Faults Bound the Major Plates.

Earthquakes Movement & Destruction. What is an Earthquake? Shaking of the Earth produced by a sudden movement of rock beneath its surface.

Seismology and Earthquake Engineering :Introduction Lecture 1.

1 Yahya C. Kurama, Professor Civil and Environmental Engineering and Earth Sciences University of Notre Dame Introduction to Engineering Program University.

1 Yahya Gino Kurama, Associate Professor Civil Engineering and Geological Sciences University of Notre Dame Introduction to Engineering Program University.

Yahya Kurama, Assistant Professor Richard Christenson, Graduate Student Tracy Correa, Graduate Student Gang Mei, Graduate Student Brian Morgen, Graduate.

Changes that IMPACT peoples lives! Changes to the Earth and Peoples lives in a matter of seconds.

Earthquakes An earthquake is shaking or movement of the Earth. They are caused by plate tectonics.

QUIZ 1.What are Earthquakes? 2._____ is the deformation of a material caused by stress. 3.Describe tension stress. 4.Faulting causes rock to _________.

EARTHQUAKES What is an Earthquake An earthquake is what happens when two tectonic plates suddenly slip past one another.

Earthquakes and Related Phenomena. Earthquake Web Resources

Schuyler Ozbick. wake-up-call /

Types of Faults Strike Slip Fault: Two layers of rock are shifted horizontally or parallel to the fault plane.

What is the Great Shake Out?

More Stuff About Earthquakes. Faults Any stress on the plates can cause an earthquake if the elastic limit is reached. Each type of stress results in.

STRESS – The amount of force exerted on a material.

QUIZ 10/21 1.What are Earthquakes? 2._____ is the deformation of a material caused by stress. 3.Describe tension stress. 4.Faulting causes rock to _________.

LEQ: What are the categories and types of faults, and what type of stress produce each? Key Terms: displacement, strike slip fault, dip slip fault,

Faults and Earthquakes Note: you should also have pictures drawn in your notes about where earthquakes occur along other plate boundaries (ie divergent,

The George E. Brown Network for Earthquake Engineering Simulations An Introduction MEP Camp 2011.

90 Vertical Horizontal Oblique line a b Angles a + b = 180 o Angles at a Point b = 115 o Angle a = 180 – 115 = 65 o.

LEQ: What are the categories and types of faults, and what type of stress produce each? Key Terms: displacement, strike slip fault, dip slip fault,

Ch. 8 Types of Stress that cause Earthquakes

GEOL 308 Quiz: Focal Mechanisms

Earthquakes - Seismology

Folding and Faulting Chapter 4, Sec. 4.

Plate Tectonic Animations

Normal Faults What Happens? Type of Boundary? Picture Examples…

Earthquakes Created by: Mr. Kreeger.

What causes Earthquakes?

I. Basic Techniques in Structural Geology

Earthquakes California Standards 3.a., b., & c.

هل يمكن أن نكون جيل الأرض الأخير؟

Types of Stress that cause Earthquakes

Chapter 12 Section 2 Earthquakes.

Waves and Oscillation waves transport _________ along a medium without transporting ________.

Douglas Dreger, Gabriel Hurtado, and Anil Chopra

Douglas Dreger, Gabriel Hurtado, and Anil Chopra

Earthquakes and Fault Types

Monitoring Faults.

Earthquakes EARTHQUAKE 101.

What is the Great Shake Out?

Earthquake Introduction

Types of Stress that cause Earthquakes

Deforming Earth’s Crust

CH. 14 Vocabulary test study guide

Folding and Faulting Chapter 4, Sec. 4.

Chapter 5 Section 1 What processes change Earth’s crust?

V. Fault Mechanisms and Earthquake Generation

Chapter 2 Vocabulary Review

Earth Science Notes Earthquakes.

Seismology Introduction.

Understanding Earthquakes.

Why do they happen? Where do they happen? How do they happen?

Thursday, March 7, 2013 Be in your seat when the bell rings

What is an Earthquake? An Earthquake is the vibrations produced when a rock snaps and breaks under different types of stress.

Seismology – Summary.

Blow-ups of seismic image (a) along strike-slip fault shown in Figure 13.4a, (b) large fold along profile PGS08-12 and (c) along profile PGS08-06 near.

Faults and Earthquakes

Earthquakes Forces Inside Earth

Presentation transcript:

ENGR 166 – Foundations in Engineering Structural Engineering Module Dynamics of Structures

NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation Tokyo Bay Bridge, Tokyo, Japan

NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation Millennium Foot Bridge, London, England

NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation Northridge Earthquake, California

NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation Previous Earthquakes around the World

NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation Previous Earthquakes around the US

NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation Thrust Fault Oblique Fault Normal Fault Strike Fault Earthquake Faults

NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation HORIZONTAL SLIP ALONG THE NAF 2 meters (6.6 feet) 2 meters (6.6 feet)

NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation HORIZONTAL SLIP ALONG THE NAF

NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation VERTICAL SLIP ALONG THE NAF 1.7 meters (5.6 feet) 1.7 meters (5.6 feet)

NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation NEES at CU Boulder The George E Brown, Jr. Network for Earthquake Engineering Simulation Seismic Waves