Positioning a shotfiring shelter

Slides:



Advertisements
Similar presentations
Falls from vehicles – toolbox talk for construction workers
Advertisements

Work at Height Regulations 2005
Health and Safety Executive Health and Safety Executive Running a Small Construction site Presenters name in Arial regular 32pt.
A Free Resource From The presentation is from Mark Sutton For SAFEHANDS Health & Safety Consultants Ltd A Free Resource From
The Post-Blast Inspection
Step-by-step guide to prevent falls
Blast Site Edge Protection
PowerPoint presentation
2013 Top 5 CFO Inspection Concerns Sgt Peter Niedermaier Supervisor of Shooting Clubs and Shooting Ranges Chief Firearms Office of Ontario.
Overview for Resource Room 203 Day 2 Part
1 Risk Management Department Ladder Safety July, 2006.
1 Walking-Working Surfaces This material was produced under grant [SH20856SH0] from the Occupational Safety and Health Administration, U.S. Department.
Step-by-step guide to prevent falls Module E - Other Specifications Part C-1-Fall Protection Requirements for Construction.
LADDER SAFETY.
Working at Height Regulations Statistics 2003 / 2004 (HSE) 67 Fatalities 3,884 major injuries (2/3 of which were falls from below 2 metres.
Working at Height Presented by Nic Carstens Health and Safety Officer Tel:
Control of Substances Hazardous to Health Regulations 2002 (COSHH)
Safety for Working in High Places
to a day when your employer must care about you -
CC1001K CARRY OUT SAFE WORKING PRACTICES. MANUAL HANDLING The Manual Handling Regulations The Manual Handling Regulations These regulations.
MAKE SURE YOUR OWN ACTIONS REDUCE RISKS TO HEALTH AND SAFETY.
Senior Staff Safety Presentation 18/12/08 SHE code 20 Controlling Explosive and Flammable Gases and Dusts.
Fall Hazards.
Safe Work Practices in AgMech The importance of AgMech. – Mechanical technology supplies security in the form of food, clothing and shelter.
Fire Precautions Regulations 1997 Alexi and Mat. Employers Responsibility Employers are responsible for providing multiple access and exit points in the.
Slide 1 of 12 Fires on Explosives Vehicles Guidance on what steps to take in the event of a fire on a vehicle that is either carrying explosives or materials.
Health & Safety West Winch Primary School. Health & Safety Overview.
Walking-Working Surfaces: Preventing Falls. Start Safe and Stay Safe In order to Start Safe and Stay Safe in the areas where you walk and work, you should.
Preventing Slips & Trips at Work
A guide to… Maintenance Safety. Aim There is a legal requirement for regular and effective maintenance, inspection and testing of work equipment. This.
Fall Protection.
Loading and Unloading of Drilling Rigs & Compressors Safe Transportation of Drilling Rigs and Compressors Drilling and Blasting Toolbox Talk : 02 This.
Danger Zone Control and the Duties of Sentries Guidance on how to ensure control of the danger zone and what is expected from sentries. Quarries Working.
Thunderstorms – Risks and Actions Guidance on what steps to take if a thunderstorm approaches during the blasting process. Quarries Working towards a safe.
Defining the Danger Zone for Blasting Guidance on what to consider when determining the danger zone for quarry blasting Quarries Working towards a safe.
This Presentation Developed By Drew R. Smith This presentation may be modified or reproduced by individual fire departments or training organizations provided.
Fall Protection Training. - Falls remain the number one cause of fatalities in the construction industry. FALL PROTECTION FACT!!!
The Chief Fire Officers’ Association The professional voice of the UK fire and rescue service Fire Safety & Housing Paul Dryden Greater Manchester Fire.
PROCEDURE FOR OPERATING HEDGE TRIMMERS (Revision 1 – 28th October 2010) Toolbox Talk.
Procedure for Using Strimmers (Revision 2 – 31 st July 2013) Toolbox Talk.
Rick Statham HAS Dip, CMIOSH (Joint Managing Director) Safety & Access Ltd SG4:10 Preventing Falls in Scaffolding Revised Industry Guidance.
If you are providing respiratory protection you have, or will arrange face fit testing. You have undertaken a task specific risk assessment and determined.
Procedure for Operating Leaf Blowers (Revision 1 – 17th November 2010) Toolbox Talk.
Slide 1 of 8 Post-Blast Fumes Guidance on post-blast fumes and what steps to take to avoid exposure to them. Drilling and Blasting Toolbox Talk : 16 Target.
Procedure for Use of Stihl Multisystem (Revision 0 – 18th January 2011) Toolbox Talk.
Slide 1 of 13 Don’t be a Dummy with Explosives A reminder of the power of detonators and explosives. Drilling and Blasting Toolbox Talk : 17 Target Audience.
Working at Height How to comply with the new Regulations.
IMPORTANT NOTE TO CONSTRUCTION MANAGERS
SG4:10 Preventing Falls in Scaffolding Revised Industry Guidance
A Toolbox Talk for Pedestrian Safety In Quarries and Surface Mining
Defining the Danger Zone for Blasting
Drilling and Blasting Toolbox Talk : 17 Updated October 2015
Subpart M Fall Protection.
Working at Height.
Drilling and Blasting Toolbox Talk : 03 Updated Aug 2014
Drilling and Blasting Toolbox Talk : 02 Updated Aug 2014
Drilling and Blasting Toolbox Talk : 10 Updated Aug 2014
Target Audience Anybody involved in the blasting process.
Drilling and Blasting Toolbox Talk : 07 Updated Oct 2015
Drilling and Blasting Toolbox Talk : 06 Updated Apr 2019
Target Audience Shotfirers and Explosives Supervisors.
Target Audience Shotfirers and Explosive Supervisors.
Drilling and Blasting Toolbox Talk : 16 Updated Oct 2015
Drilling and Blasting Toolbox Talk : 17 Updated October 2015
Target Audience All quarry personnel.
IMPORTANT NOTE TO CONSTRUCTION MANAGERS
IMPORTANT NOTE TO CONSTRUCTION MANAGERS
IMPORTANT NOTE TO CONSTRUCTION MANAGERS
IMPORTANT NOTE TO CONSTRUCTION MANAGERS
Work at Height – Ladders and Step Ladders
Presentation transcript:

Positioning a shotfiring shelter Drilling and Blasting Toolbox Talk : 01 Positioning a shotfiring shelter Guidance on what to consider when positioning a shotfiring shelter Quarries Working towards a safe and healthy quarrying industry National Joint Employers Advisory Employees Committee Health and Safety Executive This publication may be freely reproduced except for advertising, endorsement or commercial purposes. The information is current at January 2009. Please acknowledge ‘QNJAC’ as the source 

Positioning a shotfiring shelter 1. Introduction If you a firing a blast and need to be inside the declared danger zone then you must use a shotfiring shelter If you can fire the blast from a location outside of the declared danger zone then you do not need a shotfiring shelter This is the best option but requires the use of a remote firing system or very long lead-in cables/tubes What is the purpose of a shotfiring shelter ? To minimise risk for the shotfirer whilst firing the blast

Positioning a shotfiring shelter. 2. Construction How should a shelter be constructed ? There are no set guidelines for the construction of a shotfiring shelter, however, there are some obvious factors to be taken into account. Should be robust and fitted with a floor Should be capable of being moved in a safe manner by on-site equipment Should be big enough to hold all the people required Good idea to mark with a maximum number Should be fitted with an outward opening, closable door Should be fitted with an observation slit The following slide shows a good example of shelter construction

Positioning a shotfiring shelter. 2. Construction (continued) Example of a well constructed shotfiring shelter Photo courtesy of Aggregate Industries Size : can house 3 people in comfort Observation slot covered with steel mesh Strong, outwardly opening door Robust steel body Carrying system specifically design for on-site equipment Strong mesh floor, helps keep the shelter dry and clean

Positioning a shotfiring shelter. 3. Risks What are the risks ? Flyrock Impact on shelter Ingress through door Falls of ground From above : impact on shelter or through door From below : shelter falls to bench below Dust and fumes Lung damage

Positioning a shotfiring shelter. 4. Basic Guidance (continued) Distance from blast As far as possible Limited by the length of the shotfiring cable or shock-tube starter line A minimum distance should be specified in the shotfiring rules DISTANCE – The further the better

Positioning a shotfiring shelter. 4. Basic Guidance (continued) Can you fire from outside of the danger zone ? This is the best option If you can, then you do not need a shelter You will need a remote firing system This option also gives you greatly enhanced control over the danger zone as you can often fire from a viewing / observation point

Positioning a shotfiring shelter. 4. Basic Guidance (continued) Locate shelter behind or to side of blast if possible Location should be shown on a plan in the blast specification BLAST AREA

Positioning a shotfiring shelter. 4. Basic Guidance (continued) Distance from crest of bench As a guideline this distance should be at least 50% of the face height This could be increased if a geotechnical assessment indicates that this is required h/2 h

Positioning a shotfiring shelter. 4. Basic Guidance (continued) Distance from toe of face As a guideline this distance should be at least the face height This could be increased if a geotechnical assessment indicates that this is required If there are multiple benches above then the distance may need to be increased even more h h

Positioning a shotfiring shelter. 4. Basic Guidance (continued) Orientation of door of shelter Facing away from blast Parallel to crest of bench Parallel to toe of face above BLAST AREA

Positioning a shotfiring shelter. 4. Basic Guidance (continued) Wind direction To avoid exposure to dust and fumes the shotfiring shelter should not be downwind of blast BLAST AREA WIND DIRECTION

Positioning a shotfiring shelter. 5. Key Points Always use a shotfiring shelter Locate shelter as far away from the blast as possible and to the side or behind the blast Do not place the shelter down wind of the blast Locate the shelter away from the crest or toe of any face Orientate the door of the shelter away from the blast and parallel to the crest and toe of nearby faces