S-band BPM prime Support Hyoung Suk Kim KNU

Support Jig before Assembling b d a e c f Parts Names S-band BPM * Soft pusher ; MC Nylon (mono cast nylon) Right rim support ; Aluminum Turning knob ; Aluminum (or Brass) Left rim support ; Aluminum Base Plate ; Aluminum * S-band BPM has been sketched without its beam pipe for easy view

Functional Description on Jig Pieces  Turning knob (d) has notched surface around it to make easy to handle. Also this has male screw line on a nail body which is matched with the female screw line inside of the hole in right rim support (c).  Base plate (f) is a simple aluminum base plate which can be modified according to users, for example, screw hole drilling, another supporting rod addition to hold cover top plate over the BPM, etc.  S-BPM (a) can be safely held on the support jig not by the two contact points, such as a V-block support, but circumferential contact points between the S-band BPM (a) and Rim supports (e), (c).  Jig pieces are made of aluminum except of (b) (MC Nylon ; mono cast nylon). (Turning knob (b) could be made of other metal to keep its mechanical strength.)  Soft pusher (b) is made of MC Nylon to prevent some scratch on the BPM surface but with some compressive strength to fix the BPM (a).  Right rim support (c) and Left rim support (e) has circumferential curvature to fix the outer rim of the BPM.

Support Jig after Assembling b d a e c f This S-band BPM with its prime support are going to be scheduled to be transported to LAPP next week.