بسم الله الرحمن الرحيم. Training the student about:  Use of the analytical balance.  Volumetric glassware measurement.  Use of digital and glass.

Slides:

Advertisements

Similar presentations

Solution Concentration. Calculations of Solution Concentration Mole fraction Mole fraction – the ratio of moles of solute to total moles of solution.

Advertisements

Water and Solutions. The importance of water Important component of solutions Water quality, composition, and pH can drastically affect an experiment.

Ch 13 Solutions Sec 2 pg 467 #1-11.

Chapter 3 Calculations with Equations & Concentrations.

Molarity 2. Molarity (M) this is the most common expression of concentration M = molarity = moles of solute = mol liters of solution L Units are.

Changes in Solubility I.Pressure A. Changes in pressure do not affect solubility of liquid or solid solutes in liquid solvents. 1. But, increases in pressure.

Neutralization Chapter 21.

Solution Concentration. Calculations of Solution Concentration: Mass Percent Mass percent Mass percent is the ratio of mass units of solute to mass units.

Making Molar Solutions From Solids. What are molar solutions? A molar solution is one that expresses “concentration” in moles per volume Usually the units.

Molarity and Molality.

Solution preparation Solid solution Liquid soluti

Molarity. Molarity Molarity (M) or molar concentration is a measure of the concentration of a solute in a solution. Unit for molar concentration is mol/L.

Solutions II. Solubility curves Note that a typical solubility curve shows the total mass (in g) of a solute that will completely dissolve in 100 g of.

Solutions and their Behavior Chapter Identify factors that determine the rate at which a solute dissolves 2. Identify factors that affect the solubility.

Today: Quiz Thursday / Friday May 16/17 HW – Read pages Worksheet – Concentrations of solutions Worksheet - Molarity Problems 1.

1 Chapter 7: Solutions and Colloids. 2 SOLUTIONS Solutions are homogeneous mixtures of two or more substances in which the components are present as atoms,

Preparing a Molar Solution

Concentration/Dilution

Solubility and Concentration Chemistry Mrs. Coyle.

C.6-C.7 In which you will learn about: Different concentration units

1 SOLUTIONS A N I NTRODUCTION. 2 Objectives 1. What are different ways of expressing the concentration of a solution? When is each used?

Units of Concentration Bio Sciences; Chemicals. Bellwork What is a homogeneous solution? A homogeneous solution has the same uniform appearance and composition.

Solutions. Definitions n A solution is a homogeneous mixture n Solvent is the liquid in which the solute is dissolved n an aqueous solution has water.

Notes 15.2 Describing Solution Composition. Mass Percent Mass percent= mass of solute X 100 mass of solution = grams of solute X 100 grams of solute +

Concentration Units: Terms like “dilute” and “concentrated” are not specific. Percent by Mass: Mass % = mass of solute x 100 Total mass of solution Recall:

Section 15.2 Describing Solution Composition 1. To understand mass percent and how to calculate it Objective.

Acids Lesson 16 Titrations. A standard solution has known molarity. A primary standard is made by weighing a pure solid and diluting in a volumetric flask.

III. Molarity Topic 9 The Mole. A. Molarity Concentration of a solution. total combined volume substance being dissolved.

Chapter 20 Concentration. Molarity (M) Moles of solute per liter of solution. Molarity = moles of solute liters of solution.

Percent by mass, mole fraction, molarity, and molality

بسم الله الرحمن الرحيم UMM AL-QURQ UNIVERSITY Faculty of Medicine Dep. Of BIOCHEMISTRY.

Solution Composition & Concentration Mass Percent & Molarity!

Chapter 20 Concentration. Molarity (M) Moles of solute per liter of solution. Molarity = moles of solute liters of solution.

Solutions Chapter 13 & 14. Solution  A uniform mixture that may contain solids, liquids, or gases  Also called a homogeneous mixture  Composed of a.

Solutions Chapter 14.

Solution Concentration

Ch. 13/14: Solutions Describing a Solution’s Composition.

Daily Inquiry: 1.Many solutions are described as concentrated or dilute. Distinguish between these two terms. 2.A solution is made by dissolving 4.75 g.

Biotech Equations. Preparing Solutions What is a solution? – Mixture of two ore more substances Solutions have two parts – Solute – substance that is.

Stoichiometry: Quantitative Information About Chemical Reactions Chapter 4.

Concept of volumetry. CHEMICAL ANALYSIS METHODS OF CHEMICAL ANALYSIS Volumetry Gravimetry Chromatography Atomic absorption spectrometry Potentiometry.

So Temperature Can Effect Saturation As we saw in the Supersaturation Demo, temperature is important when trying to add a solute to a solvent. This is.

Chemical Solutions Preparations General Biochemistry Laboratory BIOC 201 Rami M. Mosaoa.

Solution Concentrations The measured amount of solute in a given amount of solvent or solution.

Biochemical Calculations

Common Lab Methods and Calculations

S-C-9-3_Concentrations Presentation

Solution Concentration

8.6 Making Molar Solutions

Solutions & Chemical Equilibrium

DILUTING A STOCK SOLN To make a soln less concentrated: add solvent

Tutorial 1 Lecture 3.

Molarity (M): State the ratio between the number of moles of solute & the volume of solution (in liters). Molarity (M) =

Biochemical Calculations

Section 2: Concentration

Solution Concentration

Concentration of Solute

Solution chemistry What are solutions?

b) Preparation of solutions from known concentration of liquids.

Solubility and Concentration

What is a Standard Solution?

EXP. NO. 6 Acid Base Titration

Experiment 2 Method for the Expression of concentration 1- Formality

Solution Concentration

Molarity (M): State the ratio between the number of moles of solute & the volume of solution (in liters). Molarity (M) =

Presentation transcript:

بسم الله الرحمن الرحيم

Training the student about:  Use of the analytical balance.  Volumetric glassware measurement.  Use of digital and glass pipettes.  Ideal preparation of different types of solutions (Standard, Saturated, Unsaturated and Percent solutions).

 Normality (g eq/L): The concentration of a solution in equivalents per liter.  Molality (W/W): Mole (mol.): A mass of a pure substance equal to its formula weight in grams (g).  Molarity (W/V): The concentration of a solution in units of moles of solute per liter of solution.

 In case of solids:  1 molar solution=M.W in gms.x100/purity%g/l.  Example: 1 molar solution of NaOH: =40 x 100/96.0 g/l.  In case of liquids:  1 molar solution=M.W x 100/purity x Sp.Gr. g/l.  Example: 1 molar solution of acetic acid: = x 100/99.5 x g/l.

 Take two conical flasks.  Place distilled water in one flask and tape water in the other.  Weigh 5 ml. of water six times from each flask using the analytical balance.  Express your results in the table.

or = C.V. (Co. Var.)% = x 100

o Read the given details of the reagent from its bottle: o M.W. o Sp. Gr. / or wt/v at 20 c. o Purity % o Prepare the given table:

 Prepare 250 ml. of 2M HCl. And NaOH solutions (see the table above).  Keep the solutions for the next practical.

 Prepare 20 ml. of saturated solution of Sodium chloride and Ammonium sulphate.

 Prepare 100 ml. of percent solutions of Sodium chloride and Ammonium sulphate. (5%, 10%, 12% and 15%). Experiment 5: Preparation of Percent Solutions.

QUESTIONS?