OSHA Region IV Electrical Outreach General Industry Photos 29 CFR 1910 Regulations

General Industry Photos Standard – (d)(9)(iii) Description – Welding lead cable splice were not insulated. All splices and metal parts of cables and parts must be guarded.

General Industry Photos Standard – (b)(1) Description – Building wiring systems were not properly installed. Wiring draped over building surfaces.

General Industry Photos Standard – (b)(2) Description – Equipment not installed IAW listing requirements.

General Industry Photos Standard – (g)(1)(iii) Description – Access to circuit breaker panels blocked.

General Industry Photos Standard – (g)(2)(i) Description – Live parts exposed.

General Industry Photos Standard – (g)(2)(i) Description – The receptacle was not properly installed in the junction box which exposed energized parts.

General Industry Photos Standard – (g)(2)(i) Description – Broken electrical receptacle exposing energized parts.

General Industry Photos Standard – (g)(2)(i) Description – Live parts of 480 VAC electrical system exposed. All live parts are required to be guarded.

General Industry Photos Standard – (g)(2)(i) Description – Front cover removed from circuit breaker panel. Live parts exposed.

General Industry Photos Standard – (f)(5)(v) Description – Portable light with metal guard which is required to be grounded.

General Industry Photos Standard – (f)(5)(v) Description – The ground pin was removed from the electric plug.

General Industry Photos Standard – (a)(2)(iii)(G) Description – Electrical wiring was not protected from damage. Lying across road where cranes and other vehicular traffic could pass over the wiring.

General Industry Photos Standard – (b)(2) Description – The faceplate was removed from the receptacle exposing the energized parts.

General Industry Photos Standard – (e)(1) Description – Electrical systems were not designed for wet and damp locations

General Industry Photos Standard – (g)(2)(iii) Description – The electrical plug did not have adequate strain relief which causes stress on the contacts.

General Industry Photos Standard – (j)(1)(iv) Description – Electric cords and cables lying in water.

General Industry Photos Standard – (j)(1)(iv) Description – The receptacle which was approved for wet and damp locations was damaged.

General Industry Photos Standard – (b)(1) Description – Electrical wiring was not approved for hazardous locations. Paint spray area.

General Industry Photos Description – Electrical wiring and systems were not installed IAW NEC.