Bottom insulation plate 4/15/2017 Top insulation plate Top plate Hot nozzle Hot runner plate A plate Cavity insert Core insert Slider Lifting device B plate Support pillar Ejector pin Support plate Ejector plate Ejector return plate Lifter Bottom plate Bottom insulation plate 2010-09-17
2010-09-17
2010-09-17
Hydraulic cylinder Hydraulic cylinder 2010-09-17
※Because the big slider construct is very complex, so the slider moving must slow by the hydraulic cylinder, otherwise the slider will be damaged easy. 因为结构复杂,大行位在油缸推动的过程中速度一定要慢,否则行位容易损坏. 2010-09-17
※The base of big slider is closed and the yellow inner slider is open before close the mold like the bottom picture show , because the yellow inner slider close by the angle pin of cavity, before the first of close the mold you must insure the big slider at such state. 合模前大行位座必须在关闭的位置,黄色内行位必须是打开的状态如下图所示,因为黄色行位需要通过前模斜导柱闭合, 首次合模前必须确保大行位处于这样的状态. Angle pins 斜导柱 2010-09-17
2010-09-17
Safety device Topinsulation plate Top plate Hot nozzle Hot runner plate A plate Cavity insert Slider Core insert Lifting device B plate Space block Ejector pin Support pillar Eject plate Lifter Eject return plate Bottom plate Bottom insulation plate 2010-09-17
Safety device Cavity insert Wedge Adjusting plate 2010-09-17
Slider Hydraulic cylinder Adjusting plate Press block Core insert 2010-09-17