Arnan Sipitakiat Dept. Computer Engineering, Chiang Mai Univeristy.

Slides:

Advertisements

Similar presentations

Interfacing to the Analog World

Advertisements

Analog-to-Digital Converter (ADC) And

Lecture 17: Analog to Digital Converters Lecturers: Professor John Devlin Mr Robert Ross.

Digital to Analogue Conversion

Digital-to-Analog & Analog-to-Digital Conversion BJ Furman 17APR2014.

Digital to Analog and Analog to Digital Conversion

©2008 The McGraw-Hill Companies, Inc. All rights reserved. Digital Electronics Principles & Applications Seventh Edition Chapter 14 Connecting with Analog.

CE 478: Microcontroller Systems University of Wisconsin-Eau Claire Dan Ernst Analog to Digital (and back again) Interfacing a microprocessor-based system.

ADC: Analog  Digital Converters Successive Approximation Register (SAR)

Khaled A. Al-Utaibi  Digital Vs Analog Signals  Converting an Analog Signal to a Digital One  Reading Analog Sensors with the.

ADC and DAC. Reason for Signal Conversion digital AD2 DA1.

From Continuous Time System to Discrete Time System ES400 Jack Ou, Ph.D. Chapter 1.

Lecture 9: D/A and A/D Converters

Interfacing Analog and Digital Circuits

5-1 Analogue Input/Output Many sensors/transducers produce voltages representing physical data.  To process transducer data in a computer requires conversion.

DIGITAL SYSTEMS TCE INTERFACING WITH ANALOG DEVICES (Week 12)

1 Analog-to-digital converter Prepared by: Selah al-Battah Mohammed Al-khabbaz Atiyah Alnakhli Ali Dumyati.

Interfacing with the Analog World Wen-Hung Liao, Ph.D.

Embedded Systems Development and Applications

 Circuit building blocks that compare the strength of two signals (usually Volts) and provide an output signal when one is bigger than the other are.

AD/DA Converter National Instruments NI USB-6009 BME 1008 Introduction to Biomedical Engineering FIU, Spring 2015 Feb 12 Lesson 4 - NI USB Matlab.

EE174 – SJSU Lecture #4 Tan Nguyen

1 Figure 9.36 The process of periodically sampling an analog signal. (a) Sample-and-hold (S/H) circuit. The switch closes for a small part (  seconds)

EET260: A/D and D/A converters

Analog-to-Digital Converters Prepared by: Mohammed Al-Ghamdi, Mohammed Al-Alawi,

Analogue Input/Output

Digital to Analog and Analog to Digital Conversion

Digital to Analog Converters

Digital-to-Analog & Analog-to- Digital Conversion Anuroop Gaddam.

Data Converters ELEC 330 Digital Systems Engineering Dr. Ron Hayne

Digital-to-Analog Analog-to-Digital Microprocessor Interface.

Analog to Digital conversion. Introduction  The process of converting an analog signal into an equivalent digital signal is known as Analog to Digital.

Data Acquisition Systems

Analog to Digital Converters (ADC) Ben Lester, Mike Steele, Quinn Morrison.

AD/DA Conversion Techniques - An Overview J. G. Pett  Introductory tutorial lecture for :- ‘Analogue and digital techniques in closed-loop regulation.

Data Acquisition ET 228 Chapter 15 Subjects Covered Analog to Digital Converter Characteristics Integrating ADCs Successive Approximation ADCs Flash ADCs.

Design of Digital-to-Analog Converter Qin Chen Yong Wang Dept. of Electrical Engineering Feb. 6th, 2006 EE597G Presentation:

CHAPTER 19 Data Conversion. Objectives Describe and Analyze: Analog vs. Digital Signals Resolution Digital-to-Analog Conversion Analog-to Digital Conversion.

1 Data-Converter Circuits A/D and D/A Chapter 9 1.

Analog to Digital Converters

Analog/Digital Conversion

Comparators, DAC, and ADC

Figure Analog-to-digital conversion.. Figure The DAC output is a staircase approximation to the original signal. Filtering removes the sharp.

ECE 2799 Electrical and Computer Engineering Design ANALOG to DIGITAL CONVERSION Prof. Bitar Last Update:

Embedded Systems Design 1 Lecture Set C Interfacing the MCS-51 to: –D/A Converter –A/D Converter.

Digital-to-Analog Analog-to-Digital Week 10. Data Handling Systems  Both data about the physical world and control signals sent to interact with the.

0808/0809 ADC. Block Diagram ADC ADC0808/ADC Bit μP Compatible A/D Converters with 8-Channel Multiplexer The 8-bit A/D converter uses successive.

Sill Torres: Pipelined SAR Pipelined SAR with Comparator-Based Switch-Capacitor Residue Amplification Pedro Henrique Köhler Marra Pinto and Frank Sill.

EKT 314/4 WEEK 9 : CHAPTER 4 DATA ACQUISITION AND CONVERSION ELECTRONIC INSTRUMENTATION.

Digital-to-Analog Analog-to-Digital

Task 2: Define digital and analogue signals

0 /59 Nyquist Rate ADCs Dr. Hossein Shamsi ECE Dept, K.N. Toosi University of Technology.

Lecture Notes / PPT UNIT III

Analog-Digital Conversion. Other types of ADC i. Dual Slope ADCs use a capacitor connected to a reference voltage. the capacitor voltage starts at zero.

Networked Embedded Systems Sachin Katti & Pengyu Zhang EE107 Spring 2016 Lecture 13 Interfacing with the Analog World.

Digital to analog converter [DAC]

Digital-to-Analog Analog-to-Digital

Digital-to-Analog Analog-to-Digital

What is a DAC? A digital to analog converter (DAC) converts a digital signal to an analog voltage or current output DAC.

SAR ADC Tao Chen.

Analog-Digital Conversion

Data Acquisition System

Principles & Applications

Digital-to-Analog Analog-to-Digital

Simple ADC structures.

Simple ADC structures.

ADC and DAC Programming in AVR

Analog-to-digital converter

Chapter 7 Converters.

 Both data about the physical world and control signals sent to interact with the physical world are typically "analog" or continuously varying quantities.

Presentation transcript:

Arnan Sipitakiat Dept. Computer Engineering, Chiang Mai Univeristy

ADC Methods Direct conversion (Flash ADC) Successive-Approximation Ramp-compare ADC

Direct Conversion

Successive-Approximation DAC = Digital-to-Analog converter EOC = end of conversion SAR = successive approximation register S/H = sample and hold circuit V in = input voltage V ref = reference voltage

Ramp-compare ADC Similar to Successive Approximation, but uses a simple circuit to generate a ramp and measures the time it takes to match the input. The ramp generation circuit is often sensitive to temperature.

R1 = 33K, Vin = 5V ถ้า Rsensor = 66K ค่าที่อ่านจาก GoGo Monitor จะเป็นเท่าใด Vout = Vin x R2 / (R1+R2) Voltage divider: Measuring Resistance

Vo = Vin x R2 / (R1+R2) ADC = 1023 x R2 / (R1+R2) = 1023 x 66 / ( ) = 1023 x 2/3 = 682

Successive-Approximation ADC Voltage Divider

ADC Parameters Resolution. 8, 10, 12, … bits Number of analog ports ADC speed