CE/ENVE 320 – Vadose Zone Hydrology/Soil Physics Spring 2004 Copyright © Markus Tuller and Dani Or 2002-2004 Soil Bulk Density and Compaction Hillel, pp.

Slides:



Advertisements
Similar presentations
In Place Soil Density Test Methods
Advertisements

Water Budget IV: Soil Water Processes P = Q + ET + G + ΔS.
Soil Mechanics - II Practical Portion.
Soil Compaction.
Snow Depth Property with potentially largest variation in space.
Cover Crops and Biofuels Implications for Soil Characteristics and Plant Development Deanna Boardman October 21, 2009.
Aggregate Properties HMA
LABORATORY DETERMINATION OF POROSITY
Soil Tillage, Land Preparation, and Conservation
Drainage is the artificial removal of water from the cropped fields within the tolerance limit of the crops grown in the area under consideration.
SOIL MECHANICS & TESTING
Chapter 3 Compaction. To improve the density and other properties of soil Increases the solid density improves strength Lowers its permeability Reduces.
Soil Structure, Density, and Porosity Laboratory #4.
PHYSICAL PROPERTIES OF SOIL
Characterization of the Soil Liquid Phase
Chapter 4: Soil Architecture and Physical Properties
Physical Properties of Soil
ENCI 5791 Compaction In-situ soils used as: –Bases for the construction of highway pavements –embankments or leveling material for construction projects.
Created by Dr. Michael Pidwirny, Department of Geography, Okanagan University College, BC, CA evaporation Soil and Water Ch 5 Continued.
Soil Water ContentSoil Moisture Content Water that may be evaporated from soil by heating at C to a constant weight Gravimetric moisture content.
Soil Physical Properties Used to Assess Soil Quality Field Exercise.
Ch. 4 continued Soil Properties.
Physical Properties of Soil
SOIL TEXTURE Botany Soils. SOIL SEPARATES mineral soil is considered as a porous mixture of inorganic particles, decaying organic matter, water.
The Hydrological Cycle and Water Balance
7. Soil Compaction (Das, chapter 6)
Groundwater Hydraulics Daene C. McKinney
CHAPTER TWO SOIL COMPRESSION.
EFFECT OF TILLAGE ON PLANT GROWTH MUHAMMAD SARFARAZ 2008-ag-1574.
SEMBODAI RUKMANI VARATHARAJAN ENGINEERING COLLEGE DEPARTMENT OF CIVIL ENGINEERING FOUNDATION ENGINEERING BY KARTHIVELU.
Chapter 4 States of Matter.
4. Phase Relations (Das, Chapter 3) Sections: All except 3.6
Soil Water.
Prepared by: Marcia C. Belcher Construction Engineering Technology.
©2002 Pearson Education, Inc. Upper Saddle River, New Jersey THE NATURE AND PROPERTIES OF SOILS, 13/e Nyle C. Brady and Ray R. Weil Chapter 5 Soil.
Soil Respiration Unit: Soil Science. Objectives O Define: soil respiration and soil microbes O Explain the role of soil respiration in determining soil.
Water Movement Below Surface
Soil Water Tension Department of Agricultural and Biological Engineering University of Illinois at Urbana-Champaign.
Physical Properties of Soil Denham Springs Freshman High Ag I.
Characterization of Soil Moisture Status and the Movement of Water in Soils.
Geotechnical Engineering
Observation of Pore Scale Liquid Behavior with NIR-Microscopy and Advanced Laser Techniques Markus Tuller and Dani Or Dept. of Plants, Soils and Biometeorology,
Soil Bulk Density Unit: Soil Science. Objectives O Define: ammonification, available water holding capacity, nitrification, bulk density, denitrification,
Soil Structure, Density, and Porosity
Soil Chapter 2 Soil Physical Properties Pages 26 – 60.
T4-1 Soil Science and Management, 4E Chapter 4 Physical Properties of Soil.
Civil Engineering Department College of Engineering Course: Soil and Rock Mechanics (CE 260) Lecturer: Dr. Frederick Owusu-Nimo.
WATER I: POROSITY Intraped micropores Macropores.
Soil Physics David Zumr room: b608 Lecture (and seminar) notes will be available: -
Free Powerpoint TemplatesPage 1Powerpoint Templates Page 1 Powerpoint Templates Page 1 INDEX PROPERTIES, RELATIONSHIPS AND TEST.
BASIC SOIL PLANT WATER RELATIONS
Lecture 8 Elements of Soil Mechanics
Soil Properties determination
Aggregate Properties HMA
Water Budget IV: Soil Water Processes P = Q + ET + G + ΔS.
LABORATORY DETERMINATION OF POROSITY
Soils and Growing Media
Ahmedabad Institute of Technology
Physical Properties of Soil. Soil Texture What is Soil Texture? It is the proportion of three sizes of soil particles. Which are: Sand (Large) Silt (Medium)
Soil-Water-Plant Relationships A. Background 1. Holdridge Life Zones 1.
DETERMINATION OF FIELD DENSITY BY CORE CUTTER METHOD
Soil Physical Properties Used to Assess Soil Quality
SOIL COMPACTION GEOLOGY AND APPLIDE GEOLOGY -:Prepared By:- GEC,GODHRA
Soil Structure.
Soil Bulk Density/Moisture/Aeration
BOBOT ISI (BI) TANAH.
GOVERNMENT ENGINEERING COLLEGE
Sardar Patel Institute Of Technology
SEM 3 CIVIL.
Light Compaction Equipment
Presentation transcript:

CE/ENVE 320 – Vadose Zone Hydrology/Soil Physics Spring 2004 Copyright © Markus Tuller and Dani Or Soil Bulk Density and Compaction Hillel, pp. 12 & 112 4

Copyright© Markus Tuller and Dani Or Determination of Bulk Density To determine bulk density we need to measure the dry mass and the total volume occupied by the soil sample. CORE METHOD: A cylindrical metal sampler is driven into the soil to remove a known volume (core). The core (soil + brass cylinder) is oven-dried at 105 o C to remove non-structural soil water till the mass remains constant (usually after 24–48 hrs).

Copyright© Markus Tuller and Dani Or Core Method Volume Cylinder Dry Mass Sample Oven 105 o C

Copyright© Markus Tuller and Dani Or Core Method - Example r = 3 cm h = 12 cm M s = 480 g (oven-dry mass) r h

Copyright© Markus Tuller and Dani Or Excavation Methods – Sand Funnel A quantity of soil is excavated in the field, dried at 105 o C and weight. The volume is determined by filling the excavated hole with a well defined standard sand of which the volume per unit mass is known. (SAND-FUNNEL Method) Valve Standard Sand Base Plate

Copyright© Markus Tuller and Dani Or Excavation Methods – Rubber Balloon Water Tower with Scale In the RUBBER BALLOON Method the volume is determined by inserting a balloon into the excavation and filling it with water or an other fluid with known density. Rubber Membrane Valve

Copyright© Markus Tuller and Dani Or Bulk Density – Clod Method The clod method is based on measuring volume and mass of a wet clod sampled in the field according to the following steps. 1.Sample clod and put it into a nylon hairnet of known mass. Weigh clod +hairnet. 2.Coat the clod with Saran solution to make it waterproof. Apply 2-3 layers and allow min drying time for each layer (solvent evaporates). Weigh container with saran before and after coating to determine the mass of saran covering the clod. 3.Weigh clod with coating and hairnet. Weigh clod again when it is suspended in water at known temperature (Archimedes principle). 4.To correct for water content of the soil, break open the clod and take a small sub-sample. Weigh sub-sample before and after oven drying.

Copyright© Markus Tuller and Dani Or Bulk Density – Clod Method CLOD METHOD:

Copyright© Markus Tuller and Dani Or Clod Method 5.Calculate oven-dry mass of clod: where M w is the wet weight of the clod (corrected for the hairnet), and q m is gravimetric water content determined for the sub- sample. 6.Calculate bulk density:

Copyright© Markus Tuller and Dani Or Bulk Density – Gamma Rays GAMMA RAY TECHNIQUES: Gamma ray techniques are based on attenuation and diffraction of gamma rays emitted from a 137 Caesium or 241 Americium source due to collision with other atoms of the soil phases. Attenuation and diffraction are dependent on bulk density and other soil properties (e.g., water content)

Copyright© Markus Tuller and Dani Or Gamma Rays TRANSMISSION TECHNIQUE: Two probes at a fixed spacing are lowered into previously prepared openings in the soil. One probe contains a Geiger tube, which detects the attenuated radiation transmitted through the soil from the gamma source located in the second probe.

Copyright© Markus Tuller and Dani Or Gamma Rays SCATTERING TECHNIQUE: A single probe contains both, detector and source separated by shielding. Can be used on the surface or placed in a hole dependent on design of the equipment.

Copyright© Markus Tuller and Dani Or Gamma Ray SCATTERING TECHNIQUE: A single probe contains both, detector and source separated by shielding. Can be used on the surface or placed in a hole dependent on design of the equipment.

Copyright© Markus Tuller and Dani Or  In agriculture and forestry soil compaction is undesirable.  For many engineering applications a well compacted soil is crucial for safe foundations (the Leaning Tower of Pisa is an example of building on soft soil). Soil Compaction – desired or not? Image: Opera Primaziale Pisana

Copyright© Markus Tuller and Dani Or Soil Compaction Low porosity (n) or high bulk density (  b ) are indicators for soil compaction. Soil compaction results in mechanical impedance to plant root growth, poor aeration, and reduced water infiltration. forest ecosystems are extremely sensitive to soil compaction! Compaction associated with timber harvest operations could disturb ecosystem for many years.

Copyright© Markus Tuller and Dani Or ·Operation of heavy vehicles (e.g. harvesters, construction machines) on agricultural land can cause soil compaction. Agricultural Soil Compaction – Causes

Copyright© Markus Tuller and Dani Or ·Compaction alters soil hydraulic and gaseous exchange properties and increases mechanical impedance to plant roots. Soil Compaction – Indicators

Copyright© Markus Tuller and Dani Or Soil Compaction - Agriculture

Copyright© Markus Tuller and Dani Or ·Compaction hampers plant growth and decreases crop yield. ·The extent of soil degradation due to compaction exceeds an area of 6.8x10 4 km 2 worldwide (Oldeman 1991). Soil Compaction – Effects

Copyright© Markus Tuller and Dani Or Visualization of effect of compaction on flow Water flow pathways are visualized using dye tracer experiments The resulting distribution of dye tracer in the soil reflects the degree and patterns of soil compaction.   (Kulli 2001)

Copyright© Markus Tuller and Dani Or Soil Compaction – Effects on pore spaces

Copyright© Markus Tuller and Dani Or Modeling effects of soil compaction on pore space mm mm mm mm mm mm Results from uniaxial compression tests of soil samples at different initial water potentials (Berli, 2002) were in agreement with pore closure model (Ghezzehei & Or, 2002).

Copyright© Markus Tuller and Dani Or Soil Compaction – agricultural practices Subsoiler

Copyright© Markus Tuller and Dani Or Mechanical impedance to root growth A tillage pan has been mechanically broken by a subsoiler. Roots penetrate into the subsoil through the subsoiler slot to access water and nutrients.

Copyright© Markus Tuller and Dani Or Mechanical impedance to root growth Loose zone Subsoiling Chisel Plowpan Root distribution of a cotton plant

Copyright© Markus Tuller and Dani Or Soil Compaction – Gas flow (aeration) Surface compaction can be partially reduced with an aerator

Copyright© Markus Tuller and Dani Or Soil Compaction – Aeration The aerator cuts and removes small cores from the top few centimeters, thereby creating vertical channels for improved infiltration and aeration.

Copyright© Markus Tuller and Dani Or Soil Compaction – Aeration