Reliability of present dc system is high, but could increase if a redundant battery or a redundant battery system were put in parallel with present system.

Slides:



Advertisements
Similar presentations
PowerPoint ® Presentation Chapter 4 System Components and Configurations Components Electricity Sources System Configurations.
Advertisements

Series and Parallel Circuits
Chapter 5: Server Hardware and Availability. Hardware Reliability and LAN The more reliable a component, the more expensive it is. Server hardware is.
ERIC VANDENBURG, SPENCER HOMAN, TREVOR LARSON and NIK URLAUB Team website: / 1.
1 Team BUSS Backup Storage Source. 2 Team BUSS Backup Storage Source EHV Substation Second DC Storage Source Sponsor Idaho Power Company Team Members.
Team BUSS Backup Storage Source. Team BUSS Idaho Power Company Backup Storage Source Project Title Extra High Voltage (EHV) Station Second DC Storage.
1 Team BUSS Backup Storage Source. 2 Team BUSS Backup Storage Source EHV Substation Second DC Storage Source Sponsor Idaho Power Company Team Members.
INSIDE THE GRID Feedback Session Tara Kotheimer Cynthia Smith IIT Research Mentor: Dr. Alexander Flueck This material is based upon work supported by the.
Understanding Network Failures in Data Centers: Measurement, Analysis and Implications Phillipa Gill University of Toronto Navendu Jain & Nachiappan Nagappan.
During a mains supply interruption the entire protected network is dependent on the integrity of the UPS battery as a secondary source of energy. A potential.
Cody Hyman.  The Base Load Power Plants  Always active and feeding the grid  Mostly Coal and Nuclear  Intermediate and Peaking Power Plants  Activated.
Solar Lightings Solar Module. Charge Controller. Battery. Inverter. Loads Accessories.
Lesson 9: Electrical Components
10.13 Series & Parallel Circuits. Series Circuits electric circuit in which the loads are arranged one after another in series. A series circuit has only.
Performance modeling of a hybrid Diesel generator-Battery hybrid system Central University of Technology Energy Postgraduate Conference 2013.
Hybrid Wind & Solar Generation Project
Power Supply Design J.SHANMUGAPRIYAN.
Shore Station UPS Requirements for the NEPTUNE Power System
Small Wind Electric Systems Wind Turbine Electrical Output – Electricity from a spinning shaft Balance of Systems – Types – Components.
BLACKOUT POWER OUTAGE By Masih Madayeni Class 3/6 English Presentation.
Basic Electrical Engineering Lecture # 04 Simple Resistive Circuits Course Instructor: Engr. Sana Ziafat.
ELECTRICAL SAFETY Part 1: Basic Electricity k groves /e haller.
PHY 202 (Blum)1 More basic electricity Non-Ideal meters, Power, Power supplies.
NHA 2010, Long Beach, California, USA E. PINTON May 4th TECHNICAL AND ECONOMICAL STUDY ABOUT THE INTEREST IN USING PEMFC SYSTEMS TO FEED STAND ALONE.
Energy and Electricity. Basic ideas… Electric current is when electrons start to flow around a circuit. We use an _________ to measure it and it is measured.
Electrical Systems.
Lyndonville Electric Department Feasibility Analysis Review December 2,
Physics I Honors 1 Current and Circuits Current Physics I Honors 2 Electric Current Voltage (which indicates the presence of an electric field) causes.
Parallel Circuits – Chapter 5
Enrollment no.: Abhi P. Choksi Anuj Watal Esha N. Patel Guidied by: M. K. Joshi, P.R.Modha A.D.PATEL.INSTITUTE.
Series and Parallel Circuits. Circuits  Can either be series or parallel.
Series and Parallel Circuits. Circuits  Can either be series or parallel.
Analysis of Electrification of Remote Villages in Palestine by using: PV system, Diesel, or Extension Electrical Network Prepared by :Ayman Shtayah Qais.
Electric Current and Circuits Lesson 3. Electric Current Electrons in a static state have energy, but are far more useful when they are made to transfer.
Producing and Measuring Electricity. DC and AC DC stands for “Direct Current” – the current only flows in one direction: AC stands for “Alternating Current”
Red Rocks Community College ENY 130 Grid-Tied PV Fall 2009 Module 2.
Series and Parallel Wiring GET A CALCULATOR!!!!!.
Introduction to Power Supplies
Battery Backup PV Systems Design Considerations
DC Generator Patrick Mulligan.
PHY 202 (Blum)1 More basic electricity Non-Ideal meters, Kirchhoff’s rules, Power, Power supplies.
U3e-L3 1.Why are the + and – symbols unnecessary when drawing the power source in an electric schematic? 2.A ______ circuit occurs when the positive terminal.
CELLS IN SERIES AND PARALLEL Lesson 9. Cells in Series  The electric potential given to a single electron by a dry cell has an average voltage of around.
Feedback Controlled Brushless DC Motor Background Lecture.
Regenerative braking system
IEA INTERNATIONAL ENERGY AGENCY PHOTOVOLTAIC POWER SYSTEMS PROGRAMME Overview 1.Introduction / Summary 2.PV-diesel hybrid systems 3.Measurement equipment.
Microgrid Load Management and Operation Erich Keller G&W Electric Co. Frank Patton Jr., PE N. J. Shaum & Son, Inc.
Colocation Data Center Availability : Making Maintenance Windows Obsolete Christopher Thames, Director of Critical Facilities.
Photovoltaic and Battery Primer
Chapter 17 Resonance Circuits.
DC Circuits.
Lesson 9 Parallel Circuits.
7. Power in electric circuits
Wen Cai Supervisor: Dr. Babak Fahimi December 04, 2015
Photovoltaic Systems Engineering Session 22 Solar+Storage Systems
What do all these have in common? What are they used for?
Reduction in Downtime via Interlocking
Series and Parallel Circuits
Characteristics of Series & Parallel Circuits
Resistors in Series and Parallel
HYBRID RENEWABLE ENERGY SYSTEMS AND ENERGY SAVING
Created for CVCA Physics By Dick Heckathorn 3 March 2K + 5
Sizing Methodologies • Sizing Calculations
FIGURE 12-1 A Leyden jar can be used to store an electrical charge.
Photovoltaic Systems Engineering Session 16 Solar+Storage Systems
KELMAN CIRCUIT BREAKER ANALYZER
FIGURE 12-1 A Leyden jar can be used to store an electrical charge.
Electricity and Magnetism
Components inverters Except where otherwise noted these materials are licensed Creative Commons Attribution 4.0 (CC BY)
Presentation transcript:

Reliability of present dc system is high, but could increase if a redundant battery or a redundant battery system were put in parallel with present system. Due to low initial cost and proven lifetime and reliability, lead acid batteries are still best alternative for the time being. Ultracapacitor and fuel cell hybrid systems (with batteries) are close to being viable alternatives. In order to become viable, costs need to decrease in the future and these alternatives need to see more field testing. Extra High Voltage Substation Back Up Storage Source Instructor: Joe Law Loads were divided into two separate portions, the momentary load and the continuous load. Showed that ultracapacitors are able to trip a coil (momentary load). Lesson learned: resonance must be considered when adding capacitance to a RL circuit. Present Fault Tree Substation Battery Bank Reliability of present dc system was determined to be Multiplying by minutes in a year (525,600) gives the downtime of the present dc system, 14.7 min per year. Options to increase reliability include adding a parallel battery source or adding a complete parallel system. Adding a redundant battery in parallel with the present battery would increase reliability to , or 3.80 min of downtime per year. Adding a complete battery system in parallel with the present system would increase reliability to 7.82*10^-10, or sec of downtime per year. Lead acid batteries are the least reliable component of the dc system. As a storage source, however, they are very reliable and the reliability of all storage source alternatives will be compared against batteries. Reliability Analysis Bench Top Testing Rob ButzerMitch ColburnBrian Vandenburg Analysis of Alternative Background Objective Team Members: Lead Acid Batteries Ultracapacitors DC Generators Fuel Cells Flywheels High Reliability Initial Cost Substations use dc supply systems to sustain control functions during periods of loss of the ac power system. Many extra high voltage (EHV) substations have a single battery and charger system to supply dc power. The eastern U.S. blackouts of 2003 and other system events have revived interest in redundancy within the power system. The battery and charger can be a significant single point of failure that is expensive to mitigate. Maintenance requirements of lead acid batteries have also driven further interest in alternatives Calculate the reliability of the present dc storage system in EHV substations. Compare the present battery system with other storage systems based on reliability and cost. Recommend the most economical and reliable redundant system. Conclusion Maintenance Cost Lifetime Not Available Not Available Poor Low Very High Low High Minimal Low High Stand Alone? ~20 years Estimated 10 years Estimated 10 years ~20 years Yes No* *Note: To be determined a stand alone source, the source must be able to supply a continuous current for 8 hours immediately after power is lost. The source must also provide a high momentary current at the end of an 8 hour period. These storage alternatives were also analyzed in combination with one another, or as “hybrid systems.” PoorHighLow ~10 yearsYes Block Diagram of System