1. Engineers shall not undertake technical assignments for which they are not qualified by education or experience." To do so would be "faking it." This.

Slides:



Advertisements
Similar presentations
Conflict of Interest, Conflict of Commitment, and Outside Activities UTSA HOP 1.33 Non-covered UTSA staff 1.
Advertisements

ETHICS. Business Conduct  The Agent agrees to conform to all applicable federal, state and local laws in conducting business under this agreement.
Code of Ethics for Professional Accountants
Codes of Ethics The Value in Developing a Code of Ethics for a Profession or in an Organization Module 2 in the “Teaching Engineering Ethics” Series.
VIRGINIA PUBLIC PROCUREMENT ACT ARTICLE 1-GENERAL PROVISIONS § Short title; purpose; declaration of intent. -- A. This chapter may be cited as.
INDEPENDENCE AICPA Code of Professional Conduct (Article IV):
Engineering Ethics* What is engineering ethics?
ENGINEERING ETHICS.
ASME Code of Ethics1 Engineering Ethics Discussion not Lecture Ethics not Morals No person is perfect.
CODE of ETHICS for ENGINEERS: NSPE
1 Engineering Ethics Seminar Richard O. Mines, Jr., Ph.D., P.E. Hodge Jenkins, Ph.D., P.E. February 2005 Mercer University School of Engineering.
Codes of Ethics The Value in Developing a Code of Ethics for a Profession or in an Organization Module 2 in the “Teaching Engineering Ethics” Series.
1 Code of Professional Conduct Darrell Knapp Kansas City Actuaries Club Seminar June 24, 2009.
1 Practical Ethics: Following the MTA’s Code of Ethics in the Real World A Webinar Presentation March 13, 2007 – Charles Comer, CMT.
Engineering Ethics Chapter 12
5/5/2015Software Engineering Code of Ethics1 Software Engineering Code of Ethics and Professional Practice Dr. Bob Weber CEG 460 / 660 Wright State University.
Fig. 1 An engineer's honesty and integrity provide a shield of protection to the public welfare and safety. In today's world of lawsuits and accounting.
MSRB Proposed Rules and Interpretations NALHFA 2011 Annual Educational Conference May 20, 2011.
ENGR-10_Lec-21_Chp15_Engineering_Ethics.ppt 1 Bruce Mayer, PE Engineering-10: Intro to Engineering Engineering 10 Chp.15 Engineering.
BELMONT UNIVERSITY AMERICAN INN OF COURT SEPTEMBER 9, 2014 PRESENTED BY KRISANN HODGES DEPUTY CHIEF DISCIPLINARY COUNSEL - LITIGATION BOARD OF PROFESSIONAL.
The AMA Code of Ethics Could Egyptian Marketing Professionals Agree on a List of Rules, Perhaps Similar to This? The IMI Journal. Members of the AMA are.
1 Overview of Ethics Requirements for Employees of Montgomery County This is a summary to help identify issues; it is not the law. Please address ethics.
Introduction to the Ethics of Engineering Introduction to Mechanical Engineering The University of Texas-Pan American College of Science and Engineering.
Rules of Professional Responsibility. Scope w To establish and maintain a high standard of integrity, skills and practice in the profession. w To safeguard.
All questions are true or false
 Philosophy of scientific / engineering research. May 2005  Dr. Mehmet Bodur, Computer Engineering Dept. Eastern Mediterranean University  Place and.
The following code of ethics was adopted by the American Society of Civil Engineers on September 25, The code of ethics became effective on January.
Copyright © 2010 South-Western/Cengage Learning
National Contract Management Association – Norfolk Chapter Contracting Ground Rules.
Professional Ethics. McGraw-Hill/Irwin © 2004 The McGraw-Hill Companies, Inc., All Rights Reserved. 3-2 Steps in Resolving an Ethical Dilemma Identify.
Software Engineering Code Of Ethics And Professional Practice
Professional Ethics “Ethics are statements of moral principles and values that guide the action of auditors”. The independence, powers and responsibilities.
1 AAPL Meeting — March 17, 2015 Tina Grovier, Joe Perkins, and Ramona Monroe Stoel Rives LLP, Anchorage, AK AAPL Meeting — March 17, 2015 Ethical and Legal.
1 SPIRIT Silicon Prairie Initiative on Robotics in Information Technology Engineering Ethics.
Wayne County Bar Association August 15,  Rule 6.1 Voluntary Pro Bono Publico Service A lawyer should render public interest legal service. A.
Institute of Actuaries of India
Legal and Ethical Considerations for Member Leaders.
Class 11_1 Today: Engineering ethics: a short discussion followed by case study group work Handout: Engineering code of ethics (our technical drawing work.
Professional Ethics in Computing Dr. David Sinclair L253
Ethics and Engineering
S OFTWARE E NGINEERING C ODE O F E THICS A ND P ROFESSIONAL P RACTICE Software Engineering Ethics and Professional Practices © 1999 by the Institute of.
Engineering Ethics.
Ethics Jonathan J. Makela Based on material from P. Scott Carney, T. Galvin, J. P. Makela, and the National Ethics Center.
Conflict of Interest requirements in RFQ. What are some of the common Conflict of Interest Scenarios. How to find out about the conflict of Interest before.
 What is conflict of interest and how can it be avoided  What factors should be considered when determining a “ fair wage “
Mediator/Social Worker
Chapter 19: Ethical Responsibilities Chapter 19 Ethical Responsibilities.
11/24/20151 CVE 5074 Leading Construction Operations Team Leadership Part VII – Ethics & Quality.
CODE OF ETHICS by: eunice rudas__________________.
Engineering Ethics. Engineering Ethics ( II ) Wael. A. Moustafa MA.Sc., P.Eng. May 18, 2011 Mechanical Engineering Department Umm Al-Qura University.
Conflicts, Ethics and Commercial Reality Lynda Whitney.
Ethics—Standard of Professional Behavior Required to Ensure the Public Health, Safety, and Welfare NCEES Past President W. Gene Corley, Ph.D., P.E., S.E.,
1 The Nature of Ethics Ethics is generally concerned with rules or guidelines for morals and/or socially approved conduct Ethical standards generally apply.
Introduction to Procurement for Public Housing Authorities Unit 1A – Ethics and Conflicts of Interest in Procurement Activities Unit 1A.
Philippine Institute of Chemical Engineers Code of Ethics

Professional Engineering Practice
Professional Engineering Practice
Engineering Ethics Reading: pp. 374 – 395.
Engineering Design is an Iterative Process
Licensed Electrical & Mechanical Engineer
Ethics A brief overview.
CVE 4070 Construction Engineering Professional Ethics
Code of Engineering Ethics
I IEEE Code of Ethics Electrical and Computer Engineers
Ethics Program.
Engineering Design is an Iterative Process
Discussion not Lecture Ethics not Morals No person is perfect
CS-480b Network Security Dick Steflik
Presentation transcript:

1. Engineers shall not undertake technical assignments for which they are not qualified by education or experience." To do so would be "faking it." This would be unfair, since the quality of the work would be inferior. Engineer's Obligation to Employers/Clients By applying the codes of ethics, an engineer earns the trust and respect of his clients and employer.

2. Engineers shall approve or seal only those plans or designs that deal with subjects in which they are competent and which have been prepared under their direct control and supervision." To profess confidence in a project or product with which one is unfamiliar would be dishonest and potentially dangerous should any problems arise with that product 3. Engineers may coordinate an entire project provided that each design component is signed or sealed by the engineer responsible for that design component." This is an elaboration on the previous rule.

4. Engineers shall not reveal professional information without the prior consent of the employer or client except as authorized or required by law." Such "professional information" does not belong to the engineer, but rather to the client or employer. Thus, disclosure of this information would be like giving away something that does not belong to you. 5. Engineers shall not solicit or accept valuable considerations, financial or otherwise, directly or indirectly, from contractors, their agents, or other parties while performing work for employers or clients." This is commonly known as bribery or conflict of interest.

6. Engineers shall disclose to their employers or clients potential conflicts of interest or any other circumstances that could influence or appear to influence their professional judgment or the quality of their service." Both clients and employers have a right to know of these things. It is also in the best interest of the engineer's professional reputation to make these things known. 7. An engineer shall not accept financial or other compensation from more than one party for services rendered on one project unless the details are fully disclosed and agreed to by all parties concerned." This would be an obvious case of conflict of interest.

8. To avoid conflicts of interest, engineers shall not solicit or accept a professional contract from a governmental body on which a principal or officer of their firm serves as a member. An engineer who is a principal or employee of a private firm and who serves as a member of a governmental body shall not participate in decisions relating to the professional services solicited or provided by the firm to the governmental body." Another case of conflict of interest.