Cluster Angewandte Fernerkundung DLR Oberpfaffenhofen Figure 2 shows all sun mean reference spectra of GOME from July 1995 to June 2006 for four single wavelengths (290nm - channel 1, 330nm - channel 2, 430nm – channel 3, and 760nm - channel 4). Black curves denote uncorrected data. The low periodic variation is due to the seasonality of the sun-earth distance, which is maximum in July and minimum in January. Large peaks in the time series for all wavelengths at the beginning of 2001 are due to severe problems with the ERS-2 spacecraft. They can be directly assigned to data gaps and GOME anomalies, such as instrument switchoffs, as regularly documented in the GOME yearly anomaly reports (see Besides the large peaks, several small peaks can be identified in the curves, which occur for different wavelengths at different dates. They can be explained with etalon structures. The red curves denote the sun mean reference data which are first corrected for the etalon effect Secondly, all spectra are normalised to 1 A.U. (Astronomical Unit) in order to remove the seasonal dependence. Finally, they are normalised to the intensity of the reference spectrum from 3rd July 1995 to calculate the percentage decrease. The intensity decreased by 80% at 290nm and by 60% at 330nm until June The drecease in channel 3 (430 nm) started in 2001 and reaches now 40%. In channel 4 at 760nm only minor changes are observed. A slight decrease of 10% from 1995 to 2001, and then a short increase of 5% until The corresponding time series for the three PMD signals are depicted in Fig. 3. The degradation of the PMD signals show almost the same behaviour as for the corresponding wavelengths. Wavelength Calibration In the framework of the ESA-project ’Long-Term Monitoring of GOME Calibration Parameters’ several spectral emission lines of the PtCrNe hollow cathode lamp were identified to be improper for an exact wavelength calibration, and therefore have been removed from the analysis. The lines did not meet the well- defined statistical criteria for all available lamp measurements. Figure 5 shows the standard deviation of the wavelengths of all emission lines for all available calibration orbits between June 1995 and May 2003 for the old and the new calibration analysis. Largest changes can be found at the beginning of channel 3, where three lines were excluded, and at the end of channel 4 around 760 nm, where the very unstable last line has been removed. The noise of the new wavelengths is much smaller compared to the old calibration, except in channel 2, where only one line has been excluded. Monitoring of the GOME/ERS-2 Inflight Calibration Parameters from GDP-4 Reprocessing M. Coldewey-Egbers, S. Slijkhuis, B. Aberle, D. Loyola The so-called Q-factors are defined as relative correction factors that transform the measured signal with fractional polarisation to an unpolarised signal (see GOME, 2000). Figure 4 shows the time series of all three Q-factors from June 1995 to June The strong decrease of Q-factor 1 is connected to the different degradation of the PMD 1 signal and the measured signal in channel 2. The PMD decreases faster compared to the channel up to the year 1999 and then from 2001 to 2006 the channel signal decreases faster. Q-factor 2 increases slowly from 1995 to 2006, that means the PMD signal is larger than the corresponding channel, while the channel decreases faster, respectively (see also Figs. 2 and 3). Q-factor 3 is more or less stable (0.15 to 0.2) over the entire period. Measurements carried out during the calibration of the GOME FM have shown that all three PMDs are sensitive to light above 790 nm. Early in-flight solar data showed that straylight appears to be worst in PMD 3 (13%), that explains the initial non-zero Q-factor 3. The irregular large peaks and outliers are due to GOME anomalies such as cooler switch-offs, instrument or satellite switch-offs, on-board anomalies, or special operations. References [1] GOME: Level 0 to 1 Algorithms Descriptions, Techn. Rep., DLR, ER-TN-DLR-GO-0022, Figure 4: GOME Q-Factors for each PMD from June 1995 to June Q-factors: Outliers and peaks due to cooler switch-offs, instrument and satellite switch-offs, and special operations. Decrease and increase due to different degradation of PMD and corresponding channel signal. Figure 1: Ratio of the sun mean reference spectra from 9th January 1997 to 2006 to the corresponding reference spectrum of Grey shaded areas mark features caused by the dichroic filter, which separates channels 3 and 4. Intensity decrease: 90% at 240 nm and 50% at 325 nm Blickrichtung Influence of the South Atlantic Anomaly on the Leakage Current The four GOME detectors are random access linear photodiode arrays. One characteristic of these devices is a certain amount of leakage current produced by thermal leakage. The leakage current is monitored by periodically taken dark-side measurements. The South Atlantic Anomaly (SAA) is a region with intense radiation in space near the Earth that causes damage to many spacecrafts in low Earth orbit. The GOME measurements are affected by high-energy protons leading to large data spikes. For this study, all GOME orbits crossing the SAA region during night time have been separated. Figure 7 shows the leakage current in channel 4 for an integration time of 30 seconds for 10 consecutive orbits in The third and fourth orbit from top crossed the SAA. Data are much noisier and contain large spikes. Figure 8 shows the noise of the leakage current measurements for 30s integration time and the year The noise level inside the SAA increases by a factor of two compared to the noise outside the SAA region. The leakage current itself is slightly larger inside the SAA than outside the SAA (without figure), that is due to the expected spikes on individual detector pixels. Calculation of the dark signal using these measurements from inside the SAA may yield to a slight overestimation of the leakage, and therefore to an underestimation of the real signal. The same analysis for the year 2000 and the other time patterns confirms these results. The influence of the SAA on the darkcurrent and its noise level is largest for the long integration times (e.g. 30 and 60 s). It becomes smaller for the shorter ones of 1.5 s. Figure 7: Leakage current in channel 4 for 30s integration time and 10 consecutive orbits from rd and 4th orbit from top cross the SAA region. Wavelength calibration: Wavelengths are more stable now using GDP-4. In channels 3 and 4, wavelengths correlate with the temperature measured at the predisperser prism. Figure 2: Sun mean reference intensity for four different wavelengths (from top to bottom: 290 nm, 325 nm, 502 nm, and 639 nm) from June 1995 to June Red curves are corrected for etalon structures and for 1A.U. Sun mean reference intensity and PMD signals: Large outliers and anomalies in 2001 can be explained with GOME switch-offs. Low periodic variation is due to the seasonality of the sun-earth distance. Introduction In 2006 an update of the GOME Level-0-1 processor (GDP-4) has been developed in order to reprocess the entire data set. The main driver for this updated version was the new sun mean reference spectrum intensity check, and the associated closing of the time gaps between sun mean reference spectrum updates on the Level 1b product. This opportunity has been used to include other algorithm developments such as an extension of the GOME on-fly calibration parameter database, and a slightly modified spectral calibration. For the first time a fully homogeneous dataset is available that is used to monitor the instrument performance and stability over its lifetime from 1995 to Sun Mean Reference Spectra, PMD Signals and Q-factors Instrument degradation as well as the ERS-2 pointing problem since 2002 lead to a strong decrease in the measured intensity of GOME spectral channels 1 and 2. Figure 1 shows the ratio of the sun mean reference spectra from 1997 to 2006 to the corresponding reference spectrum from 9th January The intensity in channel 1 is reduced by more than 90%. In channel 2 the decrease is still 40-50%, and in channel 3 it is 0- 40%. Figure 3: PMD Signals from June 1995 to June Figure 5: Standard deviation of the wavelengths of all emission lines for the old (open circles) and the new (red dots) calibration. Filled black dots denote the lines that were removed from the analysis. One of the key elements in the optical system of GOME is the quartz predisperser prism. The refractive index of quartz depends not only on the wavelength of the light passing through it but also on the temperature of the prism. It is expected, that the temperature increases along an orbit, partly due to warming by the sun and partly because light passes through the instrument. Those temperature changes may affect the lamp measurements and therefore the wavelength calibration. Figure 6 shows a correlation between one single wavelength ( nm) and the temperature. However, this correlation is not existing in channels 1 and 2. It is strongest in channels 3 and at the end of channel 4. Figure 6: One single wavelength ( nm, black curve) and temperature at the predisperser prism (red curve) as a function of time. Leakage Current and South Atlantic Anomaly: Leakage current measurements are noisier and contain large data spikes. Figure 8: Leakage current noise inside (red) and outside (black) the SAA region for the year 1997.