Connect To Success Selection & Proper Installation of Coax Connectors.

Slides:

Advertisements

Similar presentations

Spring Terminal Technology

Advertisements

1 National Urban Search & Rescue Response System Communications Specialist Course Communications Specialist Course Skill 3 Unit 2: RF Cables and Meters.

About ICM ICM Corporation is the global manufacturer of our patented 360° radial compression technology in both connectors and tools. Our F-Conn connectors.

Corning Cabelcon 1. 2 To begin with – we need some tools… Cable cutter Cabelcon Rotary Stripper Mounting tool Compression tool Please read the instructions.

How to install a PL-259 My Way! by Steve, N1NXU. Start with a clean cut. Notice how the top cable end is a nice clean round cut. It was cut with a cable.

New Mexico FFA Agricultural Mechanics Career Development Event Electric Power.

Assembly / Disassembly / Reassembly Computers. Chapter Objectives After completing this chapter you will: Understand how static electricity can damage.

PNI Connector Purpose: To introduce the PNI wire-to-board and wire-to-wire, crimp style connector from JST. Objectives: Illustrate the intended application.

Copyright 2008 Kenneth M. Chipps Ph.D. How to Terminate a Corning Unicam Connector Last Update

Impedance : 50 ohms Bodies : Brass, Gold Plating Center Contact : Brass or Beryllium Copper Insulator : Teflon Frequency Rang : 0 to 4 GHz MB5111 SMB Female.

Electronics. Solid snap together electronic connectors.

Connectors Connectors are a major cause of equipment failure. Pins are wired incorrectly, bare wires touch and short circuit or connector pins are accidently.

Corning Cabelcon 1. 2 To begin with – we need some tools… Cable cutter Cabelcon RG11 Rotary Stripper Mounting tools Compression tool Please read the instructions.

Radio Frequency in Buildings. Introduction 2 Acome offers all passive components for mobile communication in buildings networks Surge arrestors Connectors.

Times Microwave Systems LMR ® Wireless Products Seminar.

GVH Connector Purpose: To introduce the GVH wire-to-board, crimp style connector from JST. Objectives: Illustrate the intended application. Discuss the.

Cellular telecom networks. Coaxial Antenna Line 2 Introduction Waterproofing kits HYPERCELL ® Products offer all passive components between BTS and antennas.

A 2 element 6 Meter Quad Made from PVC pipe and capable

EET Survey of Electronics Chapter 6 – Electric Connections.

CMS WeekDec 2002E. Hazen HF Electronics Status Report E. Hazen, J. Rohlf, E. Machado Boston University.

ESTeem Training Class Antenna Fundamentals. Decibels (dB) Used for all mathematical calculations in the radio world. – dB is a logarithmic number dB =10.

1 Telecom Cabling CATV systems and coax cable. 2 Telecom Cabling Community antenna TV is covered in the NEC article 820, and is covered in a limited capacity.

5-15. Connect To Success Selection & Proper Installation of Coax Connectors.

1 Cable modems Cable modems BASIC TELECOMMUNICATIONS.

5-15. UTP Cables/Connectors/Devices for use on New Technology Analog and IP Systems.

Router. Switch Repeater Cable is the medium through which information usually moves from one network device to another. It used to connect one network.

Choosing the Right Coax by Marty Woll N6VI ARES-Los Angeles Amateur Radio... when all else fails.

The physical network Unit objective: Identify network cables and connectors, and use networking tools.

PL, & Power Pole Crimp Connectors. A Unique Approach.

End Fed Antennas End Fed Long Wires

RF Signal Cables W. Udo Schröder, 2011 Principles Meas/Electronics 2 RG59/U coaxial cable (BNC) Stiffer than RG58 75 Ohm impedance Dual shielded cable:

Basic (VHF) Radio Communications

1 CCTV SYSTEMS CCTV cables. 2 CCTV SYSTEMS Cable selection is a very important consideration in the performance of a CCTV system, especially where long.

Coax Connector Installation by Marty Woll N6VI ARES-Los Angeles Amateur Radio... when all else fails © 2010 N6VI.

Lecture 8 Cable Certification & Testing:. Cable Distribution Cable Distribution Equipment UTP (Unshielded Twisted Pair) UTP Cable Termination Tools UTP.

General Licensing Class Coax Cable Your organization and dates here.

CRIMPING TOOLS. CONTENTS INTRODUCTION EXAMPLES CABLE TIE TOOLS RJ45 CRIMP TOOLS HAND CRIMP TOOLS.

WeldFit Push-in Fittings

Experts in Chem-Feed and Water Treatment Old style ORP and pH sensors. The exposed red sensor is an ORP sensor. This connecter predates the connector to.

Connectors & Cables © D. J. McMahon rev

Operating procedure for POF cables Comoss Electronic Co., Ltd. Date : May-05, 2008.

Automotive Heating and Air Conditioning, Fifth Edition By Tom Birch © 2010 Pearson Higher Education, Inc. Pearson Prentice Hall - Upper Saddle River, NJ.

1 “BUILDING QUICK TAPE ANTENNAS” Dr. Al Torres KP4AQI FEBRUARY 2015.

COMPUTER NETWORKS CS610 Lecture-11 Hammad Khalid Khan.

Sentek Technologies Joining EnviroSCAN Probes. Probe Components 20-way probe cable connector (special order) Cable spacer (Part No 80015) Probe rods Probe.

Automotive Heating and Air Conditioning CHAPTER Automotive Heating and Air Conditioning, 7e James D. Halderman | Tom Birch SEVENTH EDITION Copyright ©

Use Legacy Cable On ALL CCTV Installs Cables/Connectors/Devices for use on New Technology HD-1080p and IP Systems.

Audio Video Production

Doble Power Factor Bushing Test

Coaxial Cable Copper-BASED SYSTEM Module 6

A TECHNICAL BRIEFING FOR AMATEUR RADIO OPERATORS

CONNECTORS 101.

INSTALLATION GUIDE FOR CRIMP CONNECTORS

BNC Female Bulkhead connector

Soldering process 1 Add the soldering material on the soldering pad of speaker in order to solder the wire on the speaker.

Most Effective Methods to Replace a Brake Light Switch.

All you Need to Know About the Wiring Harness

Coax Connector 3 Piece Connector Assembly Gerry Crenshaw WD4BIS www

A 2 Meter 2 Element Collinear Antenna

JFPS Connector Purpose: Objectives: Content:

Presented by: Richard Hathcoat & Alexander Millan

REFLECTION AND TRANSMISSION II

Coaxial Cables & Connectors

Installation guide for RG6/59 compression connectors

A. To reduce television interference B. To reduce signal loss

Installation guide for CX3 RG 7/11 compression connectors

Installing Coax and Network Connectors

Presentation transcript:

Connect To Success

Selection & Proper Installation of Coax Connectors

A CONNECTOR is an extension of the coax cable and provides a means to connect the cable to an electronic device at the cable termination side …

Impedance 50 Ohm BNC 75 Ohm BNC

Twist-On GEM Part # 302-4TP

Cable’s vary from.195OD to.245OD.245 OD..195 OD

¼” 9/16” Twist-On GEM Part # 302-4TP

Twist-On GEM Part # 302-4TP

Universal Crimp-On GEM Part Number TP

Universal Crimp-On GEM Part Number TP Not Vulnerable to Fluctuating Cable O.D.’s

Universal Crimp-On GEM Part Number TP RG6 PVC RG59 PVC RG6 Plenum RG58 PVC RG59 Plenum

Universal Crimp-On GEM Part Number TP

Universal Crimp-On GEM Part Number TP 7/16”

Crimp Ferrule Universal Crimp-On GEM Part Number TP Fold Braid 1/16” 1/4”

Universal Crimp-On GEM Part Number TP

Universal Crimp-On GEM Part Number TP.320 Hex Cable Support Hex Choices for Cable Support :.264 RG6 PVC,.250 RG59 PVC, RG6 TFE,.212 RG59 TFE, RG58 PVC

Crimp-Crimp GEM Part Number 305-4TP

Crimp-Crimp GEM Part Number 305-4TP Used for Higher Frequency Applications above 2 GHz Center Contact more closely matched to Center Contact of cable

Crimp-Crimp GEM Part Number 305-4TP Crimped or soldered contact provide Lower VSWR up to 4 GHz

Crimp-Crimp GEM Part Number 305-4TP Use 75 OHM Connector For High Frequency Systems above 1.2 GHz

Crimp-Crimp GEM Part Number 305-4TP 19/32” 5/16” 3/16” 3/32”

Crimp-Crimp GEM Part Number 305-4TP Dialectric Support Bushing

Crimp-Crimp GEM Part Number 305-4TP

Crimp-Crimp GEM Part Number 305-4TP

Crimp-Crimp GEM Part Number 305-4TP

Uni-Crimp GEM Part Number TP

Uni-Crimp GEM Part Number TP Cost Effective Compression Seal Type Connector

Uni-Crimp GEM Part Number TP Internal Cone Design Identical to the Compression Seal

Uni-Crimp GEM Part Number TP.320 HEX

Uni-Crimp GEM Part Number TP

Uni-Crimp GEM Part Number TP Cone Slides Between Dielectric and Inner Braid

Uni-Crimp GEM Part Number TP

Uni-Crimp GEM Part Number TP 1/4”

Uni-Crimp GEM Part Number TP 3/4”

Uni-Crimp GEM Part Number TP

Uni-Crimp GEM Part Number TP BENEFITS include EASY ASSEMBLY and SIMILAR PERFORMANCE AS COMPRESSION but at LOWER COST

Compression GEM Part Number 302-N2CSTP

Compression GEM Part Number 302-N2CSTP Accepts RG 59 Cable Range of

Compression GEM Part Number 302-N2CSTP Completely Captures Inside Components

Compression GEM Part Number 302-N2CSTP Mechanical Superiority Over Other Connector Styles

Compression Seal Will Not Pull Off EVER ! O Ring Prevents Water Wicking Up the Cable

F Connectors Are Completely Waterproof

1 Assembly Procedure 1 Crimp Tool for F RCA and BNC Connectors And…will terminate the following cables: RG59 PVC, RG59 Plenum, RG6 PVC, RG6 Plenum, RG6 Dual/Tri/Quad, RG6 Quad Plenum Hand Tool GET-CS

NO CONNECTOR FAILURES EVER!

Compression GEM Part Number 302-N2CSTP 1/4”

Compression GEM Part Number 302-N2CSTP Fold Back Braid Mark Cable 1-1/8”

Compression GEM Part Number 302-N2CSTP Mark Cable

Compression GEM Part Number 302-N2CSTP BNC Die Head

Compression GEM Part Number 302-N2CSTP

Compression GEM Part Number 302-N2CSTP

Electrical Mechanical Cost Summary