Modeling Seismic Response for Highway Bridges in the St. Louis Area for Magnitude 6.0 to 6.8 Earthquakes J. David Rogers and Deniz Karadeniz Department of Geological Sciences and Engineering University of Missouri - Rolla ABSTRACT Two highway bridges spanning the Missouri River flood plain were selected for evaluation of seismic site response for the most probable earthquakes we can expect to see in the near future emanating from the three principal sources in the Midwest: the New Madrid Seismic Zone; Wabash Valley Seismic Zone; and Southern Illinois Seismic Zone. This study focused on the expected range of earthquakes magnitudes: M 6.0, 6.3, 6.5 and 6.8. These have a 25 to 40% probability of occurring over the next 50 years. Most previous efforts have focused on M 7 to 7.6 quakes, such as occurred in The quakes only have a 7 to 10% probability of occurrence in the next 50 years. Our results suggest site amplification between 550% and 950%, depending on earthquake magnitude and epicentral distance. Our study suggests that the threshold magnitude for significant foundation failure and structural damage to Missouri River bridges is between M 6.4 and 6.6. Above these magnitudes widespread liquefaction is predicted, which would dampen ground acceleration, but would sever foundation elements, such as piles or caissons. Site amplification could be expected where the site period is > 1.0 second (s). Therefore, M 6.5+ earthquakes at ranges 110–260 km could cause severe damage to structures 10 to 25 stories high founded on channel deposits with > 30 to 46 m of unconsolidated sediment. Map at left shows the location of bridges studied, locations of modeled earthquakes, and the outlines of the three seismic zones in the Midwestern USA. Black dots represent the major historic earthquakes that have occurred in the region. Map at right shows the three recognized source zones for historic seismicity in the Midwestern United States. Seismic Source Zone Creve Coeur BridgeHermann Bridge Site South Central Illinois110 km195 km Wabash Valley Seismic Z.195 km275 km New Madrid Seismic Z.210 km260 km The geology of the Missouri River floodplain is typified by bedrock bluffs and channel floors developed in dense Paleozoic limestone and dolomite, covered by glacial windblown silt (loess). The channel flood plain is filled with young unconsolidated sands and silt. The upper 2 to 4 meters of the flood plain are usually covered with recent lake sediments and overbank floodplain silts and clays. The thickness of the channel fill varies between 30 and 60 m. Creve Coeur Bridge

Earthquake source and wave propagation were characterized using SMSIM code of Boore (1993), from the US Geological Survey. Site Response is characterized using DEEPSOIL v.2.5, from the Univ. of Illinois. The site response at the ground surface is markedly different from the base rock input motion and site response increases as the magnitude increases: Rock Acceleration Surface Acceleration Hermann Bridge Response Spectra Rock/Surface Peak Accelerations

CONCLUSIONS 1. Preliminary results indicate that the bridges we analyzed would be subjected to long period motions, which may pose a significant threat to simply-supported tail spans founded on friction piles. 2. Large amplifications can be expected at both bridge sites. Amplification of the ground motion is in the range of 550% to 950%. 3. Similar site amplification was predicted for earthquakes at distances of 110 to 210 km, because there is only slight attenuation of seismic energy in the stiff Paleozoic bedrock. 4. Widespread liquefaction is predicted at the Creve Coeur Bridge site for ≥ M 6.8 event, but only localized liquefaction for M 6.3-M 6.7 events. 5. The screening analysis did not predict any liquefaction at the Hermann Bridge site Soil softening (liquefaction) may cause a decrease in response spectra values for periods < 1 sec. 7. However, soil softening may cause an increase in response spectra values for periods >1 sec. Amplification of Ground Response Site amplification is the ratio of the response spectra of a soil site to the response spectra of the bedrock beneath that site. Earthquake energy can be amplified because: Resonance within the soil column overlying much stiffer basement rocks Impedance Ratio between the rigid basement rock and the unconsolidated soils lying over them Conservation of energy of the incoming seismic wave train (e.g. wave energy arriving at a much higher rate than can be propagated through the soft soil cover) Liquefaction Potential Screening Analysis Liquefaction (“quicksand”) can affect: 1.Surface Accelerations 2.Spectral Accelerations