ADSP-BF533 EZ-Kit Lite (USB Connection) Installation
Pre-Installation Connect the ADSP-BF533 board to the PC using a USB data cable Connect the ADSP-BF533 board to the PC using a USB data cable Power up the board by connecting the AC adapter Power up the board by connecting the AC adapter Remember the ADSP-BF533 is a 16-bit processor, make sure to use VisualDSP++ for 16-bit processors Remember the ADSP-BF533 is a 16-bit processor, make sure to use VisualDSP++ for 16-bit processors
USB auto detect
Start VisualDSP++ Environment IMPORTANT NOTE: Hold Down Control (CTRL) on the keyboard
Select EZ-KIT Lite (ADSP-BFxxx) under Debug Target, then select ADSP-BF533 as the processor. Change the Session name if needed, then press OK
VisualDSP++ started. If there is an error box, check all connections and try again.