UVIC cloud chamber DEC, Mechanical questions Reply to: Mark Lenckowski General drawing notes: * Red tubing – discharge * Purple tube – suction and/or evaporator * Yellow tube – oil line to compressor * Orange tube – discharge (separator to heat exchanger) * Hi temp stage – R134A (approx 10oz) * Low temp stage – R508 (approx PSIG) * All access ports will have caps (not drawn)

Cloud chamber mechanical (iso) Cold stage evaporator

Cloud chamber mechanical (front) Heat exchanger Cold stage refrigeration Approx 32” Warm stage refrigeration

Cloud chamber mechanical (left) Access ports Cold stage Access ports Warm stage

Warm stage circuit (iso)

Warm stage circuit (front) DISCHARGE: (red) ¼” tube X 52” long Q3: is two loops sufficient for vibration control? SUCTION: (purple) 3/8” tube X 92” long Q1: is two loops OK for vibration control? Q2: is 5/16” tube an option?

Warm stage circuit (left) Schrader access valve SAE ¼” flare (discharge side) Q4: Is this style of valve OK on the discharge circuit? Shut-off/access valve (packed) with SAE 3/8” flare port. Henry 7763-B valve or equivalent. Q7: Is this an acceptable style of valve? Q8: Is this location acceptable?.042” capillary tube 90” long This feature is copied from pictures of Scientemp equipment. Q5: Is it an expansion chamber or Filter dryer? Q6: If a filter dryer, is 100 mesh size to be used? Filter dryer to keep capillary tube clear (drawn as 1” X 6” size) Q9: Is 100 mesh size good to use? Q10: Is the size (volume) acceptable Q11: does filter dryer need to be vertical or is about 30deg OK?

Warm stage circuit (right)

Cold stage circuit (iso) Evaporator cold stage * 5/16” tube X 230”long * 22” OD X 2” pitch spiral coil Q12: Is 3/8” tube too big?

Cold stage circuit (front) Evaporator cold stage 5/16” tube Suction: 3/8” tube X 69” long Discharge: ¼” tube X 35” long Q14: is two full loops OK for vibration control? Suction: Q13: is two loops OK for vibration control? Oil return: ¼” tube X 23” long Discharge: ¼” X 16” long

Cold stage circuit (left) Schrader access valve SAE ¼” flare (discharge side) Q18: Is this style of valve OK on the discharge circuit? Capillary tube:.036” X 90” long Shut-off/access valve (packed) with SAE 3/8” flare port. Henry 7763-B valve or equivalent. Q19: Is this an acceptable style of valve? Q20: Is this location acceptable? Filter dryer (drawn as 1” X 6” size) Q15: Is 100 mesh size good to use here? Q16: Is the size (volume) acceptable? Q17: does filter dryer need to be vertical or is about 30deg OK?

Cold stage circuit (right)