P10551: Nano-Ink Deposition System Members: Eric Hettler (ME) William Gallagher (ISE) Chris Mieney (ME) Gregory Ryan (ME) and Joseph Cole (EE) Faculty Guide: Dr. Denis Cormier Motivation: Deposition of multiple material compositions in various quantities can permit a part to be printed with varying material grades across a layer and varying between layers. Project Description: Modify an existing deposition system to mix materials and deposit layer by layer on the print surface. A UV curable resin has been dyed to serve as a medium to demonstrate the printing of multiple materials. For more information visit: System Architecture Platform Print Carriage Modification Concept Selection Mixer Pre-Colored Epoxy Reservoirs Deposition Mixing Process Commercial 3d Printers are expensive and are designed for one type of material. is a complete open source system, where all design, program and operation information is available to the public. The mission is to promote affordable technology where the user can develop their own ideas and make it happen. originated at Cornell University, and has been used by research organizations globally. Multiple Concepts for mixing and deposition were developed: 1.) Inject individual color into stream of clear material 2.) Mix pre-colored material 3.) Premix dye and inject into stream of clear material Curing Concepts 1.) Laser 2.) LEDs 3.) Halogen Bulbs 4.) Florescent UV Bulbs The selected concepts were chosen due to cost constraints, predicted performance, and alignment with mission to allow others to replicate. UV Curable Resin WaterShed® XC Commonly used for sterolithography -Looks like acrylic -Feels like ABS -Designed for Solid State Laser Acknowledgements: Dr. Denis Cormier Gerry Garavuso RIT Brinkman Lab Results and Conclusions: Functionality: -Final system successfully combines and prints multiple materials, although color mixing could use some improvement. Future work and recommendations: -Develop a more robust control system within the architecture. -Construct a dynamic mixing manifold to ensure thorough mixing. -Utilizes open source software -Motion Control was analyzed and proven sufficient Testing: PropertyAverageStDev Layer height (mm).24 Layer Cure Time (sec)240 -Various print settings were tested to evaluate the properties of the system. With modification of these settings, deposition rate can be controlled. -Testing consisted of mixed material deposition and multiple layer deposition. -Curing time was measured as the time to cure until the next layer can then be printed. -Layer thickness was measured, however the outline size was difficult to assess. -Mixing manifold designed to accommodate various geometry patterns as needed. -Luer taper fits on end to accommodate various nozzle sizes -Three Lee Micro valves are attached to manifold to control fluid dispensing Material Reservoirs Curing Bulb Mount Mixer/Manifold Curing Micro valve -6 Watt T5 blacklight bulbs – peak output of 352 nm -Standard, widely available lighting fixtures -Simple construction, requires only minimal modification to existing system -Attaches to existing carriage Various colors printed