Magnet quench during a training run Magnet electrical circuit schematic PROGRESS ON THE MODELING AND MODIFICATION OF THE MICE SUPERCONDUCTING SPECTROMETER.

Slides:

Advertisements

Similar presentations

Spectrometer Solenoid Update Steve Virostek - LBNL MICE VC 150 August 23, 2012.

Advertisements

MICE RF and Coupling Coil Module Outstanding Issues Steve Virostek Lawrence Berkeley National Laboratory MICE Collaboration Meeting October 26, 2004.

MICE Superconducting Solenoids: Status and Update RAL: T W Bradshaw M Courthold J Rochford M Hills D Baynham Oxford: J Cobb W Lau S Yang MICE.

CM-18 June The Measurement and Monitoring of the Field from the MICE Magnets Michael A Green Lawrence Berkeley Laboratory, Berkeley, USA Frank Filthaut.

MUTAC Review, 9 April MuCOOL and MICE Coupling Magnet Status Michael A. Green Lawrence Berkeley Laboratory Berkeley CA

Trip Report on the visit to ICST of HIT, Harbin, China Derun Li Mike Green Steve Virostek Mike Zisman Lawrence Berkeley National Laboratory (from December.

Spectrometer Solenoid Update Steve Virostek Lawrence Berkeley National Lab MICE Video Conference 114 September 18, 2008.

Progress on the MICE Cooling Channel Solenoid Magnet System

Changing the absorbers: how does it fit in the MICE experimental programme? Besides the requirement that the amount of multiple scattering material be.

Spectrometer Solenoid Design and Procurement Review Steve Virostek Mike Green Mike Zisman Lawrence Berkeley National Lab MICE Collaboration Meeting October.

23 October 2005MICE Meeting at RAL1 MICE Tracker Magnets, 4 K Coolers, and Magnet Coupling during a Quench Michael A. Green Lawrence Berkeley Laboratory.

1 MICE Mtg Oct 2002 Elwyn Baynham RAL Focussing Absorber Magnet Elwyn Baynham ; Tom Bradshaw Iouri Ivaniouchenkov ; Jim Rochford Applied Science Division.

1 Issues concerning the Design of the Tracker Solenoids Michael A. Green Lawrence Berkeley National Laboratory 17 August 2005.

1 Spectrometer Solenoid Design and Cost Update Michael A. Green Lawrence Berkeley Laboratory 10 February 2005.

MICE RF Module Safety Steve Virostek Lawrence Berkeley National Laboratory MICE Collaboration Meeting February 12, 2005.

Tracker Solenoid Module Design Update Steve VirostekStephanie Yang Mike GreenWing Lau Lawrence Berkeley National LabOxford Physics MICE Collaboration Meeting.

10 October 2006 MICE CM-16 at RAL 1 Distributed versus Lumped Coupling Magnets Michael A. Green and Soren Prestemon Lawrence Berkeley Laboratory, Berkeley.

Spectrometer Solenoid Fabrication Update Steve Virostek Lawrence Berkeley National Lab MICE CM23 at ICST, Harbin January 14, 2009.

Spectrometer Solenoid Update Steve Virostek - LBNL MICE Video Conference #129 February 25, 2010.

9 June 2006MICE CM-15 Fermilab1 Progress on the MICE Cooling Channel and Tracker Magnets since CM-14 Michael A. Green Lawrence Berkeley Laboratory.

1 The Genoa Tracker Solenoids and their Contribution toward a New Design Michael A. Green Lawrence Berkeley National Laboratory and Pasquale Fabbricatore.

1 Quench Protection and the Power Supplies for the MICE Focusing and Coupling Magnets Michael A Green Lawrence Berkley Laboratory 10 February 2005.

1 Superconducting Magnets for the MICE Channel Michael A. Green Oxford University Physics Department Oxford OX1-3RH, UK.

Spectrometer Solenoid Update Steve Virostek - LBNL MICE Video Conference #145 December 15, 2011.

Spectrometer Solenoid Fabrication & Testing Update Steve Virostek Lawrence Berkeley National Lab MICE CM24 at RAL June 1, 2009.

MICE Spectrometer Solenoid Design and Fabrication Update Mike Green and Steve Virostek Lawrence Berkeley National Laboratory MICE Video Conference December.

12 March 2006NFMCC Meeting, IIT, Chicago1 Progress on the MICE Cooling Channel and Tracker Magnets Michael A. Green Lawrence Berkeley Laboratory.

CM-18 June Magnet Conductor Parameters and How They affect Conductor Selection for MICE Magnets Michael Green Lawrence Berkeley Laboratory Berkeley.

1 Progress on the MICE Cooling Channel Magnets Michael A. Green Lawrence Berkeley National Laboratory 28 June 2005.

Spectrometer Solenoid Tech Board Schedule Discussion

MICE Spectrometer Solenoid Update Michael S. Zisman Center for Beam Physics Accelerator & Fusion Research Division Lawrence Berkeley National Laboratory.

Spectrometer Solenoid and RFCC Update Michael S. Zisman Center for Beam Physics Accelerator & Fusion Research Division Lawrence Berkeley National Laboratory.

Spectrometer Solenoid Fabrication & Testing Update Steve Virostek Lawrence Berkeley National Lab MICE Collaboration Meeting #26 University of California.

MICE Magnets - Virostek 11 MICE Magnets Steve Virostek Engineering Division Accelerator & Fusion Research Division Lawrence Berkeley National Laboratory.

RF Cavity / Coupling Coil Module

Progress on the MuCool and MICE Coupling Coils * L. Wang a, X. K Liu a, F. Y. Xu a, A. B. Chen a, H. Pan a, H. Wu a, X. L. Guo a, S. X Zheng a, D. Summers.

Spectrometer Solenoid Update Steve Virostek Lawrence Berkeley National Lab Roy Preece Rutherford Appleton Lab October 28, 2011 MICE Collaboration Meeting.

Emittance measurement: ID muons with time-of-flight Measure x,y and t at TOF0, TOF1 Use momentum-dependent transfer matrices iteratively to determine trace.

Status and Integration of the Spectrometer Solenoid Magnets Steve Virostek Lawrence Berkeley National Lab MICE RAL June 15, 2007.

Emittance measurement: ID muons with time-of-flight Measure x,y and t at TOF0, TOF1 Use momentum-dependent transfer matrices to map  path Assume straight.

Magnet quench during a training run Successfully trained to peak currents and operationally tested Thermal performance requirements met 3D magnetic bore.

The status of the construction of MICE Step IV K. Long, on behalf of the MICE collaboration.

Spectrometer Solenoid Test Plan Workshop: Spectrometer Solenoid Overview Steve Virostek - LBNL February 17, 2012.

ICHEP 2012 Melbourne, 7 July 2012 Paul Soler on behalf of the MICE Collaboration The MICE Beam Line Instrumentation (Trackers and PID) for precise Emittance.

Some Thoughts on Magnetic Measurements for MICE Michael A. Green Lawrence Berkeley Laboratory Berkeley CA 94720, USA.

Spectrometer Solenoid: Plans to Fix Magnet 2 Steve Virostek Lawrence Berkeley National Lab Spectrometer Solenoid Review November 18, 2009.

Abstract: The Muon Ionization Cooling Experiment (MICE) is an international effort sited at Rutherford Appleton Laboratory, which will demonstrate ionization.

Spectrometer Solenoid Fabrication & Testing Update Steve Virostek Lawrence Berkeley National Lab MICE CM25 at RAL November 6, 2009.

Spectrometer Solenoid Fabrication Status and Schedule Steve Virostek Lawrence Berkeley National Lab MICE RAL October 20, 2008.

MICE Cooling Channel Magnets: Spectrometer Solenoid Procurement RF Module Coupling Coil Proposal Steve Virostek Lawrence Berkeley National Lab NFMCC 07.

Magnet vacuum vessel w/radiation shield and cold mass in place Magnet leads (left) and the three cryocoolers on the top of the spectrometer solenoid service.

Spectrometer Solenoid Update Steve Virostek Lawrence Berkeley National Lab MICE Collaboration Meeting #28 Sofia, Bulgaria.

Spectrometer Solenoid – Quench Analysis The LBNL version of the quench model has been further refined - Heng Pan is finishing various quench scenarios.

MICE Coupling Coil Testing at Fermilab All Experimenters Meeting Ruben Carcagno March 19, R. Carcagno - MICE CC Testing at Fermilab3/19/2012.

Spectrometer Solenoid Fabrication Status and Schedule RF Cavity / Coupling Coil Module Plan and Progress Steve Virostek Lawrence Berkeley National Lab.

Spectrometer Solenoid Fabrication Update Steve Virostek Lawrence Berkeley National Lab NFMCC at LBNL January 25, 2009.

22 October 2005MICE Meeting at RAL1 Tracker Solenoid Overview Michael A. Green Lawrence Berkeley Laboratory MICE Collaboration Meeting 22 October 2005.

MICE Prototype Coupling Coil Fabrication Update Allan DeMello Lawrence Berkeley National Laboratory MICE CM38 - Napa California February 25, 2014 February.

Progress on MICE RFCC Module for the MICE Experiment * Allan DeMello, Nord Andresen, Michael Green, Derun Li, Heng Pan, Steve Virostek, Michael Zisman.

-1- Steve Virostek (LBNL) and Li Wang (SINAP) Instrumentation for the MICE Coupling Coil Steve Virostek Lawrence Berkeley National Lab February.

MICE Spectrometer Solenoid Recovery Review - December 3-4, Steve Virostek MICE Spectrometer Solenoid Design and Assembly.

MICE CC Magnet Cryostat Design Overview Derun Li Center for Beam Physics Lawrence Berkeley National Laboratory MICE CC Cryostat Design Review LBNL, February.

MICE Coupling Coil Vacuum Vessel Fabrication Update Allan DeMello Lawrence Berkeley National Laboratory Coupling Coil Working Group January 28, 2014 January.

MICE. Outline Experimental methods and goals Beam line Diagnostics – In HEP parlance – the detectors Magnet system 2MICE Optics Review January 14, 2016.

Muon Ionization Cooling Experiment - MICE HEPTech - Grenoble 4-5 th June 2015 Tom Bradshaw STFC, Rutherford Appleton Laboratory.

M. Migliorati, C. Vaccarezza INFN - LNF

MICE CM29 Magnets Summary

Spectrometer Solenoid Update

Spectrometer Solenoid Fabrication Status and Schedule

as a prototype for Super c-tau factory

Presentation transcript:

Magnet quench during a training run Magnet electrical circuit schematic PROGRESS ON THE MODELING AND MODIFICATION OF THE MICE SUPERCONDUCTING SPECTROMETER SOLENOIDS * Abstract: The Muon Ionization Cooling Experiment (MICE) is an international effort, sited at Rutherford Appleton Laboratory (RAL) in the UK, that will demonstrate ionization cooling in a section of realistic cooling channel using a muon beam. The spectrometer solenoids are an identical pair of five-coil superconducting magnets that will provide a 4-tesla uniform field region at each end of the cooling channel. Scintillating fiber trackers within each of the 400-mm diameter magnet bore tubes will measure the emittance of the beam as it enters and exits the cooling channel. Each of the 3-meter long magnets incorporates a three-coil spectrometer magnet section and a two-coil section that matches the solenoid uniform field into the MICE cooling channel. The cold mass, radiation shield and leads are kept cold by means of a series of two-stage cryocoolers and one single-stage cryocooler. Various thermal, electrical and magnetic analyses are being carried out in order to develop design improvements related to magnet cooling and reliability. The key features of the spectrometer solenoid magnets are presented along with some of the details of the analyses. S. Virostek, M. Green, T. Niinikoski, S. Prestemon and M. Zisman Lawrence Berkeley National Laboratory, Berkeley, CA 94720, USA on behalf of the MICE Collaboration * This work was supported by the Office of Science, U.S. Department of Energy under DOE contract number DE-AC02-05CH Paper ID: TUP173 INTRODUCTION Coil operating currents range from 223 to 271 amps During recent training of one of the spectrometer solenoids, all five coils run in series reached 258 amps (94% of qualifying current) A cold lead inside the cold mass for the Match 2 coil failed due to a local quench A design for further stabilization of the cold leads (inside and outside the cold mass) has been developed The internal passive quench resistors were found to be thermally damaged, likely as a result of the cold lead burn out MAGNET TRAINING & TESTING The spectrometer solenoid passive quench protection system consists of a series of diodes and resistors within the cold mass Each match coil and the 3-coil spectrometer set will be powered by dedicated 300 amp power supplies during normal operation The suitability of the passive magnet protection system is being reviewed and analyzed considering various operational regimes to verify to what degree the design can safely protect the system under reasonable fault scenarios A magnet quench analysis is being finalized, and recommendations for improvement are being developed Other proposed design changes will reduce the heat leak into the cold mass and increase the total amount of cryocooling power Reassembly of the first of the two magnets will be starting soon SUMMARY Spectrometer Solenoid #1 MICE consists of two spectrometer solenoids and a cooling channel. Muon ionization cooling occurs in three LH 2 absorbers in the cooling channel, and the muons are reaccelerated by eight RF cavities. Scintillating fiber detectors in the solenoid bores measure the incoming and outgoing muon emittance. COLD MASS COIL ASSEMBLY Each of the spectrometer solenoids consist of five superconducting coils wound on a common 2923 mm long aluminum mandrel Match Coils 1 and 2 operate as a focusing doublet to match the beam to the adjacent AFC modules The spectrometer portion (End Coil 1, Center Coil and End Coil 2) will generate a 4-tesla uniform field over a 1-meter long and 0.3 meter diameter volume. MAGNET QUENCH ANALYSIS Current design uses a passive internal quench protection system Analyses are being carried out using the Wilson code "quench" and Opera-3D with the QUENCH module The preliminary analyses predict the hot spot temperatures and peak internal voltages without mandrel quenchback The 3D model provides a more detailed look at the quench process (quenchback, layer-to-layer voltages, etc.) The analysis also considers the impact of a quench on critical components such as the LTS and HTS leads 3D quench model of the spectrometer solenoid coils Current decay in coils during quench Field distribution in the MICE coils