DriveAP 1.2 & 2.1 DriveWare®

DriveAP key features Extremely easy to use Upload, edit, download program Possibility to monitor signals on-line Print documentation Includes 3 operating modes: Stand alone (no drive connected) On-line (all changes are written immediately to the drive) Off-line (upload from drive, edit off-line, download to drive) Uses DDCS communication

DriveAP is now available in two versions Non used blocks are hidden Block connection with few clicks Supports 15 blocks Factory codes 3AFE64554468 (CD) 3AFE64554476 (CD + PC Card kit)

DriveAP example 1 User can easily make small changes to basic software Relay output selection list does not contain required setting. RO1 needs to be energized when “Encoder err” warning is given. No function blocks are required, just use the pointer.

DriveAP example 2 A measuring device is connected to AI1 of analogue extension module. Drive must create a warning in case input current goes above 6 mA and a fault if input goes above 15mA.

DriveAP example 3 Create a function that doesn’t exist in a PC tool Enable DriveWindow to monitor alarm bit from drives status word. Add following block to e.g. 12 ms cycle time and monitor parameter 84.09 instead of 3.02 (status word).

DriveAP 2 Totally new block programming tool All data stored to drives flash memory including block location, comments, symbols etc

DriveAP 2 With Multi Block Programming Application one is able to locate freely over 200 blocks including I/O blocks (AI, AO, DI, DO, EXT AI, …) Functions blocks (ABS, ADD, AND, BSET, COMPARE, COUNT, …) Communication blocks (Profibus, Master/Follower) Comment blocks 5 pages / time level available Separate info page describes block functionality Factory codes 3AFE68299195 (CD) 3AFE68299209 (CD + PC card kit)