Tutorial: Business Card Holder Chapter 5

Feature 1 – Lofted Base INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Feature 1 (cont.) At least two sketches are required for lofted solid INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Feature 2 – Extruded Cut INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Feature 3 - Shell Shell command removes a face and leaves a constant-thickness thin structure INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Feature 5 - Fillets INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Feature 6 - Fillet INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Re-Ordering of Features By filleting after the shell operation, the wall thickness is not constant Better order of operations: add fillets first, and then shell the part INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Re-Ordering of Features (cont.) Click & Drag INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

Feature 7 – Raised Text INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009