Gregory G. Dimijian/Photo Researchers cd/EM - F

Metamorphic Rocks Metamorphism Metamorphism: to change form Metamorphic rock solid state. Metamorphic rock: any rock (sedimentary, volcanic, plutonic, metamorphic) that has undergone changes in mineralogical or texture composition in the solid state.

No single mode of origin recrystallizationMetamorphic rocks result from the partial or complete recrystallization of minerals in rocks over long periods of time. solidRocks remain essentially solid during metamorphism.

Metamorphic processes HEAT: stability region of mineral sensitive to T. With increased T, pore fluid decreases. PRESSURE: greater pressure tends to decrease space available; metamorphic minerals tend to be dense. Increased P can come from any stress (burial). Directed stress will bring about a preferred orientation of minerals. FLUIDS (H 2 O): acts as a catalyst during metamorphism; aids the exchange of ions between growing crystals.

Metamorphic grade Refers to the intensity of metamorphism. High grade: high T (>550 0 C), P Intermediate grade: T ( C), P Low grade: low T ( C), P

Metamorphic Grade

Pressure (depth) and Temperature vs. Rock Type

Types of Metamorphism Regional: Widespread changes in temperature and pressure bring about changes in rocks due to tectonic forces. Contact: Colder country rocks “cooked” by intrusion of magma (affected area is proportional to the size and temperature of the intrusion but always only a local phenomenon). Deformational: Changes in rocks associated with faulting and folding (regional or local).

Types of metamorphism (cont.) Burial: Changes in a rock due to the gradual changes in T and P due to successive burial (regional). Impact: Changes due to VERY rapid increase in pressure (only localized). Hydrothermal: heated fluids leach surrounding rocks (local)

Fig. 9.3 Plate Tectonics & Metamorphism

How much can a rock change? Depends on:  grade of metamorphism  duration of metamorphism  composition of the rock

Metamorphic reactions Mineralogical changes (e.g., clay to mica): Many complicated reactions in which new assemblages form — depend on pressure, temperature, composition. Textural changes: recrystallization (grain boundaries more compact) and foliation (preferred orientation of minerals).

Mineralogical Changes ( Mineral Stability) Most minerals are stable over a relatively narrow range of P and T (e.g., ice unstable above 0°C). The stability range of different minerals overlap and provide constraints on the metamorphic history of rocks -> METAMORPHIC ZONES.

Mineralogic Changes in Metamorphosed Shales (new assemblages develop -> zones)

Mineralogic Changes in Metamorphosed Shales

Contact Metamorphism adjacent to a Granite Intrusion

Changes in Texture Grain size Recrystallization - Granular Texture Grain size can either decrease or increase. Orientation of minerals Directed stress will orient minerals perpendicular to stress: –Lineation –Foliation

Fig. Story 9.4

Textural Changes: Non Foliated or Granular Granular texture –Coarse to fine interlocking grains –Little or no preferred orientation

Quartzite (from sandstone) Breck P. Kent

Quartzite in Thin Section

Marble (from limestone) Breck P. Kent

Marble in Thin Section

FOLIATED ROCKS Mineral grains show preferred orientation See different kinds of foliation: –Slaty cleavage –Schistosity –Gneissic Foliation

(sheen) (sparkles)

Slate with Foliation and Relict Bedding

Martin Miller Slaty Cleavage

Metamorphic Foliation

S. Dobos Direction of Compressive Forces

Classification of metamorphic shale Based on the texture and composition of the rock: Low gradeSlate Phyllite Intermediate gradeSchist Gneiss High gradeMigmatite

Slate Andrew J. Martinez/Photo Researchers

Schist Biophoto Associates/Photo Researchers

Schist in Thin Section

Gneiss Breck P. Kent

Metamorphism In Hawai’i Not important except for CONTACT METAMORPHISM (of course) at dike margins Only see Low Grade metamorphic rocks in rock quarries with lots of Zeolites (The following slides are for your edification only, so you can say that you have seen these figures!)

Metamorphic facies A given set of metamorphic conditions Each facies is characteristic of particular tectonic environments and will have certain rocks that are diagnostic of those conditions. Therefore, certain rocks can be clues to the (P,T) history of the region. Facies are: zeolite*, greenschist, amphibolite, granulite, blueschist, eclogite

Metamorphic Facies *

Plate Setting and Metamorphism The end!