Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.

Slides:



Advertisements
Similar presentations
ETF Activities Boyle’s Law Lemon Battery.
Advertisements

Have you ever held a wire that has current flowing through it? If so what did you notice about it? The wire gets hot. The increase in temperature causes.
Test Chamber Assembly, 1.5M Long (59.00”) Vacuum Tube, 4.00 OD x 3.50 ID Vacuum Tube, 3.75 OD x 3.51 ID 3.375” CFF, Non-Rotatable Feedthrough, Ceramtec.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
FPGA PID Heater/Cooler Controller Galt Design, Inc.
Capacitance Chapter 18 – Part II C Two parallel flat plates that store CHARGE is called a capacitor. The plates have dimensions >>d, the plate separation.
Capacitance and Capacitors. Recall heat capacity (c) –The amount of heat energy (J) absorbed (released) by a material of known mass (m) when changing.
Molly, Gwyn, Sam, and Eric.  Sam will have soldered all parts onto our PCB so that we can test it at the meeting  Eric finished MUX code in PIC C and.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Gwynneth Davidoff, Kendall Pletcher, Mary Schmidt, Amy Whitcombe.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Molly, Gwyn, Sam, and Eric.  Do we need mounting holes for the main PCB? How many?  What are our options for heat sinking converters? Should we use.
Gwynneth Davidoff, Kendall Pletcher, Mary Schmidt, Amy Whitcombe.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Gwynneth Davidoff, Kendall Pletcher, Mary Schmidt, Amy Whitcombe.
Spectrometer Solenoid Update Steve Virostek - LBNL MICE Video Conference #129 February 25, 2010.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Molly, Gwyn, Sam, and Eric.  Tested and analyzed enough of our system to make sure that it will work  Finished thermal testing of one of our converters.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Molly, Gwyn, Sam, and Eric.  We’ll need 2 PCBs  The main board will have all the converters, current and temperature monitors, and MUXs  The second.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
A6: Team Rallye Potable Water Still Presented by: Full Group November 15, 2006.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Molly, Gwyn, Sam, and Eric. Build a robust low voltage converter from an unregulated 28V supply with a user-friendly command tester that displays relevant.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Unit E Lesson 7 Study Guide. What is electrical energy? 1). A battery provides _____ energy. 2). The chemical reactions in a battery produce _________.
Thermo-Cooler Controller Kiefer, Mary, Molly, Sam.
Molly, Gwyn, Sam, and Eric.  We ed Fred asking about connectors and EAGLE  Sam is set up to conduct a thermal test of a converter in a vacuum 
Circuits Series and Parallel. Series Circuits Example: A 6.00 Ω resistor and a 3.00 Ω resistor are connected in series with a 12.0 V battery. Determine.
CAPACITORS & RESISTORS. RESISTORS A resistor, like batteries and lights, can also be present in an electrical circuit. A resistor limits the flow of electricity.
Specific Heat. Names Specific Heat Capacity Specific Heat Heat Capacity.
2007 Electronic Project Kit Remote Control Nightlight Biological & Agricultural Engineering.
Electrical Resistance and Ohm’s Law Electric circuits are used to convert electrical energy into some other form of energy we need.
Electric Current and Electrical Energy
e-e- e-e- e-e- e-e- e-e- e-e- e-e- e-e- e-e- e-e- p+p+ p+p+ p+p+ Connecting two parallel plates to a battery produces uniform electric field  the electric.
With a knowledge of how to connect cells in parallel and series, we can figure out how to arrange batteries to deliver a desired voltage, and in some cases,
Which of these configurations gives V = 0 at all points on the y-axis? 4) all of the above 5) none of the above 10. Equipotential Surfaces III 1) x +2.
My Pals are Here! Science © 2008 Marshall Cavendish (Singapore) Private Limited © 2009 Marshall Cavendish International (Singapore) Private Limited.
Charging System Fundamentals
Spectrometer Solenoid – Quench Analysis The LBNL version of the quench model has been further refined - Heng Pan is finishing various quench scenarios.
Parallel Plates.
PARALLEL PLATES. From previous work, the electric field strength can be found from the electric force on a test charge.
Electric Current – Flow of electrons through a ___________. The number of _________ flowing through the conductor determines the amount of _________ ________.
CLIC workshop 2015 EXTRACTION KICKER STRIPLINE MEASUREMENTS C. Belver-Aguilar (IFIC) On behalf of: A. Faus-Golfe (IFIC), F. Toral (CIEMAT), M.J. Barnes.
Status of the PSD upgrade - Status of the PSD cooling and temperature stabilization system - MAPD gain monitoring system - PSD readout upgrade F.Guber,
Mar 30 Today’s Activities -AP Test Must Memorize and Gravitational Potential Energy -Electricity Background Knowledge -AP Practice Questions set #6 Tomorrow’s.

Thermoelectric Modules (TEM)
Electric Current Electric current – The net movement of electric charges in a single direction through a wire or conductor. Voltage difference – The force.
Exploring The Multimeter
Electric Current Introduction
Electronic Components
ELECTRICITY! SERIES AND PARALLEL CIRCUITS
ASSIGNMENT NO.-2.
Transistor & Voltage Divider
Arrow Electrical System
Electromotive Force and Potential Difference
Series and parallel circuits
Human Battery Stem Activity for Students/Teachers.
Electrons in Circuits. Electrons in Circuits Parts of a circuit Battery Closed switch (allows electrons to flow) Open switch (impedes flow) Wire Resistor.
Electricity.
Presentation transcript:

Thermo-Cooler Controller Kiefer, Mary, Molly, Sam

Update We measured the impedance of the TEC We are waiting on a response from Vanderlei and/or Dominik We are waiting to get a DAQ from Brian in order to complete the thermistor testing setup (we are getting it on Thursday)

Current Assignments Finish programming the PIC Initial experimenting with PWM Test the setup of the vacuum—tape an object with about the same size/weight as the TEC Test the electrical feedthrough of the vacuum ▫Battery connected to inner feedthrough, read the voltage from the other side Get a hold of a copper plate—will be used as a heat sink to the hot plate of the TEC

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2025 SlidePlayer.com. Inc. All rights reserved.