Gas Fired Water Heater Boiler Makers A Retrospective Glance Group Members Bryan Gipson Bryan Crawford Tom Rose November 11, 1997.

Slides:

Advertisements

Similar presentations

UC-Irvine Meeting Identifying Energy Saving Opportunities in Process Heating through Waste Heat Recovery and Power Generation Bryan Warren Southern.

Advertisements

Definition of Boilers Boiler

The technology of heat removal using "cylindrical heat exchangers" (Boiler TOM-1) Author: Voronov Е. Contacts: tel. +7 (701) ,

Enthalpy of Solution (HSOLN)

Combustion Calculations

Lecture# 9 MASS AND ENERGY ANALYSIS OF CONTROL VOLUMES

PARKER BOILER PARKER BOILER HOT WATER PIPING SYSTEM 1. 3 way valve and O.S.A. reset. 2. Single boiler piping schematic. 3. Single boiler with 3 way valve.

ITK-233 Termodinamika Teknik Kimia I

Unit 1 PPA 3 ENTHALPY OF COMBUSTION. ENTHALPY OF COMBUSTION (Unit 1 PPA3) (1) Write the balanced equation for the enthalpy of combustion of ethanol. (2)Draw.

1 MAE 5310: COMBUSTION FUNDAMENTALS Adiabatic Combustion Equilibrium Examples September 19, 2012 Mechanical and Aerospace Engineering Department Florida.

Heat transfer in boilers

Power Plant Construction and QA/QC Section 2.4– Boiler Auxiliaries

Steam Generation Efficiency

© 2014 Carl Lund, all rights reserved A First Course on Kinetics and Reaction Engineering Class 3.

Le Chatelier’s Principle. When a system at equilibrium is placed under stress, the system will undergo a change in such a way as to relieve that stress.

ME 475/675 Introduction to Combustion Lecture 8. Announcements.

Gas Stoichiometry!. ■ equal volumes of gases at the same temperature & pressure contain equal numbers of particles ■ Molar Volume – the volume of 1.0.

TEAM II Week 4 Data Analysis By: Cortez Rankin & D. Caruthers.

Capturing Carbon dioxide Capturing and removing CO 2 from mobile sources is difficult. But CO 2 capture might be feasible for large stationary power plants.

Last time 3/6/08. D=v o / V Bioreaction Engineering Wash Out: 1.) Neglect Death Rate and Cell Maintenance 2.) Steady State.

Chemical Reaction Engineering (CRE) is the field that studies the rates and mechanisms of chemical reactions and the design of the reactors in which they.

Prototype Cooling Tower Presented By: Bryan Crawford Assisted By: Tom Rose Gerry Taylor.

Chemical Reaction Engineering (CRE) is the field that studies the rates and mechanisms of chemical reactions and the design of the reactors in which they.

Boiler efficiency Heat Engines & Boilers.

Enthalpy of Combustion Calculations. Example Q. 4.6g of ethanol (C 2 H 5 OH) is burned. The energy released raised the temperature of 0.5kg of water by.

Incineration Exercise. Objectives  Compute the composition of flue gas  Compute the temperature of flue gas (a function of waste heat value and composition)

Chemical Reaction Engineering (CRE) is the field that studies the rates and mechanisms of chemical reactions and the design of the reactors in which they.

The BCA Method in Stoichiometry

Copyright © 2005 Advantica Inc. (USA Only) and Advantica Ltd. (Outside USA). All rights reserved by the respective owner. Own Use Gas Review of 2000 Model.

The eMLR approach and a sensitivity analysis. Toste Tanhua Arne Körtzinger Karsten Friis Darryn W. Waugh Douglas W.R. Wallace.

Water and its Chemistry Oxidation / Reduction.

Calculating k Values for Pipe Insulation By Russell Peterson & Chris Mabey.

Constructing Architect. Water and heating Building Service (BSE) Team 1, A2010.

Terry Rigdon. Ethanol (ethyl alcohol) Made from biomass such as corn or sugar Ethanol added to gasoline Benefits of ethanol over gasoline Brazil has introduced.

Material balance and Energy balance steady state reaction systems.

BY KEVIN STUBBS AND BRAD IVEY Peruvian Water Heater.

32.1 Pressure Dependence of Gibbs’ Free Energy Methods of evaluating the pressure dependence of the Gibbs’ free energy can be developed by beginning with.

Today, we will burn a gummy worm containing 2.1 g of sucrose (C 12 H 22 O 11 ). When one mole of sucrose burns in oxygen gas, it produces carbon dioxide.

Design and construction We need to seek a design that Achieve the goal of the project which should be : compact effective So we need to know types of heat.

The Heat Balance. The heat balance shows the important sources of heat energy and their relative contribution to the total energy usage in a process The.

ENERGY EFFICIENCY IN THERMAL UTILITIES AND SYSTEM

1 Analysis of Cost and Savings Values for Revised Energy Star Dishwasher Specifications June 6, 2006 Revised August 8, 2006 Revised Again January 23, 2007.

Gas Cycles 2 nd Law of Thermodynamics. Work done by a cycle When a gas undergoes a complete cycle, it starts and ends in the same state. The gas is identical.

1 CHEM-E7130 Process Modeling Exercise. 2 Exercises 1&2, 3&4 and 5&6 are related. Start with one of the packages and then continue to the others. You.

 Work – the product of force and the distance traveled  The unit of Work is a Joule (J)  Work= Force × distance W = F ● d Distance (m) Force (N) Work.

Chemistry 20 Stoichiometry. This unit involves very little that is new. You will merely be applying your knowledge of previous units to a new situation.

Gas pressure and the ideal gas law Assume specular collisions* *Bold assumption – but more general calculation gives same result. Change in momentum:

Name Next Spelling Word #1 Next Previous Spelling Word #2 Next.

Isothermal reactor design

Specific Heat Capacity. The specific heat capacity is the amount of energy required to increase the temperature of 1kg of a substance by 1˚C We will calculate.

Pressure drop in PBR Lec 10 week 13. Pressure Drop and the Rate Law We now focus our attention on accounting for the pressure drop in the rate law. to.

FURNACE HEAT BALANCE CALCULATIONS A heat balance of a furnace is a means of determining the thermal efficiency of the process and comparing the relative.

Examples 1 1.At  150°F the vapor pressure of methane is psia and the saturated specific internal energies are u f = Btu/lbm and u g =

Class 21, November 12, 2015 Lesson 3.8.  By the end of this lesson, you should understand that: ◦ To solve any equation, you must follow the basic rules.

What is it? The Kinetic Molecular Theory (KMT) is used to explain the behavior of molecules in matter. The relationships between the pressure, volume,

IC5.2.3 Mole calculations © Oxford University Press Mole calculations.

WS: Calorimetry Problems

Example: Electric heater is often used in houses to provide heating during winter months. It consists of a simple duct with coiled resistance wires as.

First Law of Thermodynamics applied to Flow processes

Date of download: 12/25/2017 Copyright © ASME. All rights reserved.

Thermal (heat) capacity

Conservation of Energy/Bernoulli’s Equation

Unit 3 Review (Calculator)

Specific Heat Capacity (比熱容量)

Water Bath Heaters 101.

Calculate 9 x 81 = x 3 3 x 3 x 3 x 3 3 x 3 x 3 x 3 x 3 x 3 x =

State Equations: State determined system is a system in which the time derivatives of the variables describing the state (the state variables) are.

Flow rate of fuel (kmol/h) = 120

Presentation transcript:

Gas Fired Water Heater Boiler Makers A Retrospective Glance Group Members Bryan Gipson Bryan Crawford Tom Rose November 11, 1997

Previous Work Steady state analysis. –Water side –Flue gas Transient analysis was not considered.

IN - OUT = ACCUMULATION

Status Report Energy balances done incorrectly. Unsure if flue temperatures are necessary. Unsure where linear regression is used.

Future Work Calculate number of moles of gas. Determine if there are any losses. –Assumptions of heater materials. –Assume construction of the heater.