USB Adapter for Experiment Board Created By : Itai Heller Ofir Asulin Supervised By: Mony Orbach.

Slides:



Advertisements
Similar presentations
USB Controlled IO Module Jon Knoll Dave Wolowicz Sponsored by: Dr. Kin Li A 499a Project.
Advertisements

LOGSYS Development Environment of Embedded Systems Tamás Raikovich Béla Fehér Péter Laczkó Budapest University of Technology and Economics Department of.
PH4705 ET4305 Interface Standards A number of standard digital data interfaces are used in measurement systems to connect instruments and computers for.
Control System for Smart House Characterization Students Yossi Lempert Natan Keren Instructor Konstantin Sinyuk.
Performed by: Tal Grylak Nadav Eitan Instructor: Moni Orbach Cooperated with: Eli Shushan המעבדה למערכות ספרתיות מהירות High speed.
AMC – Adaptive Mirror Controller Project supervised by: Mony Orbach Project performed by: Koren Erez, Turgeman Tomer Project supervised by: Mony Orbach.
1 Performed By: Khaskin Luba Einhorn Raziel Einhorn Raziel Instructor: Rivkin Ina Spring 2004 Spring 2004 Virtex II-Pro Dynamical Test Application Part.
AMC – Adaptive Mirror Controller Project supervised by: Mony Orbach Project performed by: Koren Erez, Turgeman Tomer Project supervised by: Mony Orbach.
Students: Nir Engelberg Ezequiel Hadid Supervisor: Mony Orbach In association with: November 23, Winter 2004.
Students: Nir Engelberg Ezequiel Hadid Supervisor: Mony Orbach In association with: September 28, Winter 2005.
Final Presentation 2004 Momentum Measurement Card (MMC) Project supervised by: Mony Orbach Project performed by: Hadas Preminger Uri Niv.
Characterization Presentation Spring 2006 Implementation of generic interface To electronic components via USB2 Connection Supervisor Daniel Alkalay System.
1 Project supervised by: Dr Michael Gandelsman Project performed by: Roman Paleria, Avi Yona 12/5/2003 Multi-channel Data Acquisition System Mid-Term Presentation.
AMC – Adaptive Mirror Controller Project supervised by: Mony Orbach Project performed by: Koren Erez, Turgeman Tomer Project supervised by: Mony Orbach.
Performed by: Maria terushkin & Guy Ovadia Mony Orbach Instructor: Mony Orbach Cooperated with: Alex Bekker (EO Laboratory) המעבדה למערכות ספרתיות מהירות.
Control System for Smart House Characterization Students Yossi Lempert Albert Achtenberg Instructor Konstantin Sinyuk.
Performed by: Uri Niv Hadas Preminger Instructor: Mony Orbach Cooperated with: Physics Dep. המעבדה למערכות ספרתיות מהירות High speed digital systems laboratory.
Kabuki 2800 Critical Design Review 19 October 2006.
1 Application Accessory For Cellular Phone - Characterization Presentation - Performed by: Avi Feldman Omer Kamerman Project instructor: Boaz Mizrachi.
Implementation of neuronetwork system on FPGA (characterization presentation) supervisor: Karina Odinaev Vyacheslav Yushin Igor Derzhavets Winter 2007.
Students: Asulin Ofir Heller Itai Supervisor: Mony Orbach In association with: June 16, summer 2006.
Presenting: Itai Avron Supervisor: Chen Koren Characterization Presentation Spring 2005 Implementation of Artificial Intelligence System on FPGA.
USB Adapter for Experiment Board Created By : Itai Heller Ofir Asulin Supervised By: Mony Orbach.
High Speed Digital Systems Lab Spring/Winter 2010 Part A final presentation Instructor: Rolf Hilgendorf Students: Elad Mor, Ilya Zavolsky Integration of.
Students: Asulin Ofir Heller Itai Supervisor: Mony Orbach In association with: June 16, summer 2006.
USB Mass-Storage Implementation on an Embedded System (D0113) Supervisor: Dimitry Sokolik Performed by: Yoav Gershoni Shachar Faigenblat Final Presentation.
Students: Nir Engelberg Ezequiel Hadid Supervisor: Mony Orbach In association with: January 3, Winter 2005.
CSCE 430/830 A Tutorial of Project Tools By Dongyuan Zhan Feb. 4, 2010.
AMC – Adaptive Mirror Controller Project supervised by: Mony Orbach Project performed by: Koren Erez, Turgeman Tomer Project supervised by: Mony Orbach.
1 Mid-term Presentation Implementation of generic interface To electronic components via USB2 Connection Supervisor Daniel Alkalay System architectures.
Kabuki 2800 “a real-time digital audio effects system for performance” team “Big Country” presents ECEN4610 Preliminary Design Review 14 September 2006.
Final Presentation Momentum Measurement Card Project supervised by: Mony Orbach Project performed by: Hadas Preminger, Uri Niv.
Performed by: Nir Engelberg & Ezequiel Hadid Instructor: Mony Orbach Cooperated with: Electrical Engineering Laboratory המעבדה למערכות ספרתיות מהירות High.
ASPPRATECH.
Chapter 4 Section 3.
RS232 Serial and Parallel Interfaces
Technion-Israel Institute of Technology Electrical Engineering Department High Speed Digital Systems Laboratory Project subject: wireless biofeedback system.
Bonitron Air Demand Scheduler Design Review Vanderbilt Senior Design Alex Brown Ajmer Dwivedi Cory Haugh February 04, 2008.
PIC microcontrollers. PIC microcontrollers come in a wide range of packages from small chips with only 8 pins and 512 words of memory all the way up to.
Silicon Labs ToolStick Development Platform
Advanced Computers and Communications (ACC) Faculty Advisors: Dr. Charles Liu Dr. Helen Boussalis 10/25/20121NASA Grant URC NCC NNX08BA44A Student Assistants:
1 Applied Control Systems Technology. 2 Pin configuration Applied Control Systems.
Introduction to Computing: Lecture 4
Low Cost Infrared Touch Screen Bezel for POS Systems Rohan Verma, Jeremy Taylor, Freddie Dunn III Georgia Institute of Technology School of Electrical.
ICP DAS Http: support about ISaGRAF: 1 Open Solution for I-8000 Series Embedded Controllers Presented by Chun Tsai
Part A Presentation High Speed Digital Signal Lab Students: Lotem Sharon Yuval Sela Instructor : Ina Rivkin.
Matrix Multiplication on FPGA Final presentation One semester – winter 2014/15 By : Dana Abergel and Alex Fonariov Supervisor : Mony Orbach High Speed.
MICRO CONTROLLER MODULE 1. Learning Objectives Name some gadgets that use microcontrollers. Define a microcontroller. Differentiate between a computer.
© 2004 Xilinx, Inc. All Rights Reserved Implemented by : Alon Ben Shalom Yoni Landau Project supervised by: Mony Orbach High speed digital systems laboratory.
Project D1427: Stand Alone FPGA Programmer Final presentation 6/5/10 Supervisor: Mony Orbach Students: Shimrit Bar Oz Avi Zukerman High Speed Digital Systems.
Lopamudra Kundu Reg. No. : of Roll No.:- 91/RPE/ Koushik Basak
CAN-Bus Logger Characterization presentation Apr. 19, 2009 Elad Barzilay Idan Cohen-Gindi Supervisor: Boaz Mizrahi.
Adaptive Mirror Control System Characterization Presentation Performed by: Boris Goychman & Eyal Tsin Instructor: Tsachi Martsiano Semestrial project,
Senior DesignSoftware-1Seattle Pacific University High-level Software Design Context Diagram Connections between major components Synchronization with.
THE MICROPROCESSOR A microprocessor is a single chip of silicon that performs all of the essential functions of a computer central processor unit (CPU)
11 MANAGING DEVICES AND PERIPHERALS Chapter 4. Chapter 4: Managing Devices and Peripherals2 CHAPTER OVERVIEW  Implement, manage, and troubleshoot input.
Introduction to Labs Wenchao Cao, Teaching Assistant Department of EECS University of Tennessee.
Teaching Digital Logic courses with Altera Technology
8255:Programmable Peripheral Interface
Computer Systems Unit 2. Download the unit specification from moodle or the BTEC website Or alternatively visit ahmedictlecturer.wikispaces.com.
TRANSMISSION LINE MULTIPLE FAULT DETECTION AND INDICATION TO EB
Experimental Software Engineering Course for Training Practitioners in Embedded Real-Time Systems Real-Time Systems LAB, School of Electronic Engineering,
Introduction to the FPGA and Labs
EET 1131 Unit 4 Programmable Logic Devices
Lecture 18 PicoBlaze I/O Interface
Programmable Peripheral Interface
Lecture 13 PicoBlaze I/O & Interrupt Interface
RTL Design Methodology
RTL Design Methodology
Programmable logic and FPGA
Presentation transcript:

USB Adapter for Experiment Board Created By : Itai Heller Ofir Asulin Supervised By: Mony Orbach

Project Goals Enhancing & Expanding an existing prototype circuit built on a wire-wrap board. Manufacturing a printed circuit in order to broaden and improve lab experiments, adding future implementations. The prototype is a Communication adapter designed to connect between a PC USB Port and a Lab Experiment boards.

Existing Environment The current device is based upon an old 8031 micro-controller with a RS-232 communication protocol. It is necessary to advance to a more modern communication protocol in order to keep up with the PC advance, furthermore a higher data- flow rate is needed for future implementations. The new interface must be consistent with existing environment in the lab (PC, 6 types of lab experiment devices and windows XP with VB 6.0).

Characterization of system Inputs i)Type of the lab educational device: received on installation (8bit). ii)Number of lab educational device: received from device (8 bit). iii)Random address: received from the PC (3 bit). Future implementations: iv) input Port: (8 bit )

Characterization of system Outputs i) PC’s approval for the connection with the device : On screen. ii)Approval for the receiving of the random address: Buzzer (1 bit). Future implementations: iii) output Port (8 bit)

Block Diagram PC Board Number USB Adaptor & FPGA Experiment Board (Midgam) Draw Control Confirmation (Buzzer) Power Stabilizer Outside Voltage USB 3 bits 8 bits I/O PORT 8 bits 1 bit 3 bits

Block Diagram-In depth PC Board Number DLP USB Adaptor Experiment Board (Midgam) Draw Control Confirmation (Buzzer) Power Stabilizer Outside Voltage USB 3 bits 8 bits I/O PORT 8 bits 1 bit 3 bits Cyclon FPGA EPSC Reset Clock 2XSwitch DIP-8 RS323 LM7805

Schedule Theoretical orientation.6/4/2005-DONE System planning:12/5/2005-DONE – Choosing and placing of components – Learning Orcad Circuit drawing on Orcad and handing it to Ella.-DONE Creating the circuit (with Ella) and configuration of the FPGA (in VHDL).12/6/2005 Simulations & Debugging.12/7/2005 Driver Writing.28/7/2005 Implementation of the Adaptor with the experiment system.28/8/2005