Steady-State Sinusoidal Analysis 1. Identify the frequency, angular frequency, peak value, rms value, and phase of a sinusoidal signal. 2. Solve steady-state ac circuits using phasors and complex impedances.

3. Compute power for steady-state ac circuits. 4. Find Thévenin and Norton equivalent circuits. 5. Determine load impedances for maximum power transfer. 6. Solve balanced three-phase circuits.

SINUSOIDAL CURRENTS AND VOLTAGES Vm is the peak value ω is the angular frequency in radians per second θ is the phase angle T is the period

Frequency Angular frequency

Root-Mean-Square Values

RMS Value of a Sinusoid The rms value for a sinusoid is the peak value divided by the square root of two. This is not true for other periodic waveforms such as square waves or triangular waves.

Phasor Definition

Adding Sinusoids Using Phasors Step 1: Determine the phasor for each term. Step 2: Add the phasors using complex arithmetic. Step 3: Convert the sum to polar form. Step 4: Write the result as a time function.

Using Phasors to Add Sinusoids

Sinusoids can be visualized as the real-axis projection of vectors rotating in the complex plane. The phasor for a sinusoid is a snapshot of the corresponding rotating vector at t = 0.

Phase Relationships To determine phase relationships from a phasor diagram, consider the phasors to rotate counterclockwise. Then when standing at a fixed point, if V1 arrives first followed by V2 after a rotation of θ , we say that V1 leads V2 by θ . Alternatively, we could say that V2 lags V1 by θ . (Usually, we take θ as the smaller angle between the two phasors.)

To determine phase relationships between sinusoids from their plots versus time, find the shortest time interval tp between positive peaks of the two waveforms. Then, the phase angle is θ = (tp/T ) × 360°. If the peak of v1(t) occurs first, we say that v1(t) leads v2(t) or that v2(t) lags v1(t).

COMPLEX IMPEDANCES

Kirchhoff’s Laws in Phasor Form We can apply KVL directly to phasors. The sum of the phasor voltages equals zero for any closed path. The sum of the phasor currents entering a node must equal the sum of the phasor currents leaving.

Circuit Analysis Using Phasors and Impedances 1. Replace the time descriptions of the voltage and current sources with the corresponding phasors. (All of the sources must have the same frequency.)

2. Replace inductances by their complex impedances ZL = jωL. Replace capacitances by their complex impedances ZC = 1/(jωC). Resistances have impedances equal to their resistances. 3. Analyze the circuit using any of the techniques studied earlier in Chapter 2, performing the calculations with complex arithmetic.

AC Power Calculations

THÉVENIN EQUIVALENT CIRCUITS

The Thévenin voltage is equal to the open-circuit phasor voltage of the original circuit. We can find the Thévenin impedance by zeroing the independent sources and determining the impedance looking into the circuit terminals.

The Thévenin impedance equals the open-circuit voltage divided by the short-circuit current.

Maximum Power Transfer If the load can take on any complex value, maximum power transfer is attained for a load impedance equal to the complex conjugate of the Thévenin impedance. If the load is required to be a pure resistance, maximum power transfer is attained for a load resistance equal to the magnitude of the Thévenin impedance.