Heat Transfer Through Windows An Energy and Cost Analysis Mike Call Greg Rasmussen 31 March BABE8BF8EEA/0/radiant_heat_flow.gif

Introduction Heat transfer through windows greatly contributes to the energy loss from a house There are many varieties of windows; from single paned, to double paned with aluminum, to double paned with injected Argon, PVC lining, and composite glass connectors content/uploads/double-pane.jpg

Introduction With the focus on energy, we are consultants for home owners regarding their fictitious house. They want us to recommend whether they should replace their aluminum windows with PVC lined windows. We have the theory, training, and software to do so, and are ready for the challenge. CampusInit/images/EnergyStarLogo.jpg

Objective 1.Perform energy and cost comparison to the following: – Double paned windows with aluminum framing – Double paned windows with PVC framing 2.Calculate the total energy loss difference between them 3.Use that difference to see how much the PVC windows would save each year. 4.Calculate how many years would be needed to recuperate the costs of installation. 5.Make recommendations whether to change the windows or not.

Assumptions 1.The industry average delta T was used: 39 C 2.The house has 10 windows 3.Each window is 4 ft by 4 ft, or 1.3 m^2 per window 4.Only 215 days of heat use with average temperature difference of 39 C (conservative for Utah since 20 F and 71 F difference is 27.7 C) content/uploads/2009/07/man_question_mark.j pg

Theory This diagram illustrates the different modes of heat transfer seen by windows “Therm” software has the capability to calculate the U value for each window based on geometry, material and certain standardized assumptions.

Modeling Method Measure the dimensions of the window to be modeled Download and install “Therm” software, available for download at: Build the window geometry Choose the materials for each component Set the inside and outside boundary conditions Enter the assumed temperature difference between the inside and outside panes Run the calculation to determine the window’s U value Calculate the total heat loss difference between the PVC and Aluminum windows using the calculated U values Calculate the heat loss for a year, and determine annual cost differences

Software Calculations/Results Above is the cross section of a window with Aluminum trimming the finite element mesh and the heat flux are shown graphically. Above is the cross section of a window with PVC trimming. The heat flux is noticeably smaller than the Aluminum version to the left.

Hand Calculations Once the software gave us the U-factor, we could calculate: – Flux – Heat – Heat/year – $$/year savings

Excel Calculations First, we have: – The bill date – The decatherms used during the bill period – A correction for water heater use – The total cost for that many decatherms – The cost per decatherm AddressDate Actual Decatherms Used Decatherms - Water Heater Total Cost Cost per Decatherm 115 N 2770 W, Provo, UT /2/ $ /2/ $ /5/ $ /2/ $ /3/ $ *assuming water heater = 1.5 (subtract) Average CostDecatherm/ YearSavings / Year Cost of New Windows # of years to recuperate cost $ $21.50$3, $ $21.50$10, As seen to the right, the amount of time required to recuperate the cost of installing new windows is incredible $3,000-$10,000 is the estimate cost range to replace 10 windows in an average sized home

Conclusion Though there is extra heat loss through the aluminum seals, the cost of replacing the windows is much too high to justify based on the current price of natural gas. It could be a different story if the windows were single paned, but with the already double paned windows, we recommend not to replace them!