ATLAS End-Cap C Proposed Transport Box P Cooke 15 June 2005
Requirements Support using transport frame only Support using transport frame only Isolate Thermal plug from transport box Isolate Thermal plug from transport box Temperature controlled truck Temperature controlled truck Rear door opening - 2.7M high x 2.45M wide Rear door opening - 2.7M high x 2.45M wide Load onto truck with fork-lift Load onto truck with fork-lift Recommended transport company - Danzas Recommended transport company - Danzas
Method Raise end-cap assembly frame 225mm to clear lowest point of transport frame Raise end-cap assembly frame 225mm to clear lowest point of transport frame Necessary to remove assembly frame floor (reducing supported weight) Necessary to remove assembly frame floor (reducing supported weight) Lower transport frame 90mm (extend wheel brackets) Lower transport frame 90mm (extend wheel brackets) Manufacture strong pallet Manufacture strong pallet Construct protective frame and box onto pallet Construct protective frame and box onto pallet
Original Assembly/Transport frames
Assembly frame raised 225mm and wheels raised 90mm
Inner Protective Frame assembled from Bosch Profile
Inner frame covered with varnished 12mm ply-wood
Top and Underside views of steel pallet
Assembly positioned over pallet
Wheels transferred onto pallet Outer frame assembled using Bosch profile attached to pallet
Outer frame covered with 25mm varnished ply-wood
Cut-away section of complete assembly