30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC H-RORC The HLT- Read-Out Receiver Card.

Slides:



Advertisements
Similar presentations
ATCA LLP CARRIER BLOCK DIAGRAMS LAST UPDATE 09/05/2007.
Advertisements

StreamBlade SOE TM Initial StreamBlade TM Stream Offload Engine (SOE) Single Board Computer SOE-4-PCI Rev 1.2.
Radiation Tolerant Source Interface Unit for the ALICE Experiment E. Dénes et al. LECC September 2005, Heidelberg.
Who We Are? Detector Building Group of KFKI-RMKI (Research Institute for Particle and Nuclear Physics), Budapest, HUNGARY.
Offering the freedom to design solutions Sundance PXIe Solution.
Torsten Alt - KIP Heidelberg IRTG 28/02/ ALICE High Level Trigger The ALICE High-Level-Trigger.
Super Fast Camera System Performed by: Tokman Niv Levenbroun Guy Supervised by: Leonid Boudniak.
PALM-3000 P3K FPDP Carrier Board Review Dean Palmer Building 318, Room 125 November 10, :00 am – 12:00 pm.
Detector Array Controller Based on First Light First Light PICNIC Array Mux PICNIC Array Mux Image of ESO Messenger Front Page M.Meyer June 05 NGC High.
Sept TPC readoutupgade meeting, Budapest1 DAQ for new TPC readout Ervin Dénes, Zoltán Fodor KFKI, Research Institute for Particle and Nuclear Physics.
Uli Schäfer 1 Production and QA issues Design Modules have been designed, with schematic capture and layout, in Mainz (B.Bauss) Cadence design tools, data.
1 Design of the Front End Readout Board for TORCH Detector 10, June 2010.
Manfred Meyer & IDT & ODT 15 Okt Detectors for Astronomy 2009, ESO Garching, Okt Detector Data Acquisition Hardware Designs.
CERN CMS Project Host / SD Card Configuration Data Access Dave Ojika Alex Madorsky Dr. Darin Acosta Dr. Ivan Furic.
System Architecture A Reconfigurable and Programmable Gigabit Network Interface Card Jeff Shafer, Hyong-Youb Kim, Paul Willmann, Dr. Scott Rixner Rice.
PCI/104 Explanation and Uses in Test Program Set Development.
General Purpose FIFO on Virtex-6 FPGA ML605 board midterm presentation
Students: Oleg Korenev Eugene Reznik Supervisor: Rolf Hilgendorf
General Purpose FIFO on Virtex-6 FPGA ML605 board Students: Oleg Korenev Eugene Reznik Supervisor: Rolf Hilgendorf 1 Semester: spring 2012.
DDL hardware, DATE training1 Detector Data Link (DDL) DDL hardware Csaba SOOS.
SVAR'06, 24/05/06FastTrack1 FastTrack: A High Frame Rate Stereovision Tracking System Michael Belshaw Michael Greenspan Dept. of Electrical & Computer.
Trigger Supervisor (TS) J. William Gu Data Acquisition Group 1.TS position in the system 2.First prototype TS 3.TS functions 4.TS test status.
HEP UCL Cambridge University Imperial College London University of Manchester Royal Holloway, University of London University College London Matthew Warren,
Leo Greiner IPHC testing Sensor and infrastructure testing at LBL. Capabilities and Plan.
DCS Detector Control System Hardware Dirk Gottschalk Volker Kiworra Volker Lindenstruth Vojtech Petracek Marc Stockmeier Heinz Tilsner Chair of Computer.
Remote Firmware Down Load. Xilinx V4LX25 Altera Stratix Control Altera Stratix Control Xilinx V4FX20 EPROM XCF08 EPROM XCF08 EPROM EPC16 EPROM EPC16 EPROM.
Uni-Heidelberg, KIP, V.Angelov 1 International Workshop TRDs – Present & Future September, Romania Wafer Tester, Optical Link, GTU V. Angelov Kirchhoff.
SLAAC SV2 Briefing SLAAC Retreat, May 2001 Heber, UT Brian Schott USC Information Sciences Institute.
OPTO Link using Altera Stratix GX transceiver Jerzy Zieliński PERG group Warsaw.
Normal text - click to edit Configuring of Xilinx Virtex-II Kjetil Ullaland, Ketil Røed, Bjørn Pommeresche, Johan Alme TPC Electronics meeting. CERN
PCIe Mezzanine Carrier Pablo Alvarez BE/CO. Functional Specifications External Interfaces User (application) FPGA System FPGA Memory blocks Mezzanine.
GBT Interface Card for a Linux Computer Carson Teale 1.
LECC2003 AmsterdamMatthias Müller A RobIn Prototype for a PCI-Bus based Atlas Readout-System B. Gorini, M. Joos, J. Petersen (CERN, Geneva) A. Kugel, R.
Understanding Data Acquisition System for N- XYTER.
Design and Performance of a PCI Interface with four 2 Gbit/s Serial Optical Links Stefan Haas, Markus Joos CERN Wieslaw Iwanski Henryk Niewodnicznski Institute.
NIOS II Ethernet Communication Final Presentation
June 29th 2005Ph. BUSSON LLR Ecole polytechnique, Palaiseau1 Plans for a new TCC for the endcaps Characteristics: reminder Preliminary list of tasks and.
Volker Lindenstruth ( Kirchhoff Institute for Physics Chair of Computer Science University Heidelberg, Germany Phone:
By V. Koutsoumpos, C. Kachris, K. Manolopoulos, A. Belias NESTOR Institute – ICS FORTH Presented by: Kostas Manolopoulos.
DDL1 ALICE Detector Data Link (DDL) and it’s use in STAR TOF J. Schambach.
Bernardo Mota (CERN PH/ED) 17/05/04ALICE TPC Meeting Progress on the RCU Prototyping Bernardo Mota CERN PH/ED Overview Architecture Trigger and Clock Distribution.
Upgrade to the Read-Out Driver for ATLAS Silicon Detectors Atlas Wisconsin/LBNL Group John Joseph March 21 st 2007 ATLAS Pixel B-Layer Upgrade Workshop.
Takeo Higuchi (KEK); CHEP pptx High Speed Data Receiver Card for Future Upgrade of Belle II DAQ 1.Introduction – Belle II DAQ Experimental apparatus.
PCI B ASED R EAD-OUT R ECEIVER C ARD IN THE ALICE DAQ S YSTEM W.Carena 1, P.Csato 2, E.Denes 2, R.Divia 1, K.Schossmaier 1, C. Soos 1, J.Sulyan 2, A.Vascotto.
Agata Week – LNL 14 November 2007 LLP ATCA Carrier Status M. Bellato on behalf of the LLP Carrier Working Group.
1 SysCore for N-XYTER Status Report Talk by Dirk Gottschalk Kirchhoff Institut für Physik Universität Heidelberg.
A commercially available digitization system Fotiou Andreas Andreas Fotiou.
Control for CTP and LTU boards in Run
CPT week May 2003Dominique Gigi CMS DAQ 1.Block diagram 2.Form Factor 3.Mezzanine card (transmitter SLINK64) 4.Test environment 5.Test done 1.Acquisition.
H-RORC HLT-Meeting CERN 02/06/05 Torsten Alt KIP Heidelberg.
17/02/06H-RORCKIP HeidelbergTorsten Alt The new H-RORC H-RORC.
Marc R. StockmeierDCS-meeting, CERN DCS status ● DCS overview ● Implementation ● Examples – DCS board.
Rutherford Appleton Laboratory September 1999Fifth Workshop on Electronics for LHC Presented by S. Quinton.
ROM. ROM functionalities. ROM boards has to provide data format conversion. – Event fragments, from the FE electronics, enter the ROM as serial data stream;
17 October 2002Electronics DivisionViraj Perera RAL TCM, GIO, CAN & TTCRx Adam Davis.
Vladimir Zhulanov for BelleII ECL group Budker INP, Novosibirsk INSTR2014, Novosibirsk 2014/02/28 1.
ZHULANOV Vladimir Budker Institute of Nuclear Physics Novosibirsk, Russia Beijing
András László KFKI Research Institute for Particle and Nuclear Physics New Read-out System of the NA61 Experiment at CERN SPS Zimányi Winter School ‑ 25.
The ALICE Data-Acquisition Read-out Receiver Card C. Soós et al. (for the ALICE collaboration) LECC September 2004, Boston.
E. Hazen1 MicroTCA for HCAL and CMS Review / Status E. Hazen - Boston University for the CMS Collaboration.
Use of FPGA for dataflow Filippo Costa ALICE O2 CERN
AMC13 Project Status E. Hazen - Boston University
Novosibirsk, September, 2017
Ewald Effinger, Bernd Dehning
The Complete Solution for Cost-Effective PCI & CompactPCI Implementations 1.
GBT-FPGA Interface Carson Teale.
RCU3 –> RCU4 New Schematics
PCI BASED READ-OUT RECEIVER CARD IN THE ALICE DAQ SYSTEM
Commodity Flash ADC-FPGA Based Electronics for an
FEE Electronics progress
Presentation transcript:

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC H-RORC The HLT- Read-Out Receiver Card

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC H-RORC v2.0

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC Tasks Receiving of the raw detector data via optical links Injecting the data into the main memory of the hosts of the HLT front-end processors Sending processed data out of the HLT Pre-processing the data in the FPGA Reformatting and reordering of the data

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC Functionality RORC Core –Xilinx Virtex4 LX40 FPGA –Xilinx Platform PROM for configuration –Xilinx LogiCORE PCI 66MHz/64bit –2 x half CMC interface to two DIU cards RORC X-tend –4 x DDR-SDRAM 166/200 MHz up to 1Gb/module –PCI-X 133/64 –2 x TagNET : fast serial full-duplex links –“secure remote configuration” with FLASH and CPLD –“Ready for Linux” (FAST-Ethernet, RS232, Flash memory)

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC Core & X-tend XILINX VIRTEX4 LX40 DDR-SD TAGNET USER- FLASH CFG- FLASH PLATFORM PROM XC95144 CPLD CMC-Connector Power 1V2 Power 2V5 Power 1V8 TAGNET RS-232 ETH-PHY PCI-Power 3V3 MemoryConfiguration Serial links LVDS linksPOWER CMC-J11/J22 OSC PCI-66/64 - PCI-X 133/64

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC Core only XILINX VIRTEX4 LX40 DDR-SD TAGNET USER- FLASH CFG- FLASH PLATFORM PROM XC95144 CPLD CMC-Connector Power 1V2 Power 2V5 Power 1V8 TAGNET RS-232 ETH-PHY PCI-66/64 - PCI-X 133/64 PCI-Power 3V3 MemoryConfiguration Serial links LVDS linksPOWER CMC-J11/J22 OSC

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC TOP VIEW

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC BOTTOM VIEW

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC Verification The following tests have been successfully performed : - JTAG - PCI-33/32, PCI-33/64, PCI-66/32, PCI-66/64 - CMC-Connectors with DIU/SIU cards - Xilinx Platform PROM for configuration - Configuration with Flash & CPLD - DDR-SDRAM - TagNET The H-RORC passed CERNs Production Readiness Review in October 2005.

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC PCI DMA Write Performance Measured performance of DMA data cycles on the PCI bus. Theoretical bandwidth of a 64bit/66MHz PCI bus: 528 MByte/s For each DMA block length 10/100/1000/10000 transactions have been performed. The time for each transaction was measured by a counter with a 15ns granularity. The transmitted data was checked for errors: No errors occurred max. 2xDIU data rate

30/05/06 T. Alt – KIP HeidelbergHLT-PRR : H-RORC Summary & Sources The H-RORC is currently in production. A preproduction batch of 15 boards was received and is currently under testing. Schematics, Assembly and Bill of Materials can be found here H-RORC PRR related changes : 2 panel leds JTAG chain connected to PCI large capacitors removed from the backside to achieve PCI compliance power consumption needs to be observed for each design but was no problem up to now documentation is on the web