SUPERCAM LNA WITH THE 6LN2C MMIC 03/04/2009. 6LN2C CRY11-4332-085 1.5V 45mA.

Slides:

Advertisements

Similar presentations

Operational Amplifiers

Advertisements

1. Using the gain bandwidth product, find the bandwidth of the circuit below. Use the AOL curve and closed loop gain to graphically determine the bandwidth.

Chapter 10 Analog Integrated Circuits The 741 OP-AMP Introduction.

LNA Simulation Tutorial

1 A Low Power CMOS Low Noise Amplifier for Ultra-wideband Wireless Applications 指導教授 : 林志明學生 : 黃世一

Bipolar Junction Transistor Circuit Analysis

By Squadron Leader Zahid Mir CS&IT Department, Superior University PHY-BE -19 Transistor as an Amplifier.

Op-Amps (2). Non-Inverting Amplifier Design Problem Design a non-inverting op-amp with a gain of 6. What is the approximate power supply if Vin must.

C. Hutchens Chap 4 ECEN 3313 Handouts 1 Chapter 4 Bipolar Junction Transistors.

The Bipolar Junction Transistor

7.2 The Basic Gain Cell 7.3 The Cascode Amplifier

ELE 1110D Lecture review Common-emitter amplifier Some functions of transistors  Current-source  Emitter Follower  Common-emitter amplifier.

Design of RF CMOS Low Noise Amplifiers Using a Current Based MOSFET Model Virgínia Helena Varotto Baroncini Oscar da Costa Gouveia Filho.

Department of EECS University of California, Berkeley EECS 105 Fall 2003, Lecture 23 Lecture 23: Multistage Amps-Cascades and Cascodes Prof. Niknejad.

Fixed Gain Amplifier Used within the Feed Back Loop.

SUPERCAM SINGLE PIXEL BLOCK MEASUREMENTS HAMDI MANI 09/12/2008.

Class A Operating Mode Time I out One device conducts for the whole of the a.c. cycle. Conduction angle = 360 .

Low Power RF/Analog Amplifier Design Tong Zhang Auburn University Tong Zhang Auburn University.

1 Figure Class AB output stage. A bias voltage V BB is applied between the bases of Q N and Q P, giving rise to a bias current I Q given by Eq. (14.23).

Feed/Receiver Developments ATA-TAP December 17, 2002 WJW.

Low Noise Amplifier. DSB/SC-AM Modulation (Review)

An amplifier with a transistor that conducts during the entire 360º of the input signal cycle. Optimum class A operation is obtained by designing an amplifier.

A very gentle intro. The invention that changed everything… The real thingCircuit diagram symbol.

Electronic Amplifiers 1 शनिवार, 29 अगस्त 2015 शनिवार, 29 अगस्त 2015 शनिवार, 29 अगस्त 2015 शनिवार, 29 अगस्त 2015 शनिवार, 29 अगस्त 2015 शनिवार, 29 अगस्त.

B. BOUDJELIDA1 UMan LNA Programme 4 th SKADS Workshop, Lisbon, 2-3 October 2008 University of Manchester: Progress on LNA Programme B. Boudjelida, A. Sobih,

Bipolar Transistor Review

16 – 17 Jul 02Andrew Werner TRD Monitor Tube Readout Electronics: Shaping Peter Fisher, Bernard Wadsworth, Andrew Werner MIT 1.

Microwave Engineering, 3rd Edition by David M. Pozar

Study of 60GHz Wireless Network & Circuit Ahn Yong-joon.

An Ultra-Wide-Band GHz LNA in 0.18µm CMOS technology RF Communication Systems-on-chip Spring 2007.

TRANSISTOR.  A transistor is a semiconductor device used to amplify and switch electronic signals and electrical power.  The transistor is the fundamental.

ELEC 121 January 2004 BJT Fixed Bias ELEC 121 Fixed Bias.

Voltage Divider Bias ELEC 121. January 2004ELEC 1212 BJT Biasing 3 For the Voltage Divider Bias Configurations Draw Equivalent Input circuit Draw Equivalent.

3-1 McGraw-Hill Copyright © 2001 by the McGraw-Hill Companies, Inc. All rights reserved. Chapter Three The Bipolar Junction Transistor.

KFPA Noise Calibration Module and Coupler Eric W. Bryerton NRAO CDL (Charlottesville)

BJT Transistors and Characteristics ELEC 121. January 2004ELEC 1212 Introduction to BJT’s BJT Specification Sheets BJT Characteristic Family of Curves.

A NEW METHOD TO STABILIZE HIGH FREQUENCY HIGH GAIN CMOS LNA RF Communications Systems-on-chip Primavera 2007 Pierpaolo Passarelli.

What is an Amplifier…? An Amplifier is a device which takes small voltage at the input, amplifies it and produce higher voltage at the output. The gain.

POWER AMPLIFIER Class B Class AB Class C.

Introduction to BJT Amplifier BJT (Review). Still remember about BJT? The emitter current (i E ) is the sum of the collector current (i C ) and the base.

Op Amp Nonidealities (1) Section 8.4. Topics DC Offset Input Bias Current Speed Limitations Slew Rate Finite Input and Output Impedance.

Amplifiers Amplifier Parameters Gain = Po/Pi in dB = 10 log (Po/Pi)

Preamplifiers : BGA 2003 (Silicon MMIC amplifier): In general, the function of a preamp is to amplify a low-level signal to line-level. DESCRIPTION: Silicon.

Final Design Review of a 1 GHz LNA / Down-Converter Charles Baylis University of South Florida April 22, 2005.

3.TRANSISTOR CIRCUIT CONFIGURATION

Electronics Principles & Applications Fifth Edition Chapter 7 More About Small-Signal Amplifiers ©1999 Glencoe/McGraw-Hill Charles A. Schuler.

3-Stage Low Noise Amplifier Design at 12Ghz

Storey: Electrical & Electronic Systems © Pearson Education Limited 2004 OHT 21.1 Example – see Example 21.2 from course text Determine the quiescent output.

Differential voltage-gain device that amplifies the difference between the voltages existing at its two input terminal. An instrumentation (or instrumentational)

The Bipolar Junction Transistor

COURSE NAME: SEMICONDUCTORS Course Code: PHYS 473 Week No. 5.

Emitter-Stabilized Bias Circuit Load Line Analysis.

UOP ECT 246 Week 2 iLab Transistor Circuits Check this A+ tutorial guideline at

CHAPTER 10 AC Power Bipolar Junction Transistors: Operation, Circuit Models, and Applications.

MOSFET The MOSFET (Metal Oxide Semiconductor Field Effect Transistor) transistor is a semiconductor device which is widely used for switching and amplifying.

Input Stages for Radio Systems (Low Noise Amplifiers) (LNAs)

Lets Design an LNA! Anurag Nigam.

Basic MOS Amplifiers: DC and Low Frequency Behavior

Bipolar Junction Transistor

Technology Perspective and results with mHEMTs

Variable Gain CMOS LNA MOREIRA E SILVA, Paulo Marcio, DE SOUSA, Fernando Rangel Introduction Simulation.

SMALL SIGNAL ANALYSIS OF CB AMPLIFIER

SMALL SIGNAL ANALYSIS OF CE AMPLIFIER

Chapter 12 Power Amplifiers

How Boolean logic is implemented

Difference Between Voltage Amplifier and Power Amplifier

خطوط انتقال ، آنتن و انتشار امواج

Bipolar Junction Transistors

Chapter 15 Differential Amplifiers and Operational Amplifier Design

Presentation transcript:

SUPERCAM LNA WITH THE 6LN2C MMIC 03/04/2009

6LN2C CRY V 45mA

6LN2A CIT V 45mA

WBA13 CRY V 50mA

DC Bias Ig units uA

Current input board dimensions

Zsis :SIS Device Model SIS Junction IF circuit of SIS device THE WBA13 MMIC IS MATCHED TO THE OUTPUT OF THE SIS DEVICE

TRANSISTOR MODEL NGST 4x50um

Simulated Supercam With IMN and with Measured S-param of a WBA13 and 300K Blue curve :probed wba13 With modeled IMN Red Curve: wba13 packaged in an amplifier.

Simulated Supercam With IMN and with Measured S-param of a 6LN2B and 300K Pink Curve : probed 6LN2C with Modeled IMN. Black Curve: 6ln2c mounted on an amplifier.

Simulated noise OF SUPERCAM LNA WITH WBA13 and 6LN2B

MEASURED 300K NOISE WITH THE WBA13 / 6LN2C

SIMULATED NOISE AND

MEASURED 20K NOISE WITH THE WBA13 / 6LN2C

6LN2C ON SUPERCAM LNA SPARAM 300K