PRELIMINARY TEST PLANS 6/30/2015 Detailed Design Review 1.

Slides:



Advertisements
Similar presentations
Coriolis Technology.
Advertisements

Operating Nitrox Systems 11 Presented by Nuvair. Operating Nitrox Systems2 Membrane systems produce nitrox efficiently Compressed air flows through the.
General System Maintenance BUS 4 COMPONENT FLOW.PPT
38GXC(Q)/40GXC(Q) Service Training Sizes 18 and 24K.
Friday, May 14, 2004SOFC Durability Test Stand1 Team Delphi Corporation Solid Oxide Fuel Cell Durability Test Stand John Bagby Joshua Gannon Mechanical.
Ignition System Provides a method of turning a spark ignition engine on & off. Operates on various supply voltages (Battery & Alternator) Produces high.
MSD 1 P12453 Detailed Design Review Markus Holzenkamp Robin Leili Cody Anderson 5/17/2015 Detailed Design Review 1.
Presented by Jon Pannell
Sneha Rao – Project Manager Edward Budriss – ME Alex Scarangella – ME Edward Wolf – CE Anna Cheung – ISE.
6/10/2015SYSTEMS LEVEL DESIGN REVIEW 1 HEALTH-MONITORING OF A RECIPROCATING COMPRESSOR MSD1 – P12453 SYSTEMS LEVEL DESIGN REVIEW.
Rapid Pneumatic Transportation of Radioactive Samples System Steve Padalino & Ed Pogozelski SUNY Geneseo.
Data Acquisition Purpose: Support rocket testing, provide a meaningful method to collect and store data Acquired from P7110 Measure sensor outputs  Load.
Ventricle Chamber Valve Imaging Chamber ECG Machine Aortic Compliance Chamber Buffer Chamber Secondary Compliance Chamber Flow Meter Pressure Sensors DAQ.
Sensors used in EFI (Electronic Fuel Injection)
Table of Contents Team members Starting point Definition of problem Solutions System Overview Key Components Monitoring system Charging System Generator.
Handheld Flow Calibrator Progress Report MAE 126B | Project E5 May 31 st, 2013 Jonathan Ma, Yung Nguyen, Mario Zuniga presented by Project Advisor | Craig.
Chapter 19 Charging Systems.
Ice Pile Air Conditioning Joseph Cooper: Project Lead Kylie Rhoades, Clara Echavarria, Jonathon Locke, Alex Gee.
MINIATURE ENGINEERING SYSTEMS GROUP MINIATURE CENTRIFUGAL COMPRESSOR TESTING Presented by Dipjyoti Acharya.
EKT314/4 Electronic Instrumentation
RPC «REGMIK» 15582, Ukraine, Chernihiv region, Rivnopillya, Gagarin Street, 2B phone.: +38 (0462) , , , , +38 (050)
Pump is Blue part (right) - timer is black (left side) New Electrical Outlet This Photo shows where the Re-Cir pump is installed on the Output line on.
Boker Wright, Dan Lewis, Tina Foley and Brandon Wissel.
Air Conditioning in tropical climates Presented by Ranjeet Kumar Nayak.
BODHPS PROTOTYPE B Testing and Documentation of improved prototype with a record of power output.
DAQ Systems and Instruments for Hx Performance Testing and Periodic Monitoring.
Arsine Detection using Chemcassette ® Technology.
Polarn Flexi 8000 Kit The “Ideal” Cargo Heater Kit
The complete flow monitoring solution Measure – Display – Switch – Transmit.
Inputs/Givens 1.Volume of Ice (3.5 gal) 2.Density of Ice (736 kg/m 3 ) 3.Latent Heat of Ice, h sf (333.6 KJ/kg) 4.Melt time of 1 hour (3600 s) Constraints.
FMTV COOLING SYSTEMS 4/23/2017.
The oven given in the figure is heated with a heat source having the heat flow rate Q. The total heat capacity of all objects in the oven is C and the.
Automated Industrial Wind Tunnel Controller By Daniel Monahan and Nick DeTrempe Advised by Dr. Aleksander Malinowski.
PROJECT STATEMENT Dresser-Rand will be donating a single stage ESH reciprocating compressor for RIT use. The project objective is to safely install the.
Sneha Rao – Project Manager Edward Budriss – ME Alex Scarangella – ME Edward Wolf – CE Anna Cheung – ISE P09452.
06-November-2013 Thermo-Mechanical Tests BE-RF-PM Review of the CLIC Two-Beam Module Program Thermo-Mechanical Tests L. Kortelainen, I. Kossyvakis, R.
Measurement and Control. Control Systems A control system usually consists of a processor, a control program, interfaces and a device under the processor's.
PEP-II Machine Advisory Committee Meeting SLAC, April 15-17, 2004 HOM Issues in LER Ring and IR. Recent measurements and calculations. Sasha Novokhatski.
Alex Gee Jon Locke Joe Cooper Kylie Rhoades Clara Echavarria Ice Energy Extraction.
Chemical Engineering 3P04 Process Control Tutorial # 4 Learning goals 1.Discuss some common sensors (Flow already covered in Tutorial #1) 2.Continue to.
CatVTM Controled atmosphere Vibrating magnetometer.
CUE – Make Any Pump an E-Pump
First Mercury Test by Stuart Walker. Original Setup.
11/26/2008 Utility Water Hydro-Pneumatic Tank System & Recovery.
WP4: Instrumentation Tânia Melo Mendonça. 2 ISOLDE target unit Present target unit base at ISOLDE with 7 inlets (including ion source gas leak, heating.
ATCA cooling tests Claudio Bortolin (PH-ADO) Damian Dyngosz (PH-DT) George Glonti (PH-UAT) Julian Maxim Mendez (PH-ESE) Lukasz Zwalinski (PH-DT) xTCA IG.
System Level Block Diagram P16318 Lianna Dicke. P16318: Gaseous Mass Flow Rate Controller Level 1 Functional Block Diagram 1.0 System Processing 2.0 Mechanical.
SYSTEM LEVEL DESIGN REVIEW P16318 Gaseous Mass Flow Rate Controller Luke McKean, Lianna Dicke, Selden Porter, Schuyler Witschi ?
1 © Red Lion Controls Inc. Graphite HMI Series Graphite Series.
Mass Flow Sensor Integration Team 5: Beau Rodgers Luis Mendez Brian Roberts Keenan Cheeks Sponsored by: Danfoss Turbocor Advised by: Dr. Shih.
Practical experience with the AD Stochastic Cooling Murphy’s Law R. Louwerse.
Employment of scada system in water purification and transmission system.
10-meter Interferometer Results M. Woods (special thanks to Steve Myers and Tim Slaton) Jan. 31, 2000 Commissioning Setup System Noise Monte Carlo simulation.
1. Engineering 2. Purchasing 3. Other department package assistances 4. Site supervision Instrument Department Activities:
1 TRANSDUCER. 2 Contents To understand the basic concept of Transducer To learn about Block diagram of transducer Different Applications of transducers.
Automotive Engines Theory and Servicing
Transducers Topics covered in this presentation:
WHY? HOW? Test Valve Measure Vibrations Contain Valves
Chiller Energy Audit Welcome remarks TBD..
The Basic Direct Expansion Refrigeration Cycle
FIGURE 33-1 A typical fuel tank installation.
ITEMS TO CHECK ON Running Pumps
Heart Pump and Circulatory System
Instructions: Adding refrigerant fluid to system
P16452 Active Reciprocating Compressor Valve Assembly
Automotive Engines Theory and Servicing
Distribution Student Task
Presentation transcript:

PRELIMINARY TEST PLANS 6/30/2015 Detailed Design Review 1

Sensor Tests Means of testing sensor functionality SigLab Existing USB DAQ RIT DAQ 6/30/2015 Detailed Design Review 2

Flow Meter Verify the flow meter by referencing the specifications for the output of the coolant pump Run the coolant system without running the compressor 6/30/2015 Detailed Design Review 3

Rosemount Sensor Test Install pressure tubing Run Compressor without the sensor mounted on the base to isolate vibration Verify tank pressure to ensure no noise is added after the sensor is mounted on the vibrating frame Rosemount output can also be confirmed by using the shop compressed air as an input to the sensor 6/30/2015 Detailed Design Review 4

Thermocouples Each individual thermocouple output will be confirmed by comparing it with the known ambient temperature of the room The specific thermocouple will also be verified by comparing its output value to the expected value for each individual application 6/30/2015 Detailed Design Review 5

Encoder Test Cross reference the encoder with the 1X magnetic pickup – Both sensors should be reading the same frequency which will validate the position reading from the encoder 6/30/2015 Detailed Design Review 6

RIT DAQ Cross referencing sensor outputs with existing DAQs and Signal Analyzers Use USB DAQ to validate signals Use SigLab to validate signals Reference expected values to ensure proper sensor readings 6/30/2015 Detailed Design Review 7

Envision System Utilize the functionality of the RIT DAQ Use the functioning RIT DAQ to ensure the Envision System is displaying proper outputs RIT DAQ will already be cross referenced with alternative Signal Processors and validated 6/30/2015 Detailed Design Review 8