1 Lecture 7b DWDM 1. Introduction 2. Principles of Wavelength Division Multiplexing 3. WDM System Components 4. Wavelength-Independent Coupler 5. Construction.

Slides:

Advertisements

Similar presentations

NortelNortel's WDM System. Fiber-optic communications is based on the principle that light in a glass medium can carry more information over longer distances.

Advertisements

1 Fiber Optic Communications Systems From the movie Warriors of the Net Optical Time Division Multiplexing.

Data Communications and Networking

Note Bandwidth utilization is the wise use of available bandwidth to achieve specific goals. Efficiency can be achieved by multiplexing; privacy and.

Fiber Systems Dense Wavelength Division Multiplexing (DWDM) Alpina Kulkarni Optical Communications (EE566) Dr. Paolo Liu Electrical UB.

Building a Continuous Wave Erbium Doped Fiber Laser and Amplifier Ben Baker Kristen Norton.

Fiber-Optic Communications

EE 230: Optical Fiber Communication From the movie Warriors of the Net Lecture 8 Fiber Amplifiers.

Fiber-Optic Communications

1 Fall 2005 Long Distance Communication Carriers, Modulation, And Modems Qutaibah Malluhi Computer Science and Engineering Qatar University.

E D F A Seminar By: Geno G James EE-566 Optical Communication.

Optical Amplifiers An Important Element of WDM Systems Xavier Fernando ADROIT Group Ryerson University.

Dense Wavelength Division Multiplexing Theory. What we will cover WDM Overview Optical Fiber Transmission Characteristics Key technologies of DWDM Technical.

Wavelength Division Multiplexing

M ULTIPLEXING (M UXING ) In telecommunications and computer networks, multiplexing (also known as muxing) is a method by which multiple analog message.

NETE 0510 Presented by Dr.Apichan Kanjanavapastit

BASIC TELECOMMUNICATIONS

Technique for assuring that a transmitting entity does not overwhelm a receiving entity with data Necessary when data is being sent faster than it.

Poznan Supercomputing and Networking Center

Multiplexer Multiplexing FDM TDM WDM Front-End Processor Controllers.

1 The public switched telephone network (PSTN) is a combination of many central offices throughout the country and the world connected by copper cables,

MODULATION AIDA ESMAEILIAN 1. MODULATION  Modulation: the process of converting digital data in electronic form to an optical signal that can be transmitted.

1 Ch 6 Long-Distance Communication Carriers, Modulation, and Modems.

 What is fiber-optic communication?  Method of transmitting information from one place to another  Sending pulses of light through optical fiber 

Dense Wavelength Division Multiplexing (DWDM) Technology

William Stallings Data and Computer Communications 7 th Edition Chapter 8 Multiplexing.

Physical Layer Dr. Sanjay P. Ahuja, Ph.D. Fidelity National Financial Distinguished Professor of CIS School of Computing, UNF.

Chapter 10 Optical Communication Systems

1 Chapter 5 Multiplexing : Sharing a Medium Data Communications and Computer Networks: A Business User’s Approach.

CIS 321 – Data Communications & Networking Chapter 8 – Multiplexing.

Digital Transmission Outlines:- Multiplexing FDM TDM WDM

Optical Components/Devices

Lecture Note on Optical Components. Optical Couplers Combines & splits signals Light couples from one waveguide to a closely placed waveguide because.

Optical telecommunication networks.  Introduction  Multiplexing  Optical Multiplexing  Components of Optical Mux  Application  Advantages  Shortcomings/Future.

In The Name Of Allah The Most Merciful The most Beneficial…

Components for WDM Networks

5211 Data Comm 1 Paul Weingartner Presentation #2.

Chapter 6 Multiplexing.

Multiplexing. Multiplexing is the set of techniques that allows simultaneous transmission of multiple signals across a single link.

Lecturer: Tamanna Haque Nipa

Communications Equipment Communication Equipments: –Equipments that are, Not a direct part of the network (like node, client, terminal, server etc.) but,

Data and Computer Communications by William Stallings Eighth Edition Networks and Communication Department 1 Multiplexing Click to edit Master subtitle.

11-Mar-16Physical Layer Multiplexing Multiplexing is the set of techniques that allows multiple signal transmission across a single medium at the same.

Presented by, G.RajMohan I Year M-Tech. WHY WDM? Capacity upgrade of existing fiber networks (without adding fibers) Transparency: Each optical channel.

Introduction to Communication Lecture (07) 1. Bandwidth utilization Bandwidth utilization is the wise use of available bandwidth to achieve specific goals.

Mohammad Sakib Ullah Summit Communications Limited NOC Date:05/03/2016

--PRESENTED BY DEEPAK KUMAR VERMA DEPT - ECE SEM - 6 TH ROLL UNDER THE GUIDENCE OF…. Mr. SUDIP KUMAR GHOSH (Asst.Prof.Dept. of ECE)

Outline  Introduction (Resource Management and Utilization).  Compression and Multiplexing (Other related definitions).  The Most Important Access Utilization.

Subject Name: Optical Fiber Communication Subject Code: 10EC72 Prepared By: Sreepriya Kurup, Pallavi Adke, Sowmya L(TE) Department: Electronics and Communication.

Courtesy from Significant Technologies Sdn Bhd LIGHT SOURCE & POWER METER/ PASSIVE DEVICES.

Bandwidth Utilization (Multiplexing and Spectrum Spreading)

Lecture # 18 Data Communication Muhammad Waseem Iqbal.

Bandwidth Utilization: Multiplexing and Spreading

4.3 Multiplexing Outlines FDM TDM.

by: Mrs. Aboli N. Moharil Assistant Professor, EXTC dept.

Multiplexing : Sharing a Medium

Design and Simulation of Photonic Devices and Circuits

Chapter 6 Multiplexing.

Multiplexing Multiplexing is the set of techniques that allows the simultaneous transmission of multiple signals across a single data link. A Multiplexer.

Making Networks Light March 29, 2018 Charleston, South Carolina.

Lecture 8: Multiplexing

POORNIMA INSTITUTE OF ENGINEERING AND TECHNOLOGY

By Engr: S Rehan ali shah

DATA COMMUNICATION Lecture-29.

B. Sc.Eng, M.Sc., C.Eng., FIE(SL), FIEE(UK), FBCS(UK), CITP, MIEEE

Overview of WDM Upgrade Capacity of fiber

Chapter 6 Multiplexing.

Fiber Optic Transmission

Slab waveguide solution

Bandwidth Utilization: Multiplexing

Presentation transcript:

1 Lecture 7b DWDM 1. Introduction 2. Principles of Wavelength Division Multiplexing 3. WDM System Components 4. Wavelength-Independent Coupler 5. Construction of Wavelength Independent Couplers 6. Wavelength-Dependent Coupler (Multiplexer/Demultiplexer) 7. WDM Communication System 8. Dense Wavelength Division Multiplexing (DWDM) 9. Add-drop Multiplexer 10. Conclusion 11. Appendix

2 Time Division Multiplexing (TDM) Wavelength Division Multiplexing (WDM) TDM divides a high-bandwidth transmitted signal into time slots. Each time slot carries a different low-bandwidth signal. In WDM, several high-bandwidth signals travel on the same fiber, in the same time, each using a different light wavelength. DWDM uses the same principles as a WDM, but with high density of light wavelength alocation. A common application of multiplexing is in long- distance data and voice communications.

3 Access techniques for mobile communications P - Power T - Time F - Frequency P T P T F P T F FDMA (TACS) TDMA (GSM, DECT) CDMA (UMTS) F ATDMA (UMTS)

4 Principles of Wavelength Division Multiplexing (WDM)

5 WDM System Components A coupler combiner, and a splitter, Couplers are bi-directional devices; Wavelength Independent Wavelength Dependent

6 Wavelength-Independent Coupler

7 Input power = 1 mW Splitting ratio of each coupler = 9:1 Excess loss of each coupler = 0.3 dB Insertion loss of each connector = 0.2 dB The input power is 1 mW, so we can express the power as zero decibel milliwatts (0 dBm). The incoming power level to first splitter is reduced by 0.2 dB by the first connector, and 0.3 dB by the excess loss. At the first splitter, we have total power of dBm, or:

8 Construction of a Wavelength Independent Coupler

9 Wavelength-Dependent Couplers (Multiplexer / Demultiplexer)

10 (8.5)

11

12 WDM Communication System (8.6)

13

14 Several modulated laser sources, one for each optical channel. A Distributed Feedback (DFB) laser is the best source for a DWDM system, narrow bandwidth, (less than 0.4 nm). Modulation Erbium Doped Fiber Amplifier (EDFA), An optical demultiplexer to separate each signal at its destination. Suitable detectors for each signal to extract the information in that. A DWDM system can be designed with 41 channels in the range of 1528 nm to 1561 nm. DWDM can increase the capacity of a single fiber to as much as several hundred gigabits per second. This is the same capacity as several thousand 100Base-T Ethernet cables.

15 Stimulated Emission nm -1 mks Short- wavelength Source (980 nm) Longer- wavelength Source (1480 nm) Excited erbium atoms at high energy level Atoms at metastable energy (-10 ms) Erbium atoms at low energy level