HANDLE JOG MODE The HAAS Control Series

PRESS THREE TIMES TO GET TO THIS PAGE (Continued on next slide) Note: SLIDE LEGEND ACTIONS INSTRUCTIONS KEYS INFORMATION To advance through the presentation click on your left mouse button or press. To exit press. OTHER INFORMATION

HANDLE JOG MODE This module is intended to provide you with a familiarization of the Handle Jog Mode on the Haas Control

Here is where you find the Handle Jog Buttons

Pressing the Handle Jog button on the control will display the Position screen. Used to manually move the machine axes by using the Jog Keys or the Hand Wheel. Handle Jog Buttons HANDLE JOG: : : : :

Handle Jog Button: Press This will bring up the Position screen that will allow you to move the machine axes by using the Jog keys or the Hand wheel. If you select the DIST- TO-GO display, it will zero all axes when you select the Handle Jog Mode of operation. POSITION (EDIT) O91002 F1 KEY TURNS MENU ON/OFF (OPERATOR)(WORK G54) X inX in Y inY in Z inZ in (MACHINE)(DIST TO GO) X inX in Y inY in Z inZ in JOGGING FEED 1.

Resolution/Feed Rate Buttons: These four keys select Hand wheel Resolution and the Jog Feed Rate. The number on the top indicates Hand wheel Resolution. (Amount of movement per click) The number on the bottom indicates the Jog Feed Rate in inches per minute when using the Jog keys. An axis must be selected for movement to occur. POSITION (EDIT) O91002 F1 KEY TURNS MENU ON/OFF (OPERATOR)(WORK G54) X inX in Y inY in Z inZ in (MACHINE)(DIST TO GO) X inX in Y inY in Z inZ in JOGGING FEED 1.

Handle Jog: While jogging the machine, the FEED RATE OVERRIDE buttons will adjust, in increments of +/-10%, the feed rate that is programmed into the control. The Hand Wheel can be used to adjust, in increments of 1%, the feed rate that is programmed into the control.

Handle Jog: With the spindle running, the SPINDLE OVERRIDE buttons will adjust, in increments of +/-10%, the speed that is programmed into the control. The Hand Wheel can be used to adjust, in increments of 1%, the speed that is programmed into the control.

Handle Jog: The JOG LOCK key will cause the axes you are jogging to continue jogging. Press then press the axis key you want to jog. While in motion, you can switch axis by pressing the axis you want to move. Motion will stop by pressing, or.

Prepared by Haas Automation Training Department Oxnard, CA 93030