Phase Change Review. Where on the curve is the potential energy changing? a.A, B, C b.B-C, C-D, E-F c.A-B, C-D d.B-C, D-E.

Slides:



Advertisements
Similar presentations
Liquids and Solids Water.
Advertisements

A-B = Solid ice, temperature is increasing. Particles gain kinetic energy, vibration of particles increases. Heating and cooling curve for water heated.
I. Kinetic Molecular Theory KMT
Section 12.4: Phase Changes
Agenda: Thermochemistry Heating & Cooling Curves – a review Graphing temperature change Phase Change Diagrams Why are some compounds liquids and gases.
Chapter 14 Liquids and Solids. Three types of bonding between atoms Covalent – electrons shared between nonmetal atoms, forms molecules or covalent crystal.
Unit 10 States of Matter and Gases. Phase Changes A phase change is a change in the state of matter During a phase change there is no change in temperature.
Aim: How to measure energy absorbed during a phase change
Bond - Attraction within a molecule Bonding forces - attractive forces outside and between molecules.
Welcome to Chem 2010 General chemistry (I) For third Level Chemistry, Biology and Physics Departments Chapter 8 1.
Chapter 11 intermolecular forces- attractive forces between all molecules and atoms -these forces hold phases of matter together -strength of intermolecular.
Heating and Cooling Curve Definitions: Specific Heat: Amount of energy required to raise the temperature of 1 gram of a substance by 1⁰ Celsius Enthalpy.
For this heating curve, energy was added at a constant rate. This is obvious in regions where the temperature steadily increases (AB ; CD ; EF). In these.
1 CHAPTER 4. Energy Energy is the capacity to do work. Potential energy is stored energy. Kinetic energy is the energy of motion. The law of conservation.
Section 12.4 Phase Changes (cont.)
Energy Requirements for changing state: In ice the water molecules are held together by strong intermolecular forces. The energy required to melt 1 gram.
States of Matter Chapter 13. Matter  Let’s get to the heart of it…  The particles are in constant motion.
Intermolecular Forces Forces Between Molecules. Why are intermolecular forces important? They determine the phase of a substance at room temperature.
FINAL EXAM Wednesday,December 11, at 10:15 a.m. – 12:15 p.m. in the IC building, Room 421.
H 2 O (s) H 2 O (  ) H 2 O (g). Heat & Changes of State.
Chapter 11. A substances state of matter depends on two things: The average kinetic energy of the particles (temperature) The strength of the intermolecular.
Heat: Phase Change. 'change of phase' 'change of state'. The term 'change of phase' means the same thing as the term 'change of state'. o These changes.
H 2 O (s) H 2 O (  ) H 2 O (g). A-B = Solid ice, temperature is increasing. Particles gain kinetic energy, vibration of particles increases. Heating.
Unit 8 - liquids and solutions
A. A graph of the temperature of the system versus the amount of heat added (or temp vs time if the heat is added at a constant rate) is called a ______.
Chapter 12 Liquids, Solids, and Intermolecular Forces.
Intermolecular Forces, Liquids, and Solids Chapter 11 Brown-LeMay.
Energy Energy is defined as having the ability to do work Energy allows objects to move and to change Walking, lifting, chemical reactions, etc. involve.
Preview Lesson Starter Objectives Structure of Water Physical Properties of Water Chapter 10 Section 5 Water.
States of Matter Water. States of Matter  Objectives  Describe the structure of a water molecule  Discuss the physical properties of water. Explain.
Energy and Phases.  Potential Energy - stored energy (stored in bonds, height)  Kinetic Energy - energy of motion, associated with heat.
Chapter 14 Liquids and Solids. Phase changes and temperature Normally when heat is added the temperature goes up. However when you hit a phase change.
Ch. 11 States of matter. States of Matter Solid Definite volume Definite shape Liquid Definite volume Indefinite shape (conforms to container) Gas Indefinite.
Objectives To learn about dipole-dipole, hydrogen bonding and London dispersion forces To understand the effect of intermolecular forces on the.
Why do some solids dissolve in water but others do not? Why are some substances gases at room temperature, but others are liquid or solid? The answers.
Heating Curves. Energy and Phase Change When adding heat to a solid, energy added increases the temperature and entropy until the melting point is reached.
Intermolecular Attractions and the Properties of Liquids and Solids.
Phase Changes in Water AIM: How does the Atmosphere store energy?
A.A B.B C.C D.D Section 3-2 Section 3.2 Assessment When one substances turns into another, what kind of change has taken place? A.chemical reaction B.physical.
CHEMISTRY Nov 16, Warm Up Name the different phase changes of a matter –For example: Solid  Liquid (Melting)
Intermolecular Forces Forces Between Molecules. Why are intermolecular forces important? They determine the phase of a substance at room temperature.
Chapter 12 Liquids, Solids, and Intermolecular Forces.
Energy Changes & Phase Changes. It takes energy to heat stuff up! For pure substance in single phase, can calculate how much using Q = mC  T For pure.
Energy and Phase Changes. Energy Requirements for State Changes To change the state of matter, energy must be added or removed.
Solids, Liquids, and Gases Notes. I. How do solids and liquids differ from gases? Solids – intermolecular forces are sufficiently strong relative to kinetic.
Phase Changes.  A PHASE CHANGE is a reversible physical change that occurs when a substance changes from one state of matter to another  The temperature.
Lesson Starter How would the water molecule’s structure affect the properties of water? How will hydrogen bonding influence the properties of water? Section.
Why do some solids dissolve in water but others do not? Why are some substances gases at room temperature, but others are liquid or solid? The answers.
Why do some solids dissolve in water but others do not? Why are some substances gases at room temperature, but others are liquid or solid? The answers.
Aim: How to measure energy absorbed during a phase change DO NOW: 1. A g piece of iron absorbs joules of heat energy, and its temperature.
UNIT 7-Part C: Intermolecular Forces (IMF’s) and Phase Changes.
CHAPTER 14: LIQUIDS AND SOLIDS.  Condensed State- substances in these states have much higher densities than they do in the gaseous state CONDENSED.
CH 13 Random Questions. Energy & Phase Changes Heat absorbed = endothermic Heat released = exothermic.
Agenda: Thermochemistry Heating & Cooling Curves – a review Graphing temperature change Phase Change Diagrams Why are some compounds liquids and gases.
REVIEW 1.Write a formula for the freezing of water. 2.Write a formula for the boiling of water. 3.Write a formula for the condensing of water. 4.Write.
Solids, Liquids, and Gases States of Matter. Solids, Liquids, Gases Solids - Atoms and molecules vibrate in a stationary spot Liquids – atoms and molecules.
Ch Solids & Phase Changes. Solids The particles of a solid are more closely packed than those of a liquid or gas. Intermolecular forces between.
States of Matter Test Review. Heating Curve for Water What is the explaination of the “flat” segements on the graph? Simulation B A C D.
Phases of Matter, Bonding and Intermolecular Forces
Heating Curve Turk.
States of Matter.
Phase Changes “It’s just a phase”.
Phase Changes.
Chapter 11 – Liquid and Intermolecular Forces
Heat and Phases -Heat energy is related to the motion of the atoms and molecules – more heat energy means faster moving atoms and molecules and less heat.
Intermolecular Forces
8.3 Phases and Phase Changes
Chapter 10 Properties of Solids and Liquids
Chapter 8 Phase Changes.
Phase Diagram for Water
Presentation transcript:

Phase Change Review

Where on the curve is the potential energy changing? a.A, B, C b.B-C, C-D, E-F c.A-B, C-D d.B-C, D-E

What is the total number of joules of heat energy absorbed by 15 grams of water when it is heated from 30°C to 40°C? a. 10 b. 63 c. 150 d. 630

The phase changes B → C and D → E are not associated with temperature increases because the energy is used to a. increase the velocity of molecules b. break bonds between atoms c. rearrange atoms within molecules d. increase the density of the sample e. break intermolecular forces

How much energy(kJ) is required to convert a 15.5 g water at 5.0 o C to water vapor at 180 o C? a. 56 b. 9.0 x 10 3 c. 11 d. 44 e. 27

At this point, the substance represented by the phase diagram will be undergoing sublimation. a.A b.B c.C d.D e.E

This point represents a boiling point of the substance a.A b.B c.C d.D e.E

When a substance undergoes a phase change from liquid to solid, which of the following will occur? a. Energy will be released by the substance because intermolecular forces are being weakened. b. Energy will be released by the substance because intermolecular forces are being strengthened. c. Energy will be absorbed by the substance because intermolecular forces are being weakened. d. Energy will be absorbed by the substance because intermolecular forces are being strengthened. e. The energy of the substance will not be changed.

During which of the following phase changes must heat be added to overcome intermolecular forces? I. Vaporization II. Sublimation III. Deposition a. I only b. II only c. I and II only d. I and III only e. III only

In which of the following are the intermolecular forces listed from the weakest to strongest? a. Dipole-dipole > LDF > hydrogen bonds b. LDF < dipole-dipole < hydrogen bonds c. Hydrogen bonds < dipole-dipole < LDF d. LDF < hydrogen bonds < dipole-dipole

C 30 H 62 is a nonpolar compound that is a solid at room temperature, and water is highly hydrogen bonded but is a liquid because a. water molecules are very light. b. water molecules ionize easily. c. the 62 hydrogen atoms in C 30 H 62 allow for many instantaneous dipoles that exceed the attractive force of a hydrogen bond. d. C 30 H 62 is so large that it cannot melt. e. C 30 H 62 has a lower melting point if dissolved in nonpolar hexane.

A liquid substance that exhibits low intermolecular attractions is expected to have a. Low viscosity, low boiling point, and low heat of vaporization b. High viscosity, low boiling point, and low heat of vaporization c. Low viscosity, high boiling point, and low heat of vaporization d. Low viscosity, low boiling point, and high heat of vaporization e. High viscosity, high boiling point, and high heat of vaporization

Calculate the amount of heat required to completely convert 50 g of ice at -10 ºC to steam at 120 ºC. a.27.2kJ b.137kJ c.154kJ d.24kJ

Which contains more energy, water at 100 o C or steam at 100 o C? a.Water b.Steam c.They both contain the same amount of energy d.Not enough information to determine