AUTOMATIC PLANT WATERING SYSTEM CREATED BY: KOOSHA DANESHI, CHAO JIANG, ALASTAIR FRASER.

Slides:

Advertisements

Similar presentations

Water & Wastewater Construction Back Forward Wastewater Treatment Plant and Pump Station Improvements, Haverhill, MA.

Advertisements

10 Ways to Ruin Your Mini-Max microcontroller (and lose $69)

Using three IR sensors, SensingBot can sense the front obstacles so it can avoid them. Sensing.

ELECTRONIC STICK FOR BLIND PEOPLE

EML 2023 – Motor Control Lecture 4 – DAQ and Motor Controller.

ELECTRICAL. Circuits Outline Power Hub Microcontroller Sensor Inputs Motor Driver.

Motor Control of an Oscillating Pendulum Nick Myers and Chirag Patel March 9, 2004 Advised by: Dr. James Irwin and Mr. Jose Sanchez Bradley University.

Embedded Programming and Robotics Lesson 1 Basic Electricity and Electronics Transistor Basics Lesson 1 -- Basic Electricity1.

 Main Components:  Sensors  Micro controller  Motor drivers  Chasis.

Microprocessors Tutorial 2: Arduino Robotics

HI-WIRE Haptic Interface With Intuitive Robot Control.

Probe12 Sap Velocity based Sap flow logger & Irrigation Scheduler.

Sensors. This is a set of transmitter and receiver in one of the photoelectric sensor. Detection distance can be adjusted according to the requirements.

Annie Ly Lawrence Cagatin EE485 Spring 2012 Tuffy Medical Devices.

AUTOMATIC IRRIGATION INTRODUCTION Now a days always engaged people cannot get time sufficiently. This project is mint for conservation water as well.

Physics Chapter 20: Circuits and Circuit Elements.

HEAT SEEKER Eduardo Lichtenfels Riccio Oral Presentation IMDL – January 30,2014.

Golf Course Irrigation

1 Reading Electrical & Refrigerant Drawings. 2 General An electrical drawing shows the components of the circuit as simplified standard symbols, and the.

Smart Plant Robot Prepared by Haya De’bas Jumanah Salhab Supervisor Dr. Ra’ed Al-Qadi.

Presentation of the DriveLab Board Opal-RT Real-time institute 2009.

Arnan Sipitakiat Dept. Compute Engineering, Chiang Mai University.

Schematic Diagrams & Circuits

4.2.3B Electrical Power What About Watts?. Power Law Moving electrons (current) requires ENERGY How much energy gets used depends on: Strength of push.

INC 112 Basic Circuit Analysis Week 2 Kirchhoff's laws.

DESIGNING A TEMPERATURESENSOR DESIGNING A TEMPERATURE SENSOR We will be using the following format for designing this circuit: CONTROLOUTPUTINPUT.

Remote Controlled Submarine Students Osama Naji Abu-Omar Hakam Marwan Risheh Supervisor Dr. Luai Malhis An-Najah National University Computer Engineering.

Requirements concerning the interface linking the BPM to the quadrupole M. Wendt, S. Zorzetti.

Microprocessors Tutorial 2: Arduino Robotics. Agenda 1. Robot Anatomy 2. Sensor Review 3. PWM 4. MAKE: Fade 5. Motors 6. H Bridge 7. Robot Control library.

ELECTRONIC SYSTEMS ENGINEERING TECHNOLOGY TEXAS A&M UNIVERSITY Innovating tomorrow’s products and systems today Krisys Technology Krisys Robot Sensor Board.

MOTORS. Definition Of Motor That powered by electricity or internal combustion, that supplies motive power for a vehicle or for some other device. A device.

Basic Electronics for Arduino -basic electronics -arduino related stuff -tips and tricks Rob Zimmermann 2015.

Soil moisture sensor sm-300. Contents Introduction Features SM300 working procedure Installation Calibration Specification.

PIC18F4431. PIC18F1330 Infrared Encoder/Decoder.

 Today we will cover:  Voltage regulators  Sensors  motordrivers iBOT1.

System Level Block Diagram P16318 Lianna Dicke. P16318: Gaseous Mass Flow Rate Controller Level 1 Functional Block Diagram 1.0 System Processing 2.0 Mechanical.

Throttle Arduino RC Receiver Stock Golf Cart Motor Controller Motor 1 PWM signal: Voltage: 0 – 5V Period = 22ms Positive Pulse Width: 1ms – 2ms Digital.

Automatic Fire Fighting System Athan Jefferson Advisor Dr. Junkan Ma Instructor Dr. Cris Koutsougeras ET 493 Senior Design I.

Lianna Dicke MOTOR HARDWARE BREAKDOWN. Design Goals: Drive DC motor that draws 5 A maximum continuous current Voltage operation at 12 Volts (automotive)

Simple Water Level Controller Circuit with Microcontroller and Alarm.

Bdps 2 Lecture 2. Circuits and Ohm's Law For resistive circuits.

Microcontroller (At89s52) LCD Display(16x2) Soil Moisture Sensor (semiconductors) Pumping Motor (or a bulb) Power Supply Kiel U vision Express PCB.

Project #1 Smart Sprinkler Robot System. Introduction.

Arduino Application: Speed control of small DC Motors

Welcome. Automation system By, Ms. Akshata G. Mane Ms. Prachi D. Jadhav.

1 Transistor. 2 Transistors are used to turn components on and off They come in all different shapes and sizes.

SMART HOME SYSTEM. Group Members Shakib Muazzam (CSE) Jamil Arifin (EEE) Azima Islam Fariha (CSE) Abed Al Shihab

1 Sensors and Switches... WHAT’S IN THE BOX? 2 Sensors and Switches... SENSORS, CORDSETS & PROX SWITCHES.

ARDUINO UNO The Arduino uno is a microcontroller board based on the ATmega328. It has 14 digital Input / Output pins (of which 6 can be used as PWM outputs),

1. How much current flows if you connect a ohm resistor to a 12

H-Bridge Motor Driver.

XBee Based Motor Control for Farmers

connect a DC-Motor with an arduino

Arduino Development for Beginners

Engineering Science Systems and Control.

Interfacing different devices & considerations

Name Of The College & Dept

Project Renovatio Joshua Fraser Alastair Fraser Ruofei Fu Chao Jiang

The schematic of the wire connection in the module

Systems and Control.

Systems and Control.

Requirements and Verification

05 | Integrating Advanced Sensors and Shields

Presentation transcript:

AUTOMATIC PLANT WATERING SYSTEM CREATED BY: KOOSHA DANESHI, CHAO JIANG, ALASTAIR FRASER

PROJECT DESCRIPTION/SPECIFICATIONS We wanted to create a system using Arduino to measure the moisture levels of multiple plants and to effeciently deliver water to them.

REQUIRED PARTS AND COST Soil Moisture Sensor x4 Mini Water Pump X4 L298 Dual H-Bridge Motor Driver x2 AC/DC Power Adapter 4mm Pipe for Pump x4 Sensor Shield Total Cost: $54.60

MOISTURE SENSOR Uses two probes to pass current through the soil and then reads the resistance to get the moisture level. Power: 3.3 V or 5 V Output voltage signal: V Current: 35 mA

ARDUINO AND SHIELD

AC/DC ADAPTER Supplies additional current to the driver for the pumps.

PUMP DRIVERS Provides up to 2 A each for the two connected pumps Controlled by switching high and low states on a pin on the Arduino

PUMPS Draw 1.76 A and between 3 to 9 V

QUESTIONS?