AR2FL/S and No/Lo Gain followup Campion Anton Mitch.

Slides:



Advertisements
Similar presentations
NFC Forum Measurements
Advertisements

E. Atkin, E. Malankin, V. Shumikhin NRNU MEPhI, Moscow 1.
Antenna Booster. What is antenna booster? A device used to amplify the signal received (by ratio) by the antenna before feeding to the television receiver.
FE electronic box Construction of end piece OT module Electronic components Mechanics Cooling.
Calibration of the VA2 B Pal, R Mountain, M Artuso 6/29/2010 Goal: get an absolute calibration of a VA2 channel to measure diamond charge collection.
Belle II numbering x y z x y z. Electronics mapping (rawdata) row: carrier level, 0-3. column: daughter card slot, 0-3. channel: channel on ASIC, 0-7.
Power supply cable Charge injection 3 channels readout (external cables to the scope) 3 channels readout (internal cables) Set up for reading two cards.
AR1FS Debugging Guide Critical Components Mitch Newcomer August
MICE RF TEST STAND Major Milestones (2006) –Testing of BURLE 4616 circuit September 2006 –Testing of 4616 circuit with full amplitude and phase control.
July 10, 2008 PHENIX RPC review C.Y. Chi 1 RPC Front End Electronics On chamber discriminator  The strips  The CMS discriminator chips  The discriminator.
Active Roof Repair Aids1 AR1FS Debugging Guide Critical Components Mitch Newcomer Feb 2005 **Note that this is a work in progress and will be updated from.
AR2FL July 22, 2004 Anton, Campion, Mitch. Remaining Issues / Status One AR3FL board was stuffed in April by Godwin has been examined carefully. All locations.
End Cap Board Testing Status at Penn July 14, 2004 Anton & Campion Mitch.
Mixed Analog and Digital Circuit Boards for the ATLAS TRT Nandor Dressnandt, Godwin Mayers, Toni Munar, Mitch Newcomer, Rick Van Berg, Brig Williams University.
B wheel Board Gain Differences Mitch Newcomer May 5, 2005.
Active Boards Grounding and Shielding at Penn Near Term Plan for Barrel Boards –In parallel to board layout verification Study /optimize / map noise with.
Data Read Noise on AR1BL. AR1BL On Detector Noise Investigation Modified ARBL K0008 to reduce clock and data read pickup. Confirmed most conclusions from.
A High-speed Adaptively-biased Current- to-current Front-end for SSPM Arrays Bob Zheng, Jean-Pierre Walder, Henrik von der Lippe, William Moses, Martin.
RLRL ~ e(t) + v R (t) - Diode Rectifier + v d - vdvd.
ATF2 Q-BPM System 19 Dec Fifth ATF2 Project Meeting J. May, D. McCormick, T. Smith (SLAC) S. Boogert (RH) B. Meller (Cornell) Y. Honda (KEK)
AMY Meeting. 24 Mar 2011 status Auger Lecce Meeting,
Development of Readout ASIC for FPCCD Vertex Detector 01 October 2009 Kennosuke.Itagaki Tohoku University.
Performance test of STS demonstrators Anton Lymanets 15 th CBM collaboration meeting, April 12 th, 2010.
Timing Jitter and Cross Talk in the SRS + Xray scan of FIT zigzag board Michael Phipps, Bob Azmoun, and Craig Woody 1.
A 72 Channel 125 MSPS Analog-to-Digital Converter Module for Drift Chamber Readout for the GlueX Detector G. Visser 1, D. Abbot 2, F. Barbosa 2, C. Cuevas.
Gunther Haller SiD LOI Meeting March 2, LOI Content: Electronics and DAQ Gunther Haller Research Engineering Group.
Outer Tracker meeting NIKEF 27 July Dirk Wiedner Status of the OT readout electronics in Heidelberg Dirk Wiedner, Physikalisches Institut der Universität.
Readout ASIC for SiPM detector of the CTA new generation camera (ALPS) N.Fouque, R. Hermel, F. Mehrez, Sylvie Rosier-Lees LAPP (Laboratoire d’Annecy le.
AIDA FEE64 development report August 2010 Progress after Texas CAD work Manufacturing 25th August
B.Satyanarayana, TIFR, Mumbai. Architecture of front-end ASIC INO Collaboration Meeting VECC, Kolkata July 11-13, Amp_out 8:1 Analog Multiplexer.
Performance of a 128 Channel counting mode ASIC for direct X-ray imaging A 128 channel counting ASIC has been developed for direct X-ray imaging purposes.
Network Analyzers From Small Signal To Large Signal Measurements
Mar. 18, 2009 HAPD ASIC Status Super KEKB Meeting 1 S.Nishida (KEK) S. Nishida HAPD ASIC Status Super KEKB Meeting Mar. 18, 2009 KEK.
Confidential MN Problem report
HB LED Pulser Boards By Michael Miller The University of Iowa.
AIDA design review Davide Braga Steve Thomas ASIC Design Group 11 February 2009.
Front End Board (16 channels) Superlayer Cross Section Frontend Enclosure HV cap board HV cap Board Signals from chamber wires go to HV cap board to be.
Bottom half – ch 0-5 placed & routed FE PS PROC FIFO TRIG OSC RX/SHAP ADC DAC VME.
FE electronic box Construction of end piece OT module Electronic components Mechanics Cooling.
SCROD CAL buffer test results The buffer was fed with sinewave in range 150 – 750 MHz, and first the input and then the output were measured on scope for.
Status of MAPMT FEE Electronics Boards Connector board – have 5 boards, 1 assembled Readout board (“MUX” board) – layout completed 12/2, but unfortunately.
D. Attié, P. Colas, E. Delagnes, M. Riallot M. Dixit, J.-P. Martin, S. Bhattacharya, S. Mukhopadhyay Linear Collider Power Distribution & Pulsing Workshop.
May E906 Work and Status TDC readout – One full TDC board, 4 ECL cables/modules KTEV UCLA LV PS – Thanks Dave N.! – +/- 5V, 18A each – Spade /10-12AWG.
Update on works with SiPMs at Pisa Matteo Morrocchi.
SPIROC ADC measurements S. Callier, F. Dulucq, C. de La Taille, M. Faucci, R. Poeschl, L. Raux, J. Rouenne, V. Vandenbussche.
Front End. Charge pre-amp and detector Voltage regulator. TOP side. Detector linear voltage regulator BOTTOM side. Charge pre-amp.
PADME Front-End Electronics
STATUS OF SPIROC measurement
Setup for automated measurements (parametrization) of ASD2 chip
Inverting and Non-inverting Op-Amp
on behalf of the AGH and UJ PANDA groups
CTA-LST meeting February 2015
TDR Measurement of MCP Anode
KRB proposal (Read Board of Kyiv group)
BNL electronics: first tests
AGATA Detector Work Performed at Saclay in lessons learned -
HV-CMOS Update The properties device (HVStripV1) we just Birmingham
Power pulsing of AFTER in magnetic field
Calibration On pixel calibration capacitor; 20fF
New Discriminator Board Test
Electronics: Demod + 4Q FE
Christophe Beigbeder/ ETD PID meeting
STATUS OF SKIROC and ECAL FE PCB
High Rate Photon Irradiation Test with an 8-Plane TRT Sector Prototype
RPC Front End Electronics
MEG II実験 液体キセノン検出器の建設状況
BUCKEYE has internal shift register which controls calibration
The Ohio State University USCMS EMU Meeting, FNAL, Oct. 29, 2004
AquK2P channels are activated by externally applied AA
Characterization of Wired-OR prototype board
Presentation transcript:

AR2FL/S and No/Lo Gain followup Campion Anton Mitch

Chip 2 Ch 14 AR2FL Problem on module was reproduced July 21. Not Present mounted on Module with a 10pF loaded PIB replacing straw Reduced in magnitude on module with improved RF finger connection.

No Gain Channels External pulser investigation One of several low gain channels responding to an external test pulse input. The pulse amplitude is chosen to cause the same response as a 50mV step in a normal channel.

Internal Pulser Demonstrating No/Lo Gain Channels Algen ‘A’ wheel Board #124180

Lo/No Gain Statistics (All Boards) Source# Lo Gain Channels #ASDBLR ASICS ALGEN32 * NBI ‘A’ Wh Bds119 * NBI ‘B’ Wh Bds116 * AR2FL/FS75 * Confirmed with external pulser Full spreadsheet on tested boards at  On Detector boards  End Cap wheel boards  End_Cap_debugging

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2025 SlidePlayer.com. Inc. All rights reserved.