Cambridge, Dec 2010Considerations for AA-lo LNA Dr Saswata Bhaumik PDRA of: Dr Danielle George The University of Manchester.

Slides:



Advertisements
Similar presentations
B. BOUDJELIDA 2 nd SKADS Workshop October 2007 Large gate periphery InGaAs/InAlAs pHEMT: Measurement and Modelling for LNA fabrication B. Boudjelida,
Advertisements

Design of a Low-Noise 24 GHz Receiver Using MMICs Eric Tollefson, Rose-Hulman Institute of Technology Advisor: Dr. L. Wilson Pearson.
The High Voltage/High Power FET (HiVP)
In partnership with STMicroelectronics DESIGN OF A CLASS 1 POWER AMPLIFIER FOR BLUETOOTH TM APPLICATIONS Advisors Candidate Prof. Antonella D’Orazio Giovanni.
Chalmers University of Technology Development of a Coolable Decade Bandwidth Eleven Feed System for SKA & VLBI 2010 Radio Telescopes Per-Simon Kildal Chalmers.
TDP Progress Report, June 4, 2010
ASTRON / Photonics p1. Photonics and AA station design Peter Maat – ASTRON Photonics and AA station design Peter Maat – ASTRON.
AAVS receiver Federico Perini AAVP December, ASTRON, Dwingeloo.
SKA TDP Receiver Antenna Interface March 21, 2008 Total system noise contributions Choice of operating temperature Wideband feeds.
Evaluation of GaAs Power MESFET for Wireless Communication
Distributed Power Amplifiers-Output Power and Efficiency Considerations Prasad N. Shastry (S. N. Prasad) 1, Senior Member, IEEE, and Amir S. Ibrahim 2.
Highly Linear Power Amplifiers for Broadband Wireless Applications Power Amplifiers for Wireless Communications Workshop September 9, 2002 M. Siddiqui,
Prototype SKA Technologies at Molonglo: 2. Antenna and Front End G.B. Warr 1,2, J.D. Bunton 3, D. Campbell-Wilson 1, R.G. Davison 1, R.W. Hunstead 1, D.A.
Receiver TDP Report to US SKA Consortium Nov 17, 2008, Emphasis in Caltech TDP Meeting the 35K Tsys goal,
Mid-Semester Design Review High Frequency Radio with BPSK Modulation.
Slide 19/3/2002 S. Xie, V. Paidi, R. Coffie, S. Keller, S. Heikman, A. Chini, U. Mishra, S. Long, M. Rodwell Department of Electrical and Computer Engineering,
Low Power RF/Analog Amplifier Design Tong Zhang Auburn University Tong Zhang Auburn University.
Receiver TDP Report to US SKA Consortium May 22, 2008 Sandy Weinreb, Joe Bardin, Glenn Jones, and Hamdi Mani California Institute of Technology
Antenna, Feed, and LNA Integration S. Weinreb, May 7, 2009, LAX Antenna Working Group Meeting 1.Issues 2.Feed Summary 3.LNA Summary 4.Differential LNA’s.
Feed/Receiver Developments ATA-TAP December 17, 2002 WJW.
Array Antenna Designs for the SKA-AAlo Eloy de Lera Acedo 1 AAVP 2010, Cambridge, UK. 10/12/10.
Name1 SKA(DS) System Design Aspects 4 th SKADS Workshop, Lisbon, 2-3 October 2008 SKA(DS) System Design Aspects: building a system Laurens Bakker.
ECE1352F University of Toronto 1 60 GHz Radio Circuit Blocks 60 GHz Radio Circuit Blocks Analog Integrated Circuit Design ECE1352F Theodoros Chalvatzis.
1 Wideband LNA for a Multistandard Wireless Receiver in 0.18μm CMOS 指導教授 : 林志明 學生 : 黃世一
Technical Interests on the SKA Noriyuki Kawaguchi National Astronomical Observatory of Japan SKA Workshop November 5, 2010.
Satellite Digital Audio Radio Service Receiver Front-End (SDARS)
Multiple Criteria Optimisation for Base Station Antenna Arrays in Mobile Communication Systems By Ioannis Chasiotis PhD Student Institute for Communications.
B. BOUDJELIDA1 UMan LNA Programme 4 th SKADS Workshop, Lisbon, 2-3 October 2008 University of Manchester: Progress on LNA Programme B. Boudjelida, A. Sobih,
AA-Low Technical Progress Meeting, October 2012, Medicina, Italy AAVS0 & AAVS0.5: System Design and Test Plan Nima Razavi-Ghods Eloy de Lera Acedo.
Design of LNA at 2.4 GHz Using 0.25 µm Technology
Microwave Engineering, 3rd Edition by David M. Pozar
Study of 60GHz Wireless Network & Circuit Ahn Yong-joon.
Namaste Project 3.4 GHz Interference Study Preliminary document - Work in Progress updated The intent of this study is to collect data which may.
Phased Array Feeds John O’Sullivan SKANZ 2012 CSIRO Astronomy and Space Science,
R. HaywardEVLA Feeds CDR - System Requirements 17 Feb EVLA Feeds CDR System Requirements.
A 1.5-V 6-10-GHz Low LO-Power Broadband CMOS Folded-Mirror Mixer for UWB Radio H.-W. Chung, H.-C. Kuo, and H.-R. Chuang Institute of Computer and Communication.
LNA DC Bias Module Approach Block Diagram Schematic Program Plan
Final Project in RFCS in the MINT Program of the UPC by Sven Günther
A High-Gain, Low-Noise, +6dBm PA in 90nm CMOS for 60-GHz Radio
Proposed Versatile 1.2 to 14 GHz Radio Telescope Receiver S. Weinreb, JPL/Caltech, Draft July 5, 2005 Contents 1.Introduction and intended applications.
KFPA Noise Calibration Module and Coupler Eric W. Bryerton NRAO CDL (Charlottesville)
Departement Elektriese en Elektroniese Ingenieurswese  Department of Electrical and Electronic Engineering Ultra Wideband Reflector Antenna Feeds Dirk.
A NEW METHOD TO STABILIZE HIGH FREQUENCY HIGH GAIN CMOS LNA RF Communications Systems-on-chip Primavera 2007 Pierpaolo Passarelli.
LNA Technologies and Topologies SKADS SKA LNA Technologies and Topologies Saswata Bhaumik PhD Student Dr Danielle George The University of Manchester.
MMIC design activities at ASIAA Chau-Ching Chiong, Ping-Chen Huang, Yuh-Jing Huang, Ming-Tang Chen (ASIAA), Ho-Yeh Chang (NCUEE), Ping-Cheng Huang, Che-Chung.
Sanae Boulay, Limelette, Nov 05 th 20091/20 S. Boulay, B. Boudjelida, A. Sharzad, N. Ahmad, M. Missous Novel Ultra Low Noise Amplifiers based on InGaAs/InAlAs.
Jinna Yan Nanyang Technological University Singapore
LNA implementation Federico Perini AA-low Technical Progress Meeting Medicina, September 2012.
A Unified Approach to Design Distributed Amplifiers Rasit Onur Topaloglu PhD. Student
Amplifiers Amplifier Parameters Gain = Po/Pi in dB = 10 log (Po/Pi)
Introduction LNA Design figure of merits: operating power consumption, power gain, supply voltage level, noise figure, stability (Kf & B1f), linearity.
Final Design Review of a 1 GHz LNA / Down-Converter Charles Baylis University of South Florida April 22, 2005.
O. García-Pérez (FG-IGN) 1FIDA3 Wide Field Astronomy and Technologies for the SKA, Limelette, 4-6 November 2009 FIDA3: A Novel Active Array for the Mid-SKA.
Rakshith Venkatesh 14/27/2009. What is an RF Low Noise Amplifier? The low-noise amplifier (LNA) is a special type of amplifier used in the receiver side.
3-Stage Low Noise Amplifier Design at 12Ghz
A 3-V Fully Differential Distributed Limiting Driver for 40 Gb/s Optical Transmission Systems D.S. McPherson, F. Pera, M. Tazlauanu, S.P. Voinigescu Quake.
Dr Danielle Kettle1 LNA progress 4 th SKADS Workshop, Lisbon, 2-3 October 2008 LNA progress.
Members:Advisor: Yuriy Miroshnichenko Dr. Thomas Weller Peter Kowalik.
M. Atef, Hong Chen, and H. Zimmermann Vienna University of Technology
 This chapter describes how the link- power budget calculations are made.  In this text [square] bracket are used to denote decibel quantities using.
High Gain Transimpedance Amplifier with Current Mirror Load By: Mohamed Atef Electrical Engineering Department Assiut University Assiut, Egypt.
Communication 40 GHz Anurag Nigam.
Input Stages for Radio Systems (Low Noise Amplifiers) (LNAs)
Lets Design an LNA! Anurag Nigam.
Technology Perspective and results with mHEMTs
Variable Gain CMOS LNA MOREIRA E SILVA, Paulo Marcio, DE SOUSA, Fernando Rangel Introduction Simulation.
High-linearity W-band Amplifiers in 130 nm InP HBT Technology
5.8GHz CMOS 射頻前端接收電路 晶片設計實作 5.8GHz CMOS Front-End Circuit Design
DS4-T1 FRONT-END TECHNOLOGIES
Student Design Competition
Presentation transcript:

Cambridge, Dec 2010Considerations for AA-lo LNA Dr Saswata Bhaumik PDRA of: Dr Danielle George The University of Manchester

Cambridge, Dec 2010Considerations for AA-lo LNA Overview Hybrid LNA simulations  Performances of LNA1 and LNA2 MMIC process considerations  Reproducibility, Repeatability, Yield, Availability, Power, Temperature Stability Interface with Antenna  Investigation of interface between LNA and Antenna is very important

Cambridge, Dec 2010Considerations for AA-lo LNA AA-lo hybrid LNA simulations LNA1 LNA2

Cambridge, Dec 2010Considerations for AA-lo LNA AA-lo LNA Simulated results: 1.Two hybrid LNA designs. 2.2-stage LNAs with differential input and single ended output. 3.Enhancement mode pHEMTs of Avago Technology 4.Operational from 50MHz to 400MHz. 5.LNA1: Gain above 25dB. NT below 35Kelvin between 100MHz and 450MHz 20Kelvin at 330MHz. 4V – 121mA drain bias (at PSU). P1dB IN point of -23dBm at 0.4GHz. 6.LNA2: Gain above 36.7dB. NT below 36Kelvin. P1dBIN is -24dBm at 0.4GHz. 3V – 60mA drain bias and 0.5V at gate AA-lo LNA:  Low loss Baluns.  Single ended LNAs.  Overall noise figure should be less than sky noise. AA-lo MMIC LNA:  Matured process  Excellent repeatability and yield  Low cost  High transconductance and low noise

Cambridge, Dec 2010Considerations for AA-lo LNA List of Measured HEMT Samples Process Different S-parameter NoiseDetails Sizessamples Samples Samples 188x47x2 150nm GaAs pHEMT 29 9x4 5x2 150nm GaAs mHEMT 3 4 4x4 4x2 130nm GaAs pHEMT 4 7 7x4 4x2 100nm InP pHEMT 5 8 8x3 8x2 150nm GaAs mHEMT 66 6x3 3x2 70nm GaAs mHEMT 7 1 1x6- 150nm GaAs pHEMT 81 1x nm InP pHEMT 933x6-100nm GaAs pHEMT Total types Ongoing/Future characterisation work: 1.HEMTs of 2/3 more processes 2.Further Characterisation of 2 of 9 above processes 3.Cryogenic characterisation of HEMTs of shortlisted processes MMIC Parameters: 1.Reproducibility 2.Reliability 3.Yield 4.Future Availability 5.Power, Temperature, Cost

Cambridge, Dec 2010Considerations for AA-lo LNA Process considerations Process Investigation based on power efficiency Important parameters: 1.Noise Measure 2.Position Gamma Opt in Smith Chart 3.Temperature dependency 4.Power efficiency Loci of Γ opt

Cambridge, Dec 2010Considerations for AA-lo LNA Temperature Dependency 1.Temperature fluctuation varies gain and NT 2.Temperature stabilisation is vital for long observations 3.Optimum biases change with temperature 4.Temperature stabilisation? Process Investigation based on temperature dependency

Cambridge, Dec 2010Considerations for AA-lo LNA Interface between antenna and LNA/balun is crucial for noise and gain ripple. Consideration must be given to practical implementation. Options – 1.Direct connection between Antenna and LNA –Differential Antenna and Differential/pseudo Differential LNA –Single-ended Antenna and Single-ended LNA 2.Balun in the Interface –Differential Antenna and Single-ended LNA (feasible for AA-lo SKA) Interface with Antenna

Cambridge, Dec 2010Considerations for AA-lo LNA Conclusions and Further Work  AA-lo has different LNA design requirements to AA-mid.  HEMTs of 9 processes investigated – 2 processes will be further investigated.  2/3 more processes will be investigated.  Different pHEMT topologies superior to mHEMT topologies for AA SKA (considering factors discussed in previous slides).  Different processes suitable for different frequency bands (AA-lo and AA-mid).  MMIC version of AA-lo LNA has been designed for fabrication.