Woodwork Tools 2 Quiz

Marking Gauge Mortise Gauge Cutting Gauge 1.What is the correct name for this tool? Depth Gauge

2. Which of the following tools would be used to rip a standard sheet of 9mm Plywood in half? A Panel Saw A Coping SawA Tenon Saw A Jnr Hacksaw

3. What is the correct name for this saw? Pad Saw Flush Cut Saw Bow Saw Dovetail Saw

Pliers Pincers Engineers Pliers 4.What is the correct name for this tool? End Cutters

Through Housing Joint Mortise & Tenon Joint Cross Halving Joint 5.Which joint is this tool normally used to mark out? Rebate Joint Dovetail Joint Stopped Housing Joint

Adjustable Square Sliding Bevel Cutting Gauge 6.What is the correct name for this tool? Mitre Gauge

Roll the pincers as shown 7. Which picture shows the correct way to use these pincers ? Pull the pincers as shown

8. Which of the following tools would be used to start a small hole for a screw? A Scriber A Countersink Drill A Nail Punch A Bradawl

9. What is the blade of a Panel saw made from? Cart Iron Spring Tempered Tool Steel Bright Drawn Mild Steel (BDMS) Stainless Steel

10. What is the correct name for the tool being used in this picture? Mortise Gauge Cabinet Scraper Sliding Bevel Cutting Gauge Router

11. What is the correct name for the tools shown below? Centre Punch Parallel Punch Nail Punch Dot Punch Hollow point

Stock Spur Stem 12.What is the correct name for this part of a Mortise Gauge? Thumbscrew

13. Which of the following tools would be used for marking out angles other than 90˚ Odd Leg Callipers A Try SquareAn Engineers Square A Sliding Bevel

Drawing lines parallel to an edge Marking out Circles Centre Punching Holes 14. What are Trammels normally used for? Marking out Mortise Joints

Dovetail Saw Fret Saw 15. What is the correct name for this tool? Bow Saw Flush Cut Saw Piercing Saw Coping Saw Panel Saw

Well Done Quiz Completed

Wrong Click here to try again 