Pulse Amplitude Modulation Section 6.6. DSB/SC-AM Modulation (Review)

Slides:

Advertisements

Similar presentations

Time Division Multiplexing (TDM)

Advertisements

Chapter 6. Sampling and Pulse Modulation Husheng Li The University of Tennessee.

Time division multiplexing TDM

ECE 8443 – Pattern Recognition EE 3512 – Signals: Continuous and Discrete Objectives: Generalized Fourier Transform Analog Modulation Amplitude Modulation.

Department of Electronics and CommunicationsEngineeringYANSAHAN UNIVERSITY Department of Electronics and Communications Engineering YANSAHAN UNIVERSITY.

Storey: Electrical & Electronic Systems © Pearson Education Limited 2004 OHT 5.1 Signals and Data Transmission  Introduction  Analogue Signals  Digital.

AM/FM Receiver.

Pulse Code Modulation Lecture 5.

1 11 Lecture 11 Basic Modulation Techniques (V) Fall 2008 NCTU EE Tzu-Hsien Sang.

1 Single Side Band Suppressed Carrier Professor Z Ghassemlooy Electronics and IT Division School of Engineering Sheffield Hallam University U.K.

EKT343 –Principle of Communication Engineering

Modulation Modulation => Converts from digital to analog signal.

EE104: Lecture 21 Outline Review of Last Lecture Vestigial Sideband Modulation AM Radio Introduction to FM FM Bandwidth and Carson’s Rule Narrowband and.

C H A P T E R 4 AMPLITUDE MODULATIONS AND DEMODULATIONS

Chapter 7 CT Signal Analysis : Fourier Transform Basil Hamed

Standard Amplitude Modulation (AM)

Aristotle University of Thessaloniki – Department of Geodesy and Surveying A. DermanisSignals and Spectral Methods in Geoinformatics A. Dermanis Signals.

Chapter 4 Amplitude Modulation. Baseband vs Passband Transmission  Baseband signals: Voice (0-4kHz) TV (0-6 MHz)  A signal may be sent in its baseband.

TEL312 Electronic Communications Fundamentals Modulation Modulation is the process by which information (message) is transformed Into waveforms that are.

Chapter 4 Digital Transmission

4.2 Digital Transmission Pulse Modulation (Part 2.1)

NETE 0510 Presented by Dr.Apichan Kanjanavapastit

PULSE MODULATION.

Data Transmission The basics of media, signals, bits, carries, and modems (Part II)

Signal Encoding Techniques

Data and Computer Communications Chapter 8 – Multiplexing

Prof. Brian L. Evans Dept. of Electrical and Computer Engineering The University of Texas at Austin EE345S Real-Time Digital Signal Processing Lab Spring.

Prof. Brian L. Evans Dept. of Electrical and Computer Engineering The University of Texas at Austin EE345S Real-Time Digital Signal Processing Lab Fall.

Signal and Systems Prof. H. Sameti Chapter 8: Complex Exponential Amplitude Modulation Sinusoidal AM Demodulation of Sinusoidal AM Single-Sideband (SSB)

Prof. Brian L. Evans Dept. of Electrical and Computer Engineering The University of Texas at Austin EE445S Real-Time Digital Signal Processing Lab Fall.

Single-Sideband AM A DSB-SC AM signal transmits two sidebands and required a channel bandwidth of Bc = 2W Hz However, the two sidebands are redundant The.

8.0 Communication Systems Modulation: embedding an information-bearing signal into a second signal e.g. – purposes : locate the signal on the right band.

EE 6331, Spring, 2009 Advanced Telecommunication Zhu Han Department of Electrical and Computer Engineering Class 11 Feb. 24 th, 2009.

COMMUNICATION SYSTEM EEEB453 Chapter 7(Part I) MULTIPLEXING.

Prof. Brian L. Evans Dept. of Electrical and Computer Engineering The University of Texas at Austin EE445S Real-Time Digital Signal Processing Lab Fall.

ECE 8443 – Pattern Recognition EE 3512 – Signals: Continuous and Discrete Objectives: Review Resources: Wiki: Superheterodyne Receivers RE: Superheterodyne.

1 Time division multiplexing TDM m(t) TsTs 2T s 3T s 4T s 5T s 6T s 7T s.

Concepts of Multiplexing Many input signals to one transmission media Reduces the number of channels or conductors running from point A to point B Added.

CSCI 465 Data Communications and Networks Lecture 7 Martin van Bommel CSCI 465 Data Communications and Networks 1.

EE104: Lecture 5 Outline Review of Last Lecture Introduction to Fourier Transforms Fourier Transform from Fourier Series Fourier Transform Pair and Signal.

Prof. Brian L. Evans Dept. of Electrical and Computer Engineering The University of Texas at Austin EE345S Real-Time Digital Signal Processing Lab Spring.

ECE 4710: Lecture #22 1 Frequency Modulation  FM spectrum is very difficult to calculate in general  Useful to develop simple approximations when the.

CHAPTER4: CONTINUOUS-WAVE (CW) MODULATION First semester King Saud University College of Applied studies and Community Service 1301CT.

6.1 Chapter 6 Bandwidth Utilization: Multiplexing and Spreading Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.

6.1 Chapter 6 Bandwidth Utilization: Multiplexing and Spreading Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.

Multiplexing. Multiplexing is the set of techniques that allows simultaneous transmission of multiple signals across a single link.

Chapter 8 Multiplexing Many to one/one to many Types of multiplexing

Data Comm. & Networks Instructor: Ibrahim Tariq Lecture 3.

ECE 8443 – Pattern Recognition ECE 3163 – Signals and Systems Objectives: Demultiplexing and Demodulation Superheterodyne Receivers Review Resources: Wiki:

◦ We sometimes need to digitize an analog signal ◦ To send human voice over a long distance, we need to digitize it, since digital signals are less prone.

What do these abbreviations stand for? PWM PPM PAM PCM ASK FSK PSK AM FM IF AF RF TRF amp Pulse width modulation Pulse position modulation Pulse amplitude.

Prof. Nizamettin AYDIN Advanced Digital Signal Processing 1.

1 Pertemuan 3 Networking Fundamentals Matakuliah: M0284/Teknologi & Infrastruktur E-Business Tahun: 2005 Versi: >

Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display. Chapter Six Sampling and Pulse Modulation.

1 st semester 1436 / Modulation Continuous wave (CW) modulation AM Angle modulation FM PM Pulse Modulation Analog Pulse Modulation PAMPPMPDM Digital.

Introduction to Communication Lecture (07) 1. Bandwidth utilization Bandwidth utilization is the wise use of available bandwidth to achieve specific goals.

8.0 Communication Systems Modulation: embedding an information-bearing signal into a second signal e.g. – purposes : locate the signal on the right band.

Analog Communication Systems Amplitude Modulation By Dr. Eng. Omar Abdel-Gaber M. Aly Assistant Professor Electrical Engineering Department.

Demodulation PWM Signal

4.1 Chapter 4 Digital Transmission Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.

Pulse Code Modulation (PCM)

Hw week 5 1. Let the message signal m(t) = 4 + 2cos(2  103t), carrier wave xc(t) = 8cos(2  106t) (a) For DSB-SC systems, draw the frequency domain.

2D Fourier transform is separable

Chapter 10. Digital Signals

PULSE MODULATION.

Lecture 5: DSB-SC AM Modulation 1st semester

LECTURE 12: SIGNAL MODULATION AND DEMODULATION

Lesson Week 8 Fourier Transform of Time Functions (DC Signal, Periodic Signals, and Pulsed Cosine)

Digital Signal Processing

8. Communication Systems

Presentation transcript:

Pulse Amplitude Modulation Section 6.6

DSB/SC-AM Modulation (Review)

Frequency Shift Property (Review)

Frequency Spectrum of DSB/SC- AM Signal (Review)

Carrier Signal for Amplitude Modulation

Pulse Amplitude Modulation

Frequency Spectra for Pulse Amplitude Modulation (Determined by fourier series) Replication is caused by multiplication of m(t) by cos()

Frequency Modulation (Review) Multiple signals are transmitted simultaneously through the same channel.

Time-Division Multiplexing Multiple signals are transmitted in the same channel with the signals separated in time, but not in frequency! The switches at the receiving end is synchronized to the switches of the multiplexer.

Demodulator for PAM

Telephone System in the US (Need to low pass filter the circuit) The maximum frequency content cannot exceed 3.2 KHz. Drawback: deterioration in voice quality. Ears can hear up to 20 KHz. (Sampling rate: 8 KHz)

Pulse Modulation Using Sample and Hold (model the sample and hold with sampling and filtering behavior)

Impulse Response of a Data Hold Circuit

Frequency Spectra for Flat-Top PAM