DataLogger Operation - 1 DataLogger ® Operation Procedures

DataLogger Operation - 2 The DataLogger Record and document key parameters of the fusion process Creates a joint report that can be saved, viewed, analyzed, printed, and transferred to a desktop computer for archiving

DataLogger Operation - 3 Rugged Device Meets MIL-STD-810F standards for drops, vibration and temperature extremes IP67 rating: impervious to dust and water immersion. Can be operated from -22 F to 140 F DataLogger Unit Rugged Pocket PC

DataLogger Operation - 4 Product Manual Shipped with each unit Available for free at Read safety instructions before operating any machine

DataLogger Operation - 5 Basic Setup- Pocket PC Charge the pocket PC –Allow to fully charge (approx 4 hrs) –Once charged, battery lasts approx. 15 hrs Power On –Press the power button to turn on the unit Set the Time and Date Turn BlueTooth on

DataLogger Operation - 6 Basic Setup- DataLogger Install batteries in the unit –Remove the battery cover from the topic of the unit. Insert ‘D’ cell batteries and replace the battery cover. Press the Multifunction switch to turn on the DataLogger

DataLogger Operation - 7 LED Status Indicators Once the batteries are installed and the multifunction switch is pressed, 2 LED lights will illuminate Blue –Flashing indicates the Bluetooth is ready to communicate with the pocket PC –Steady indicates the Bluetooth has established communication with the pocket PC Tri-Color –Amber stays on less than 2 seconds, indicating power-up initialization state –Flashing green indicates normal operation mode –Flashing red indicates data logging mode

DataLogger Operation - 8 Pressure Transducer Connected to the DataLogger via a cable Taps into the hydraulic system of the fusion machine using the supplied connection fittings and quick disconnect Do not store unit with quick disconnect fitting attached Not interchangeable between units

DataLogger Operation - 9 McElroy Software Program Factory setup- immediately ready to log data Provides a user interface and joint reporting storage capability Download joint reports daily McElroy DL3-PPC Data Logging Software Program Free download and update at:

DataLogger Operation - 10 Calibration and Repair DataLogger should be calibrated at McElroy Manufacturing or an authorized distributor once a year All other repairs must be done at factory Go through your distributor to return a DataLogger to McElroy for calibration or repair

DataLogger Operation - 11 Recording Start DataLogging before pipe ends meet heater (5 seconds on stopwatch) Stop recording after cooling cycle but before any valves are actuated.

DataLogger Operation - 12 Visit our website for product and training updates. Get your free product catalog and reference guide.

DataLogger Operation - 13 DataLogger ® Operation Procedures