Welcome to the Eastern Region Laboratory Procedures Manual ERLPM

Slides:

Advertisements

Similar presentations

Mn/DOT Combined Smoothness Specification Operator Certification Training Workshop July 12, 2010.

Advertisements

LOW VOLUME ROAD DESIGN EMPIRICAL APPROACH.

Paving Potpourri 2015 Spec Changes and More! Bob Dyer Assistant State Construction Engineer WAPA Joint Training March 2015 Lynn Peterson Secretary of Transportation.

2014 Washington Asphalt Conference “Specification Update & Initiatives” Joe DeVol Assistant State Materials Engineer State Materials Laboratory.

Using CFB Ash As A Substitute For Portland Cement In Full Depth Reclamation Presented By Steve Dixon, Civil & Environmental Consultants, Inc. Jim Panaro,

Pavement Design Session Matakuliah: S0753 – Teknik Jalan Raya Tahun: 2009.

HMA Design (Surface) The surface course is the layer in contact with traffic loads and normally contains the highest quality materials. It provides characteristics.

Pavement Material Session Matakuliah: S0753 – Teknik Jalan Raya Tahun: 2009.

Asphalt Specification Changes July 2005 Contractor Asphalt Training Rich Hewitt, PE District Bituminous Engineer District Five Materials & Research.

2014 AAPA Conference March 11-12, 2014 Curtis Vincent, P.E. Construction Engineer Lyndi Davis Blackburn, P.E. Assistant Materials and Tests Engineer Specification.

SMA Mixture Design Requirements

1 Final Estimates and Asphalt Reports. 2 Setting Spread Rate For Asphalt Base.

Guillermo Felix P.E Eastern Region Paving Engineer

Know the factors considered in the AASHTO design method

Pavement Design.

CVE 506 HIGHWAY AND TRANSPORTATION ENGINEERING II DR O.S ABIOLA Dept. of Civil Engineering University of Agriculture,Abeokuta.

Transportation Engineering II

Monty Wade, P.E Applied Pavement Technology, Inc. April 4, 2012

Asphalt Rubber Related Specifications Arizona Department of Transportation.

Soil Stabilization By: Monica Acosta.

Lec 28, Ch.20, pp : Flexible pavement design, ESAL (Objectives)

7.0 RAC Jeopardy Assessment of Learning 2 RAC Jeopardy Roads, Routes, and Highways Got RAC?RACitectureRAC of AgesRAC and Roll An Ounce of Prevention.

Asphalt Quality Assurance Program

Flexible Pavement FAARFIELD Design Example

Quality Control Testing

32 nd Eastern Region Annual Airports Conference Eastern Region Laboratory Procedures Manual ERLPM Guillermo Felix P.E Eastern Region Paving Engineer.

Careers in Aerospace Engineering Careers in Aerospace Engineering KEN BLACKBURN NCASE Atlanta, GA March 2004.

1 8/29/2015WisDOT BTS MMS.  MIT – Materials Information Tracking (Field Version) Used by WisDOT/Consultant/& Municipal staff in the field to enter a.

Florida Department of Transportation 1 Overview of CQC Asphalt Specifications.

Asphalt QC 2000 The Adventure Begins….. Topics Terminology Specifications Sampling and Testing Reporting/CQR Who Does What? Lube & Oil Change All in 20.

AAPA 2010 Study Tour – Accelerated Pavement Testing & Equipment Observations and Recommendations Accelerated Pavement Testing & Equipment.

DR O.S ABIOLA DEPARTMENT OF CIVIL ENGINEERING UNIVERSITY OF AGRICULTURE, ABEOKUTA CVE 409 HIGHWAY ENGINEERING.

Road Engineering Todays lecture Introduction Pavement design Project - Road 34.

Guidelines for Use of Highway Specifications for Airport Pavements

Material Variability… … or “how do we know what we have?”

Session #3 Asphalt 103- Materials: Basics of RAP, Usage and Specifications.

PROGRESS OVERVIEW: COLTO STANDARD SPECIFICATIONS TMH AND TRH DOCUMENTS OTHER DOCUMENTS.

بسم الله الرحمن الرحيم Comparative Analysis Of Airport Pavement Design Methods: Case Study for Khartoum New International Airport.

The application of locally developed pavement temperature prediction algorithms in Performance Grade (PG) binder selection Prepared for SATC 2007 By Erik.

 The objective of this task is to develop a mix design procedure for the various types of FDR  Determine what works and what does not work  Each.

College of Engineering Discovery with Purpose Department of Civil, Construction and Environmental Engineering Tim Ellis, Associate.

ERLPM Workshop Statistical Analysis

Presented to: 2010 FAA Worldwide Airport Technology Transfer Conference By: Gordon Hayhoe, FAA AJP-6312, WJHTC Date: April 20, 2010 Federal Aviation Administration.

CALIFORNIA BEARING RATIO (CBR) METHOD

Spreadsheets for SiteManager Materials 2007 HIGHWAY CONTRACTOR’S MEETING March 13 th (Bowling Green) March 16 th (Lexington) Presented By: Ross Mills.

Nilesh Surti, PE NCDOT State Pavement Construction Engineer.

Soil cement 1 1.

GEOTEXTILES IN TRANSPORTATION APPLICATIONS

CAPA 66 th Annual Meeting – April 22, Fiscal Update Staffing Funding Lettings 2.

Presented to: By: Date: Federal Aviation Administration Pavement Projects and Plans ANG-E262 REDAC Jeff Gagnon March 15, 2016.

Marshall & Superpave Mix Design

Introduction Old asphalt pavements Increase demand in landfill areas and landfill costs Landfill areas.

GOVERNMENT OF TAMIL NADU HIGHWAYS DEPARTMENT HIGHWAYS RESEARCH STATION Training program for newly recruited Assistant Engineers.

Asphalt Pavement Training Conference “HMA Mix Designs on the QPL”

California Bearing Ratio

Barriers to Implementation of In-Place Recycling

Earthwork operations- are those that involve the earth in its natural form, which need to be undertaken before the actual construction of the pavement.

Asphalt Pavements and Materials

ALDOT Specification Updates

Effect of Removing the Amelioration Period on Design & Construction of Lime Stabilised Subgrades in Local Government Scott Young BE (Hons), RPEng (Civil),

CALIFORNIA BEARING RATIO (CBR) METHOD

2018 Pavement Workshop Flexible Session May 23-24, 2018

Paramix mid-term meeting in Barcelona November 13, 2002

SUBGRADE HOW TO DEAL WITH SOFT SPOTS

Flexible Pavement Design (JKR Method)

Flexible pavement design

Flexible Pavement Design (ARAHAN TEKNIK JALAN 5/85 PINDAAN 2013)

High Value Research Sweet 16 – RAC Region 3

Materials and Tests Engineer

Pavement materials: Soil

Presentation transcript:

Welcome to the Eastern Region Laboratory Procedures Manual ERLPM Guillermo Felix FAA – Eastern Region Paving Engineer March 17-19, 2008

Workshop Objectives Present concept for pavement design and the structural function of various layers Present an understanding of material characteristics and principles for mix design to satisfy loading and environmental conditions. Marshall design and Superpave Discuss purpose and principles to measure the quality of mixing and placing asphaltic materials (Quality Assurance)

Workshop objectives Discuss principles and practices for sampling and testing bituminous mixes Explain statistical methods to determine quality of materials and pay factors Present Contractor testing to control the quality of the mixes (Quality Control) What happen after this workshop?

Criteria for Pavement Design Loads: Expressed in aircraft weight and Aircraft annual departures (passes) Soil strength: expressed as a relation to a standard soil for flexible pavement design. California Bearing Ratio (CBR)

Surface course, P-401 Base course –stabilized or not Sub base course Sub grade – prepared support

Aircraft weight for P-401 Less than 12,500 (Highway Spec) 12,500 lbs. but less than 60,000 Lbs. 60,000 Lbs or more

WHAT IS P-401? Surface course and defined by AC 150-5320-6 Specification that details de quality of the surface course

What is P-403? Specification for Stabilized Bituminous Base Course Binder Course Truing and Leveling Courses Testing requirement has been reduced

What is the ERLPM Eastern Region Laboratory procedures Manual Born in the Eastern Region to use statistical methods to determine quality vs range or media (average) Origen – Military specs, now MS-2 Document to be used in combination with P-401. required in Eastern region Provide forms for project submittal - Appendices

AGENDA Mix Design – Jim Smith/Chris Brower/Rodney Joel Random Sampling- Guillermo Felix Quality Acceptance (Marshall) – Ken Rowbotham Statistical Analysis – Carl Steinhauer Computer Software – Guillermo Felix Contractor’s Quality Control – Cindy LeFleur ERLPM Test and List - Guillermo

How many of you are Consultants? Testing laboratories? Contractors? Material supplier? Government?

Questions? Let’s welcome Jim and Chris