Analog Circuit Design AVI SINGH. Amplifier What is an amplifier?

Slides:

Advertisements

Similar presentations

CHAPTER 3: SPECIAL PURPOSE OP-AMP CIRCUITS

Advertisements

Experiment 8 * Op Amp Circuits Review * Voltage Followers and Adders

Operational Amplifiers

Introduction to the OP AMP

ECE 201 Circuit Theory I1 Introduction to the Operational Amplifier μA 741 OP AMP.

Operational Amplifiers (Op Amps) Discussion D3.1.

* Operational Amplifiers * Op-Amp Circuits * Op-Amp Analysis

Lecture 91 Loop Analysis (3.2) Circuits with Op-Amps (3.3) Prof. Phillips February 19, 2003.

Chapter 2 – Operational Amplifiers

Op Amps Lecture 30.

1 More on Op Amps Discussion D Ideal Op Amp 1) The open-loop gain, A v, is infinite. 2) The current into the inputs are zero.

Operational Amplifier

Department of Information Engineering357 Operation amplifier The tail, large impedance gives high CMRR Mirror as active load. High gain Follower as buffer.

ECE 2006 Chapter 5: Operational Amplifiers. Differential Amplifier Not Practical Prior to IC Fabrication 2 Inputs, Output is A v *(V 1 - V 2 )

Chapter 2 – Operational Amplifiers Introduction Textbook CD

1 ECE 3336 Introduction to Circuits & Electronics MORE on Operational Amplifiers Spring 2015, TUE&TH 5:30-7:00 pm Dr. Wanda Wosik Set #14.

Department of Information Engineering357 Feedback Op amp golden rules Approximations: 1.Voltage difference between the two inputs is zero 2.Input draws.

Operational Amplifiers (Op Amps) Discussion D3.1.

Operation Amplifier. Golden Rules of OP Amp 1.i in =0, no current flow into op amp. 2.V + =V - Typically one end of op amp is connected to ground, therefore,

Introduction to Op Amps

Announcements Assignment 3 due now, or by tomorrow 5pm in my mailbox Assignment 4 posted, due next week –Thursday in class, or Friday 5pm in my mailbox.

OPERATIONAL AMPLIFIERS

Operational Amplifiers David Lomax Azeem Meruani Gautam Jadhav.

ECE 3355 Electronics Lecture Notes Set 4 -- Version 21

IDEAL OPERATIONAL AMPLIFIER AND OP-AMP CIRCUITS

“Op-Amp” Operational Amplifier Non Inverting Amplifier Inverting Amplifier Adder –(and Subtractor using an Inverter) Differential Amplifier Integrator.

Introduction to Op Amp Circuits ELEC 121. April 2004ELEC 121 Op Amps2 Basic Op-Amp The op-amp is a differential amplifier with a very high open loop gain.

09/16/2010© 2010 NTUST Today Course overview and information.

Agenda and Notes Today, during class! 9:30 a.m. Boeing Space and Intelligence Systems (Matt and Matt) 4 extra credit assignments available at the bottom.

Operational Amplifier

ECE 4991 Electrical and Electronic Circuits Chapter 8.

EE445:Industrial Electronics. Outline Introduction Some application Comparators Integrators & Differentiators Summing Amplifier Digital-to-Analog (D/A)

Microelectronic Circuits, Sixth Edition Sedra/Smith Copyright © 2010 by Oxford University Press, Inc. C H A P T E R 02 Operational Amplifiers.

The signal conditioner -- changes the voltage Amplify Attenuate Filter.

Module 4 Operational Amplifier

TECHNIQUES OF DC CIRCUIT ANALYSIS: SKEE 1023

Fundamentals of Electric Circuits Chapter 5 Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.

Lecture 4: Electrical Circuits

Operational Amplifiers The operational amplifier, also know as an op amp, is essentially a voltage amplifier with an extremely high voltage gain. One of.

Operational Amplifiers (Op-Amps)

Operational Amplifier The operational amplifier circuit first came into existence as a basic building block in analog computers. I t was referred to as.

1 1.6 Op-Amp Basics Basic Op-Amp Op-amp equivalent circuit Practical (R i = high, R o = small)Ideal (R i =∞, R o = 0)

Applications of OP-AMP. Introduction Operational amplifier using IC's is inexpensive, versatile and easy to use. For this reason they are used not only.

E E 2315 Lecture 08 - Introduction to Operational Amplifiers.

Instrumentation Amplifiers Passive Transducer Measurement Configuration: For passive transducers in a bridge configuration the voltage of interest is the.

Op-amp used as a summing amplifier or adder It is possible to apply more than one input signal to an inverting amplifier. This circuit will then add all.

1 Operational Amplifiers n Ideal Op-Amp –input terminals –differential gain, open-loop gain.

OP-AMPs Op Amp is short for operational amplifier. An operational amplifier is modeled as a voltage controlled voltage source. An operational amplifier.

Analogue Electronics Higher Physics Unit 2 Electricity And Electronics Introduction to Op-Amps.

1 CHAPTER 20 OPERATIONAL AMPLIFIERS (OP-AMPS). 2 Introduction to operational amplifiers Symbol and Terminals.

OPERATIONAL AMPLIFIERS + - Presented by D.Satishkumar Asst. Professor, Electrical & Electronics Engineering

EE101-Lecture 8 Operational Amplifier Basics of amplifiers EE101 Fall 2012 Lect 8- Kang1 Noninverting amplifier & Inverting amplifier.

1 Operational Amplifiers 1. 2 Outlines Ideal & Non-ideal OP Amplifier Inverting Configuration Non-inverting Configuration Difference Amplifiers Effect.

Differential voltage-gain device that amplifies the difference between the voltages existing at its two input terminal. An instrumentation (or instrumentational)

CHAPTER 20 OPERATIONAL AMPLIFIERS (OP-AMPS). Introduction to operational amplifiers Symbol and Terminals.

Ref:080114HKNOperational Amplifier1 Op-Amp Properties (1)Infinite Open Loop gain -The gain without feedback -Equal to differential gain -Zero common-mode.

Dynamic Presentation of Key Concepts Module 5 – Part 2 Op Amp Circuits with Feedback Filename: DPKC_Mod05_Part02.ppt.

An operational amplifier (Op-Amp) is a differential amplifier that amplifies the difference of voltages applied to its two input terminals (differential.

Module 2 Operational Amplifier Basics

BIOPOTENTIAL AMPLIFIERS

Figure 5.1 The eight-lead DIP package (top view).

Fundamentals of Electric Circuits Chapter 5

Feedback No feedback : Open loop (used in comparators)

Examples of Negative Feedback Applications: A) Inverting Amplifiers

Department of CNET Electronic Circuit II

Electronic Circuit-II

Fundamentals of Electric Circuits Chapter 5

Department of CNET Electronic Circuit II

Electronic Circuit-II

Chapter 5 Operational Amplifiers

Presentation transcript:

Analog Circuit Design AVI SINGH

Amplifier What is an amplifier?

Necessary Conditions There is a “power gain”.

Voltage Amplifier Input and output: both are voltages LHS: Input Terminal RHS: Output Terminal The bottom wire is similar to a ‘common ground’

An equivalent Circuit Note: There is a voltage-dependent current source in the circuit.

How do we build an amplifier? Amplifiers cannot be built simply using resistors, capacitors or inductors alone. You need external power source also ( for the power gain).

Some ‘simple’ amplifier designs It is not possible for everyone to design their own amplifiers without specialised knowledge.

So, how do we proceed? Our dilemma: Amplifiers already might not satisfy all our specific requirements, while it is very difficult to design a good amplifier from scratch. The answer: A Semi-Custom Approach We use some amplifiers that have been already built, and customize them according to our own requirements. An Example of such an amplifier that we can customize according to our needs: An Operational Amplifier

Difference Amplifiers They are insensitive to what is common between two signals, and sensitive to what is different.

An Operational Amplifier(Op-Amp) A special type of difference amplifier Very high common mode rejection ratio.

Data sheet of a 741 op-amp

Equivalent Circuit of an Op-Amp

Feedback

Negative and Positive Feedback

Different Op-Amp Circuits We mostly use op-amp circuits that employ negative feedback.

Op Amp with Negative Feedback

Virtual Ground Property

In op-amp circuits employing negative feedback, the voltage at the positive input terminal is almost equal to the voltage at the negative input terminal, given that the gain of the op-amp is very high. It does not hold under: 1. Open Loop System 2. Positive Feedback 3. If the op-amp is saturated (that is, it is driving the maximum current that it can)

Golden Rules for Analysing Op-Amp Circuits Note: These hold true only and only under negative feedback.

Some simple amplifiers made using Op-Amps

Inverting Amplifiers

Non-Inverting Amplifiers

An Adder

Integrator

Differentiator

Instrumentation Amplifier

Has limited use: not as flexible as the operational amplifier Made up for four op-amps Feedback resistor is internal Mainly used for high-precision gain Only one of the resistors is determined externally that is Rg.

Analysis

Thank You