Team Fuzzy Balls Waqas Abbasi Dusty Ashberry Daniel Grant Chadwick Harris Gene Karshenboym Robert Ricaud

Overview Engineering Analysis Corrected Values Part Drawings Full Assembly Sub-Assembly Container w/ lid Control System (motor, sensors, valves)

Engineering Analysis Deflection of Lid w/ Corner Supports:Deflection of Lid w/ 8 Supports:

Engineering Analysis (Cont’d) Buckles: Total tensile strength must be greater than 600 lb. for N = 2 d= 1/8 in =.125 in F = 600 lbf Therefore, the yield strength of the material must be approx kpsi. Most low alloy steels have yield strengths greater than 50 kpsi.

Part Drawings: Full Assembly

Full Assembly Latch Handle Compressor Pressure Gauge Latch Hook Bleed Valve Pressure Switch Lid Container Pressure Seal Schrader Valve

Part Drawings: Container

Part Drawings: Lid

Part Drawing: Gasket

Part Drawings: Compressor Specifications 120 Volts 3 Amps 1 cfm

Part Drawings: Pressure Release Specifications 3/8” Pipe Size 2 ½” Height 20 psi $8.93

Part Drawings: Pressure Switch Specifications Setpoint Range 6-30 psi Deadband Pressure 2-4 psi Maximum pressure 250 psi $19.80

Part Drawings: Latch Assembly Specifications Zinc Plated Steel 2”-2-1/2” latch distance Length = 3-3/64” Width = 1-7/64” Projection/Thickness 5/8” Hook Assembly

Part Drawings: Schrader Air Valve, Pressure Gauge Specifications: A= 1-5/8” B=C=3/4” Max Pressure= 200 psi Specifications: Pressure Range = 0-60 psi Intervals = 5 psi Dial size = 29/32”

Deliverables Next Week Prototype Review Ongoing Website completely revamped by the MAN