Water Saving Device By Marcus

Plantitron: Genius Inventors Explanation My water saving device works by putting water in a funnel and then a pump sucks the water up from a container through a pipe and sprays down on the plants. It saves water by recycling used water that gets stored in a container where it continually gets pumped onto the plants until there is no water left so it is using grey water to save water and help the environment.

Water Cycle Diagram Nourish Plants Water Plants Pump Water Up Recycle Water Capture Lost Water Garden Grey Water Recycling Garden Grey Water Recycling Plantitron: The next generation saving the world

Research and Development Design

How it works

Materials ItemMaterialQuantityCost Where to get Pump Small 12 Volt pump Pre Made1$118.95Bunnings Hose 25 mm garden hose Plastic1.5 M$1.50Bunnings Sides 100 cm x 20 cm Wood2$10.40Bunnings Bottom 100 cm x 30 cm Wood1$6.20Bunnings End 20 cm x 30 Wood2$3.10Bunnings Sprinklers Small spray Pre made5$1.50Bunnings

Procedural steps Steps: 1. Buy the materials on the slide above. 2. Make the box. 3. Drill hole for pump. 4. Mount the pump. 5. Attach and run the watering hose. 6. Drill hole for water tube. 7. Attach water tube with funnel. 8. Screw in the plant holding frame. 9. Plant plants and plug in the pump. 10. Water plants and enjoy it.